- 您現在的位置：買賣IC網 > PDF目錄16537 > AD9558/PCBZ (Analog Devices Inc)BOARD EVAL FOR AD9558 PDF資料下載
參數資料
| 型號： | AD9558/PCBZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 30/104頁 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL FOR AD9558 |
| 產品變化通告： | AD9558 Minor Metal Mask Change 17/Apr/2012 |
| 設計資源： | AD9558 Eval Brd BOM AD9558 Schematic |
| 標準包裝： | 1 |
| 系列： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁
Data Sheet
AD9558
Rev. B | Page 31 of 104
In the automatic modes, a fully automatic priority-based algorithm
selects which reference is the active reference. When programmed
for an automatic mode, the device chooses the highest priority
valid reference. When both references have the same priority,
REFA gets preference over REFB. However, the reference position
is used only as a tie-breaker and does not initiate a reference switch.
The following list gives an overview of the five operating modes:
Automatic revertive mode. The device selects the highest
priority valid reference and switches to a higher priority
reference if it becomes available, even if the reference in use
is still valid. In this mode, the user reference is ignored.
Automatic non-revertive mode. The device stays with the
currently selected reference as long as it is valid, even if
a higher priority reference becomes available. The user
reference is ignored in this mode.
Manual with automatic fallback mode. The device uses the
user reference for as long as it is valid. If it becomes invalid,
the reference input with the highest priority is chosen in
accordance with the priority-based algorithm.
Manual with holdover mode. The user reference is the
active reference until it becomes invalid. At that point,
the device automatically goes into holdover.
Manual mode without holdover. The user reference is the
active reference, regardless of whether or not it is valid.
The user also has the option to force the device directly into
holdover or free run operation via the user holdover and user
freerun bits. In free run mode, the free run frequency tuning
word register defines the free run output frequency. In holdover
mode, the output frequency depends on the holdover control
settings (see the Holdover section).
Phase Build-Out Reference Switching
The AD9558 supports phase build-out reference switching,
which is the term given to a reference switchover that
completely masks any phase difference between the previous
reference and the new reference. That is, there is virtually no
phase change detectable at the output when a phase build-out
switchover occurs.
DIGITAL PLL (DPLL) CORE
DPLL Overview
DIGITAL
LOOP
FILTER
÷N1
R DIVIDER
(20-BIT)
24-BIT/24-BIT
RESOLUTION
FRAC1/
MOD1
17-BIT
INTEGER
TUNING
WORD
CLAMP
AND
HISTORY
×2
FREE RUN
TW
+
30-
BI
T
NC
O
DP
F
D
SYSTEM
CLOCK
FROM APLL
FROM
REF
INPUT
MUX
TO APLL
097
58-
136
Figure 36. Digital PLL Core
A diagram of the DPLL core of the AD9558 appears in Figure 36.
The phase/frequency detector, feedback path, lock detectors,
phase offset, and phase slew rate limiting that comprise this
second generation DPLL are all digital implementations.
The start of the DPLL signal chain is the reference signal, fR,
which is the frequency of the reference input. A reference
prescaler reduces the frequency of this signal by an integer factor,
R + 1, where R is the 20-bit value stored in the appropriate
profile register and 0 ≤ R ≤ 1,048,575. Therefore, the frequency
at the output of the R-divider (or the input to the time-to-digital
converter (TDC)) is
1
R
f
R
TDC
A TDC samples the output of the R-divider. The TDC/PFD
produces a time series of digital words and delivers them to the
digital loop filter. The digital loop filter offers the following
advantages:
Determination of the filter response by numeric
coefficients rather than by discrete component values
The absence of analog components (R/L/C), which
eliminates tolerance variations due to aging
The absence of thermal noise associated with analog
components
The absence of control node leakage current associated
with analog components (a source of reference feed-
through spurs in the output spectrum of a traditional
analog PLL)
The digital loop filter produces a time series of digital words at
its output and delivers them to the frequency tuning input of a
sigma-delta (Σ-Δ) modulator (SDM). The digital words from
the loop filter steer the DCO frequency toward frequency and
phase lock with the input signal (fTDC).
The DPLL includes a feedback divider that causes the digital
loop to operate at an integer-plus-fractional multiple. The
output of the DPLL is
MOD1
FRAC1
N1
f
TDC
DPLL
OUT
)
1
(
_
where N1 is the 17-bit value stored in the appropriate profile
registers (Register 0x0715 to Register 0x0717 for REFA). FRAC1
and MOD1 are the 24-bit numerators and denominators of the
fractional feedback divider block. The fractional portion of the
feedback divider can be bypassed by setting FRAC1 to 0, but
MOD1 should never be 0.
The DPLL output frequency is usually 175 MHz to 200 MHz for
optimal performance.
相關PDF資料 |
PDF描述 |
|---|---|
| GBM22DSAH | CONN EDGECARD 44POS R/A .156 SLD |
| DK-2632-03 | CABLE FIBER OPTIC DUAL LC-SC 3M |
| GEM30DTAS | CONN EDGECARD 60POS R/A .156 SLD |
| GMM12DRXI | CONN EDGECARD 24POS DIP .156 SLD |
| P1330R-105K | INDUCTOR POWER 1000.0UH SMD |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9559 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual PLL, Quad Input, Multiservice Line Card Adaptive Clock Translator |
| AD9559/PCBZ | 功能描述:時鐘和定時器開發工具 Multi-protocol line card dual clock RoHS:否 制造商:Texas Instruments 產品:Evaluation Modules 類型:Clock Conditioners 工具用于評估:LMK04100B 頻率:122.8 MHz 工作電源電壓:3.3 V |
| AD9559BCPZ | 功能描述:時鐘發生器及支持產品 Multi-protocol line card dual clock RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| AD9559BCPZ-REEL7 | 功能描述:時鐘發生器及支持產品 Multi-protocol line card dual clock RoHS:否 制造商:Silicon Labs 類型:Clock Generators 最大輸入頻率:14.318 MHz 最大輸出頻率:166 MHz 輸出端數量:16 占空比 - 最大:55 % 工作電源電壓:3.3 V 工作電源電流:1 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-56 |
| AD9559PCBZ | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual PLL, Quad Input, Multiservice Line Card Adaptive Clock Translator |
發布緊急采購，3分鐘左右您將得到回復。