- 您現在的位置：買賣IC網 > PDF目錄368307 > PSOC (Cypress Semiconductor Corp.) 8-Bit Programmable System-on-Chip (PSoC⑩) Microcontrollers PDF資料下載
參數資料
| 型號： | PSOC |
| 廠商： | Cypress Semiconductor Corp. |
| 英文描述： | 8-Bit Programmable System-on-Chip (PSoC⑩) Microcontrollers |
| 中文描述： | 8位可編程系統（的PSoC⑩）微控制器片上 |
| 文件頁數： | 114/148頁 |
| 文件大?。?/td> | 1412K |
| 代理商： | PSOC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁當前第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁
Cypress MicroSystems CY8C25122/CY8C26233/CY8C26443/CY8C26643 Family Data Sheet
114
Document #: 38-12010 CY Rev. ** CMS Rev. 3.20
September 5, 2002
The Watchdog Timer period is automatically set to be 3
counts of the Sleep Timer overflows. This represents
between two and three sleep intervals depending on the
count in the Sleep Timer at the previous WDT clear.
When this timer reaches 3, a WDR is generated.
The user can either clear the WDT, or the WDT and the
Sleep Timer. Whenever the user writes to the Reset
WDT Register (RES_WDT), the WDT will be cleared. If
the data that is written is the hex value 38H, the Sleep
Timer will also be cleared at the same time.
This timer chain is also used to time the startup for the
external 32 kHz crystal oscillator. When selecting the
external 32 kHz oscillator, a value of 1 second must be
selected as the sleep interval. When the sleep interrupt
occurs, the 32 kHz oscillator source will switch from
internal to the crystal. The device does not have to be
put into sleep for this event to occur. Note that if too short
of a sleep interval is given, the crystal oscillator will not
be stable prior to switch over and the results will be
unpredictable.
Reset WDT Register (RES_WDT, Address = Bank 0, E3h)
11.4
Sleep States
There are three sleep states that can be used to lower
the overall power consumption on the device. The three
states are CPU Sleep, Analog Sleep, and Full Sleep.
The CPU can only be put to sleep by the firmware. This
is accomplished by setting the Sleep Bit in the Status
and Control Register (CPU_SCR). This stops the CPU
from executing instructions, and the CPU will remain
asleep until an interrupt comes pending, or there is a
reset event (either a Power On Reset, or a Watchdog
Timer Reset). While in the CPU Sleep state, all clocking
signals derived from the Internal Main Oscillator are
inactivated, including the
48M
,
24M
,
24V1
, and
24V2
system clocking signals. The Internal Low Speed Oscilla-
tor will continue to operate during the CPU Sleep state.
The function of any analog or digital PSoC block that is
clocked from these system-clocking signals will stop dur-
ing the CPU Sleep state.
The user can also put all the analog PSoC block circuits
to sleep. This is accomplished by resetting the Analog
Array Power Control bits in the Analog Reference Con-
trol Register (ARF_CR), which overrides the individual
enable bits within each analog PSoC block. Setting the
Analog Array Power Control bits will restore the function
to those analog PSoC blocks that were previously in use.
The user should take into account the required settling
time after an analog PSoC block is enabled before it will
provide the maximum precision.
For greatest power savings, the user should put the
device in the Full Sleep state. This is accomplished by
first transitioning to the Analog Sleep state, and then set-
ting the Sleep Bit in the CPU_SCR Register to the Full
Sleep state. The CPU will be stopped at this point, and
either an interrupt or reset event is required to transition
back to the Analog Sleep state.
The Voltage Reference and Supply Voltage Monitor drop
into (fully functional) power-reduced states. All interrupts
remain active. The Internal Low Speed Oscillator
remains running (it will however drop into a less accu-
rate, low-power state). If enabled, the External Crystal
Oscillator will continue running throughout sleep (the
Internal Low Speed Oscillator is disabled if the External
Crystal Oscillator is selected). Only the occurrence of an
Table 94:
Reset WDT Register
Bit #
POR
7
6
5
4
3
2
1
0
0
0
0
0
0
0
0
0
Read/Write
RW
RW
RW
RW
RW
RW
RW
RW
Bit Name
Data [7]
Data [6]
Data [5]
Data [4]
Data [3]
Data [2]
Data [1]
Data [0]
Bit [7:0]
:
Data [7:0]
Any write to this register will clear Watchdog Timer, a write of 38h will also clear the Sleep Timer
相關PDF資料 |
PDF描述 |
|---|---|
| PSOT03LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PS0T03LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT05LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT08LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT12LC | D-SUB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSOK10001 | 制造商:Value Added 功能描述: |
| PSOODO3A | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO3B | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO6A | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO6B | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
發布緊急采購，3分鐘左右您將得到回復。