- 您現在的位置：買賣IC網 > PDF目錄385949 > TSB43AA82A1 (Texas Instruments, Inc.) 1394 integrated PHY and link layer controller(1394集成PHY和鏈路層控制器) PDF資料下載
參數資料
| 型號： | TSB43AA82A1 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | 1394 integrated PHY and link layer controller(1394集成PHY和鏈路層控制器) |
| 中文描述： | 1394綜合物理層和鏈路層控制器（1394集成物理層和鏈路層控制器） |
| 文件頁數： | 80/146頁 |
| 文件大?。?/td> | 597K |
| 代理商： | TSB43AA82A1 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁當前第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁
52
ConfigROM Size Set
Auto Response
ConfigROM Size Set
ROM Access Mode
(XLOG = 1)
LOG Access Mode
(XLOG = 0)
ROMValid
Data Write
(FCh)
Figure 52. ConfigROM Setup
Figure 5-2 shows a basic flow diagram for the host to set up the ConfigROM. The following steps provide additional
description for the figure:
1.
Once power is on, the host writes the number of bytes to be written in ConfigROM. The value between the
ConfigROM start address (FFFF F000 0400h) and the AR_ConfigROM_Size is subject for the ConfigROM
AutoResponse. If the content of the ConfigROM does not exceed 504 bytes (the maximum size for
AR_ConfigROM_Size), the host writes the value of AR_ConfigROM_Size to ConfigROM_Size. If the
ConfigROM content is more than 504 bytes, the host writes the total ConfigROM size into ConfigROM_Size.
(Note: ConfigROM_Size does not exceed 1024 Bytes). As stated previously, the host needs to respond to
requests for the ConfigROM larger than AR_ConfigROM_Size but less than the Config_ROM_Size.
2.
Next, the host loads the ConfigROM to TSB43AA82A through the Log/ROM control register (F8h) and Log
ROM data register (FCh). First, the XLOG bit is set to make LogData accessible to ROM and 400h is written
into the ROMAddr, which writes data for ConfigROM address FFFF F000 0400h into ROMAccess.
3.
Repeated writes to the Log ROM data register at FCh increment the address automatically and write the
ConfigROM data in order. To verify the data, the host writes the start address to ROMAddr, then reads
ROMAccess.
4.
Finally, the host clears the XLOG bit on the Log/ROM control register (F8h), and at the same time, sets
ROMValid(F8h) to indicate the ConfigROM is valid. If ROMValid is not set, the device responds with an
ack_tardy to a ConfigROM read request.
5.3
Transaction LOG
The host uses LOG to keep track of automatic transactions. To record the LOG, set the XLOG bit in the Log/ROM
control register (F8h) for a desired transaction to be stored in the LOG FIFO. See Section 3.4.48 for a detailed
description of each Enable bit and recorded log. The LOG may be read from the log data register at FCh. With
ShortLog format, the data section of a packet is omitted, and only the header and trailer are logged. LogAvail shows
the number of quadlets of currently recorded log. Once LOG FIFO is filled with logs, it overwrites older logs. Therefore,
if LogAvail is the same size as LOG FIFO, LOG FIFO is full and only newer logs can be viewed.
相關PDF資料 |
PDF描述 |
|---|---|
| TSB81BA3I | IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER |
| TSE-0155-32S-P1-3 | SINGLE MODE SINGLE FIBER TRANSCEIVER |
| TSL230 | PROGRAMMABLE LIGHT-TO-FREQUENCY CONVERTERS |
| TSL235(中文) | Programmable Light-To-Frequency Converter(光頻轉換器) |
| TSL245(中文) | IR Light-To-Frequency Converter(紅外光頻轉換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSB43AA82AI | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1394 Integrated PHY and Link-Layer Controller for SBP-2 Products and DPP Products |
| TSB43AA82AIPGE | 功能描述:1394 接口集成電路 Hi Perf Integr Phy & Link Layer Chip RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray |
| TSB43AA82AIPGEEP | 功能描述:1394 接口集成電路 Mil Enh Int PHY and Link-Layer Cntrlr RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray |
| TSB43AA82APGE | 功能描述:1394 接口集成電路 Hi Perf Integr Phy & Link Layer Chip RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray |
| TSB43AA82APGEG4 | 功能描述:1394 接口集成電路 Hi Perf Integr Phy & Link Layer Chip RoHS:否 制造商:Texas Instruments 類型:Link Layer Controller 工作電源電壓: 封裝 / 箱體:LQFP 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。