- 您現在的位置：買賣IC網 > PDF目錄361795 > W83C554F W83C554F Highly Integrated System I/O Controller for Power PC TM (South Bridge) & UltraDMA/33 IDE Controller QFP 208 PDF資料下載
參數資料
| 型號： | W83C554F |
| 英文描述： | W83C554F Highly Integrated System I/O Controller for Power PC TM (South Bridge) & UltraDMA/33 IDE Controller QFP 208 |
| 中文描述： | W83C554F高度集成的系統的I / O控制器的Power PC商標（南橋） |
| 文件頁數： | 52/159頁 |
| 文件大?。?/td> | 3991K |
| 代理商： | W83C554F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁當前第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁
W83C553F
3.18 Bus Master Transfers
When operating as a bus master on the PCI bus, DMA cycles will be executed on the IDE interface. In this mode, once the
BMEN bit of the Bus Master Control Register is set the W83C553F will de-assert the chip selects for that port and respond to
DRQ as defined above. If an interrupt is generated on the IDE interface, it will be delayed for IDE device to memory
transfers until the FIFO is empty (written to memory). The IDEIOW[A:B]#/IDEIOR[A:B]# will be held high and not
asserted (pause) any time that the FIFO is empty/full.
To maximize the PCI bus bandwidth, the bus master FIFO is independent of the PIO FIFOs. It is 64 bytes deep which allows
the W83C553F to burst transfers of 8 double words consistently. This allows the use of the Memory Read Line and Memory
Write And Invalidate commands.
If both ports operate in the bus master mode, they will share the same FIFO and a fairness arbitration will be employed to
guarantee both ports have transfer time slices.
Using this protocol to transfer data relieves the System CPU overhead by 90% typically. This is achieved because the CPU
only needs to send the command to the target IDE device, set up the bus master PRD table, and program the bus master
register set. There will only be one interrupt per command to service, whereas PIO commands require one interrupt per
sector or block of sectors, and the CPU must manually transfer all data.
PCI bus utilization is also reduced by up to 90% over the standard PIO protocol. The bus master core can transfer one sector
of data with less than 6 microseconds of active bus time, regardless of the IDE device transfer rate. The same PIO transfer
requires over 150 microseconds of active bus time, when using a Mode 0 IDE device.
3.19 82C59A Interrupt Controller
Two interrupt controllers are included in the W83C553F, and are internally cascaded to handle a total of 15 interrupt
channels. IRQ0 is internally connected to OUT0, of the 82C54 counter/timer. Typically, an interrupt is generated by the
rising edge of an IRQ signal. However, IRQ8 and IRQ13 are fixed to trigger on the falling edge, allowing direct connection
to the real time clock interrupt (IRQ8#), or Pentium CPU floating point error signal (FERR#). Also, RX 4D0h and RX 4D1h
can be programmed to change the IRQs from edge sensitive to level sensitive interrupts. All external IRQ lines are internally
pulled-up to eliminate noises on unconnected request pins. I/O port and channel definition matches that of the IBM PC/AT
requirement.
3.20 82C37A DMA Controller
Two 82C37A DMA controllers are integrated into the W83C553F. Each controller is a four channel DMA device,
generating memory addresses and control signals necessary to transfer information between a peripheral device and memory,
without CPU intervention.
The two controllers are cascaded to provide four DMA channels permitting 8-bit peripheral device data transfers. Three
channels permit 16-bit peripheral device data transfers. The I/O port and channel definition matches that of the IBM PC/AT
requirement.
Type A, B and F DMA are supported in the W83C553F. Both DMA controllers support full 32-bit addressing and
scatter/gather transfer capability.
Electrical Specifications
WINBOND SYSTEMS LABORATORY
49
相關PDF資料 |
PDF描述 |
|---|---|
| W83L519D | Peripheral Miscellaneous |
| W86C451 | UART |
| W86C452 | UART |
| W86F3448D | LC86F3548A |
| W86F3448M | LC86F3548A |
相關代理商/技術參數 |
參數描述 |
|---|---|
| W83C554FY | 制造商:Nuvoton Technology Corp 功能描述:I/O Controller Phase Controller 制造商:Nuvoton Technology 功能描述:I/O Controller Phase Controller |
| W83E14 | 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:SYSMAC-C20 MANUAL DX CODE ZA |
| W83L177R | 制造商:WINBOND 制造商全稱:Winbond 功能描述:100MHZ 2-DIMM SDRAM BUFFER FOR NOTEBOOK |
| W83L197R-16 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:2-CHIP 100MHZ CLOCK FOR BX NOTEBOOK |
| W83L351 | 制造商:WINBOND 制造商全稱:Winbond 功能描述:ExpressCard⑩ Power Interface Switch |
發布緊急采購，3分鐘左右您將得到回復。