參數資料
型號: IT8673F
廠商: Electronic Theatre Controls, Inc.
英文描述: GT 35C 35#12 SKT PLUG
中文描述: 先進的輸入/輸出(高級I / O)的初步規范V0.5
文件頁數: 102/128頁
文件大小: 780K
代理商: IT8673F
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁當前第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁
IT8673F
2
(12) Configuration Register B (cnfgB) (Secondary Base+1h, Mode 111)
This register is
read only
.
cnfgB(7): A logic “0” read indicates that the chip does not support hardware RLE compression.
cnfgB(6):Returns the value on the ISA IRQ line to warn possible conflicts.
cnfgB(5)-cnfgB(3): A value 000 read indicates that the interrupt must be selected with jumpers.
cnfgB(2)-cnfgB(0): A value 000 read indicates that the DMA channel is a jumpered 8-bit DMA.
(13) Extended Control Register (ECR) (Secondary Base+2h, Mode All)
Table 11-43. Extended Control Register (ECR) Mode and Description
ECR
Mode and Description
000
Standard Parallel Port Mode. The FIFO is reset and the direction bit dcr(5) is always “0” (forward direction) in
this mode.
001
PS/2 Parallel Port Mode. It is similar to the SPP mode except that the dcr(5) is
read/write
. When dcr(5) is “1”,
the PD bus is tri-state. Reading the data port returns the value on the PD bus instead of the value of the data
register.
010
Parallel Port Data FIFO Mode. This mode is similar to the 000 mode, except that the Host writes or DMA
transfers the data bytes to the FIFO. The FIFO data is then automatically sent to the peripheral using the
standard parallel port protocol. This mode is only valid in the forward direction (dcr(5)=0)
011
ECP Parallel Port Mode. In the forward direction, bytes placed into the ecpDFifo and ecpAFifo are stored in a
single FIFO and automatically sent to the peripheral under the ECP protocol. In the reverse direction, bytes
are sent to the ecpDFifo from ECP port.
100, 101 Reserved, not defined.
110
Test mode. In this mode, the FIFO may be read from or written to, but it cannot be sent to the peripheral.
111
Configuration mode. In this mode, the cnfgA and cnfgB registers are accessible at 0x400 and 0x401.
相關PDF資料
PDF描述
IT8687R GT 35C 35#12 SKT PLUG
ITC1000 GT 85C 85#16 SKT PLUG
ITF86130SK8T N-Channel, Logic Level, Power MOSFET(N溝道邏輯電平功率MOS場效應管)
ITF86182SK8T 11A, 30V, 0.0115 Ohm, P-Channel, Logic Level, Power MOSFET
ITF87012SVT 6A, 20V, 0.035 Ohm, N-Channel,2.5V Specified Power MOSFET(6A, 20V, 0.035Ω N溝道2.5V專用功率MOS場效應管)
相關代理商/技術參數
參數描述
IT8687R 制造商:ITE 功能描述:
IT86B 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIAC|600V V(DRM)|8A I(T)RMS|TO-220
IT86C 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIAC|600V V(DRM)|8A I(T)RMS|TO-220
IT86F 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIAC|600V V(DRM)|8A I(T)RMS|TO-220
IT86G 制造商:未知廠家 制造商全稱:未知廠家 功能描述:TRIAC|600V V(DRM)|8A I(T)RMS|TO-220