- 您現在的位置：買賣IC網 > PDF目錄368307 > PSOC (Cypress Semiconductor Corp.) 8-Bit Programmable System-on-Chip (PSoC⑩) Microcontrollers PDF資料下載
參數資料
| 型號： | PSOC |
| 廠商： | Cypress Semiconductor Corp. |
| 英文描述： | 8-Bit Programmable System-on-Chip (PSoC⑩) Microcontrollers |
| 中文描述： | 8位可編程系統（的PSoC⑩）微控制器片上 |
| 文件頁數： | 115/148頁 |
| 文件大?。?/td> | 1412K |
| 代理商： | PSOC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁當前第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁
Special Features of the CPU
September 5, 2002
Document #: 38-12010 CY Rev. ** CMS Rev. 3.20
115
interrupt will wake the part from sleep. The Stop bit in the
Status and Control Register (CPU_SCR) must be
cleared for a part to resume out of sleep.
Any digital PSoC block that is clocked by a System Clock
other than the
32K
system-clocking signal or external
pins will be stopped, as these clocks do not run in sleep
mode.
The Internal Main Oscillator restarts immediately on exit-
ing either the Full Sleep or CPU Sleep modes. Analog
functions must be re-enabled by firmware. If the External
Crystal Oscillator is used and the internal PLL is
enabled, the PLL will take many cycles to change from
its initial 2.5% accuracy to track that of the External Crys-
tal Oscillator. If the PLL is enabled, there will be a 30
μ
s
(one full
32K
cycle) delay hold-off time for the CPU to let
the VCO and PLL stabilize. If the PLL is not enabled, the
hold-off time is one half of the
32K
cycle. For further
details on PLL, see
7.0
.
The Sleep interrupt allows the microcontroller to wake up
periodically and poll system components while maintain-
ing very low average power consumption. The sleep
interrupt may also be used to provide periodic interrupts
during non-sleep modes.
In System Sleep State, GPIO Pins P2[4] and P2[6]
should be held to a logic low or a false Low Voltage
Detect interrupt may be triggered. The cause is in the
System Sleep State, the internal Bandgap reference
generator is turned off and the reference voltage is main-
tained on a capacitor.
The circumstances are that during sleep, the reference
voltage on the capacitor is refreshed periodically at the
sleep system duty cycle. Between refresh cycles, this
voltage may leak slightly to either the positive supply or
ground. If pins P2[4] or P2[6] are in a high state, the leak-
age to the positive supply is accelerated (especially at
high temperature). Since the reference voltage is com-
pared to the supply to detect a low voltage condition, this
accelerated leakage to the positive supply voltage will
cause that voltage to appear lower than it actually is,
leading to the generation of a false Low Voltage Detect
interrupt.
Figure 31: Three Sleep States
Run
Analog
Sleep
CPU Running
CPU not Running
Full Sleep
CPU Sleep
相關PDF資料 |
PDF描述 |
|---|---|
| PSOT03LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PS0T03LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT05LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT08LC | ULTRA LOW CAPACITANCE TVS ARRAY |
| PSOT12LC | D-SUB |
相關代理商/技術參數 |
參數描述 |
|---|---|
| PSOK10001 | 制造商:Value Added 功能描述: |
| PSOODO3A | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO3B | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO6A | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
| PSOODO6B | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
發布緊急采購，3分鐘左右您將得到回復。