- 您現在的位置：買賣IC網 > PDF目錄374668 > S5335DK (Applied Micro Circuits Corp.) PCI Bus Controller, 3.3V PDF資料下載
參數資料
| 型號： | S5335DK |
| 廠商： | Applied Micro Circuits Corp. |
| 英文描述： | PCI Bus Controller, 3.3V |
| 中文描述： | PCI總線控制器，3.3 |
| 文件頁數： | 118/189頁 |
| 文件大?。?/td> | 1193K |
| 代理商： | S5335DK |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁當前第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁
S5335 – PCI Bus Controller, 3.3V
Revision 5.01 – November 30, 2005
Data Sheet
AMCC Confidential and Proprietary
DS1657 118
Mailbox Empty/Full Conditions
The PCI and Add-On interfaces each have a mailbox
status register. The PCI Mailbox Empty/Full Status
(MBEF) and Add-On Mailbox Empty/Full Status
(AMBEF) Registers indicate the status of all bytes
within the mailbox registers. A write to an outgoing
mailbox sets the status bits for that mailbox. The byte
enables determine which bytes within the mailbox
become full (and which status bits are set).
An outgoing mailbox for one interface is an incoming
mailbox for the other. Therefore, incoming mailbox sta-
tus bits on one interface are identical to the
corresponding outgoing mailbox status bits on the
other interface. The following list shows the relation-
ship between the mailbox registers on the PCI and
Add-On interfaces.
A write to an outgoing mailbox also writes data into the
incoming mailbox on the other interface. It also sets
the status bits for the outgoing mailbox and the status
bits for the incoming mailbox on the other interface.
Reading the incoming mailbox clears all correspond-
ing status bits in the Add-On and PCI mailbox status
registers (AMBEF and MBEF).
For example, a PCI write is performed to the PCI out-
going mailbox 2, writing bytes 0 and 1 (BE0# and
BE1# asserted). Reading the PCI Mailbox Empty/Full
Status Register (MBEF) indicates that bits 4 and 5 are
set. These bits indicate that outgoing mailbox 2, bytes
0 and 1 are full. Reading the Add-On Mailbox Empty/
Full Status Register (AMBEF) shows that bits 4 and 5
in this register are also set, indicating Add-On incom-
ing mailbox 2, bytes 0 and 1 are full. An Add-On read
of incoming mailbox 2, bytes 0 and 1 clears the status
bits in both the MBEF and AMBEF status registers.
To reset individual flags in the MBEF and AMBEF reg-
isters, the corresponding byte must be read from the
incoming mailbox. The PCI and Add-On mailbox sta-
tus registers, MBEF and AMBEF, are read-only.
Mailbox flags may be globally reset from either the PCI
interface or the Add-On interface. The PCI Bus Master
Control/Status Register (MCSR) and the Add-On Gen-
eral Control/Status Register (AGCSTS) each have a
bit to reset all of the mailbox status flags.
Mailbox Interrupts
The designer has the option to generate interrupts to
the PCI and Add-On interfaces when specific mailbox
events occur. The PCI and Add-On interfaces can
each define two conditions where interrupts may be
generated. An interrupt can be generated when an
incoming mailbox becomes full and/or when an outgo-
ing mailbox becomes empty. A specific byte within a
specific mailbox is selected to generate the interrupt.
The conditions defined to generate interrupts to the
PCI interface do not have to be the same as the condi-
tions defined for the Add-On interface. Interrupts are
cleared through software.
For incoming mailbox interrupts, when the specified
byte becomes full, an interrupt is generated. The inter-
rupt might be used to indicate command or status
information has been provided, and must be read. For
PCI incoming mailbox interrupts, the S5335 asserts
the PCI interrupt, INTA#. For Add-On incoming mail-
box interrupts, the S5335 asserts the Add-On
interrupt, IRQ#.
For outgoing mailbox interrupts, when the specified
byte becomes empty, an interrupt is generated. The
interrupt might be used to indicate that the other inter-
face has received the last information sent and more
may be written. For PCI outgoing mailbox interrupts,
the S5335 asserts the PCI interrupt, INTA#. For Add-
On outgoing mailbox interrupts, the S5335 asserts the
Add-On interrupt, IRQ#.
PCI Interface
Add-On Interface
Outgoing Mailbox1
Outgoing Mailbox 2
Outgoing Mailbox 3
Outgoing Mailbox 4
Incoming Mailbox 1
Incoming Mailbox 2
Incoming Mailbox 3
Incoming Mailbox 4
PCI Mailbox Empty/Full
=
=
=
=
=
=
=
=
=
Incoming Mailbox 1
Incoming Mailbox 2
Incoming Mailbox 3
Incoming Mailbox 4
Outgoing Mailbox 1
Outgoing Mailbox 2
Outgoing Mailbox 3
Outgoing Mailbox 4
Add-On Mailbox Empty/
Full
相關PDF資料 |
PDF描述 |
|---|---|
| S5335QF | PCI Bus Controller, 3.3V |
| S5335QFAAB | PCI Bus Controller, 3.3V |
| S5566B | General Purpose Rectifier(通用整流器) |
| S5566G | General Purpose Rectifier(通用整流器) |
| S5566J | GENERAL PURPOSE RECTIFIER APPLICATIONS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S5335QF | 制造商:AppliedMicro 功能描述: |
| S5335QFAAB | 制造商:AppliedMicro 功能描述:PCI Bus Controller |
| S533-M04-F13A-E | 制造商:UNICORP 功能描述: |
| S-533-M04-F13-F | 制造商:UNICORP 功能描述: |
| S533-M04-F13-F | 制造商:UNICORP 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。