參數資料
型號: TSB43AA82A1
廠商: Texas Instruments, Inc.
英文描述: 1394 integrated PHY and link layer controller(1394集成PHY和鏈路層控制器)
中文描述: 1394綜合物理層和鏈路層控制器(1394集成物理層和鏈路層控制器)
文件頁數: 84/146頁
文件大?。?/td> 597K
代理商: TSB43AA82A1
72
7.1.2
Internal Agent Transaction for Write Request From Initiator
When each active agent register receives a write request, the internal agent operates with the behavior described
in Table 71. This table assumes that StErPkt at 08h = 0, ErrResp at 08h = 0 and AckPnd at 08h = 0.
Table 71. Agent Transaction for Initiator Write Request
STATE
REGISTER
RESPONSE TO
INITIATOR
TSB43AA82A ACTIONS
RESET
AGENT_STATE
ack_type_error
No action
AGENT_RESET
ack_complete
No action
ORB_POINTER
ack_complete
1. ORB pointer registers 1 and 2 are updated (54h, 58h).
2. Read request packet is loaded into the CTQ.
DOORBELL
ack_complete
The agent’s DrBll at 5Ch is set to 1.
UNSOLICITED_STATE_ENABLE
ack_complete
The agent’s UnStEn at 5Ch is set to 1.
ACTIVE
AGENT_STATE
ack_type_error
No action
AGENT_RESET
ack_complete
Reset agent state
ORB_POINTER
ack_conflict_error
No action
DOORBELL
ack_complete
The agent’s DrBll at 5Ch is set to 1.
UNSOLICITED_STATE_ENABLE
ack_complete
The agent’s UnStEn at 5Ch is set to 1.
SUSPENDED
AGENT_STATE
ack_type_error
No action
AGENT_RESET
ack_complete
Reset agent state
ORB_POINTER
ack_complete
1. ORB pointer registers 1 and 2 are updated (54h, 58h).
2. Read request packet is loaded into the CTQ.
DOORBELL
ack_complete
1. The agent’s DrBll at 5Ch is set to 1.
2. If DrBFtEn (ORB fetch control at 44h) is set to 1, the
read request packet is loaded into the CTQ again.
UNSOLICITED_STATE_ENABLE
ack_complete
The agent’s UnStEn at 5Ch is set to 1.
DEAD
AGENT_STATE
ack_type_error
No action
AGENT_RESET
ack_complete
Reset agent state
ORB_POINTER
ack_complete
No action
DOORBELL
ack_complete
The agent’s DrBll at 5Ch is set to 1.
UNSOLICITED_STATE_ENABLE
ack_complete
The agent’s UnStEn at 5Ch is set to 1.
Any state
Reserved agent area
ack_Pending
Stored in ARF
A successful write to a command agent register returns an acknowledge that depends on Ackpnd at 08h, bit 18.
Table 72 shows the command agent response to a successful write.
Table 72. Command Agent Response—Successful Write
Ackpnd
ACKNOWLEDGE SENT
0
ack_complete
1
ack_pending
The AGENT_STATE register (see Section 7.1.1) is a read-only register. A write request to this register from the
initiator results in an ack_type_error. The error response of the TSB43AA82A depends on the settings of StErPkt and
ErrResp (08h bits 15 and 14). Table 73 shows command agent error responses.
Table 73. Command Agent Error Response
StErPkt
ErrResp
Ack TO INITIATOR
RESPONSE PACKET TO INITIATOR AND OTHER ACTIONS
0
1
ack_complete
Received packet is stored in the ARF.
1
0
ack_pending
The packet which has resp_type_error or resp_conflict_error is sent to the initiator.
0
0
ack_type_error or
ack_conflict_error
No response packet is sent.
相關PDF資料
PDF描述
TSB81BA3I IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER
TSE-0155-32S-P1-3 SINGLE MODE SINGLE FIBER TRANSCEIVER
TSL230 PROGRAMMABLE LIGHT-TO-FREQUENCY CONVERTERS
TSL235(中文) Programmable Light-To-Frequency Converter(光頻轉換器)
TSL245(中文) IR Light-To-Frequency Converter(紅外光頻轉換器)
相關代理商/技術參數
參數描述
TSB43AA82AI 制造商:TI 制造商全稱:Texas Instruments 功能描述:1394 Integrated PHY and Link-Layer Controller for SBP-2 Products and DPP Products
TSB43AA82AIPGE 功能描述:1394 接口集成電路 Hi Perf Integr Phy & Link Layer Chip RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray
TSB43AA82AIPGEEP 功能描述:1394 接口集成電路 Mil Enh Int PHY and Link-Layer Cntrlr RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray
TSB43AA82APGE 功能描述:1394 接口集成電路 Hi Perf Integr Phy & Link Layer Chip RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray
TSB43AA82APGEG4 功能描述:1394 接口集成電路 Hi Perf Integr Phy & Link Layer Chip RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray