- 您現在的位置：買賣IC網 > PDF目錄365431 > S70WS512N00BFWAB2 (Spansion Inc.) Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory PDF資料下載
參數資料
| 型號： | S70WS512N00BFWAB2 |
| 廠商： | Spansion Inc. |
| 英文描述： | Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| 中文描述： | 同硅晶片堆疊多芯片產品（MCP）的512兆位（32兆× 16位）的CMOS 1.8伏，只有同時讀/寫，突發模式閃存 |
| 文件頁數： | 51/93頁 |
| 文件大?。?/td> | 846K |
| 代理商： | S70WS512N00BFWAB2 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁
52
S70WS512N00 Based MCPs
S70WS512N00_00_A0 March 14, 2005
A d v a n c e I n f o r m a t i o n
9.1
Lock Register
As shipped from the factory, all devices default to the persistent mode when power is applied, and
all sectors are unprotected, unless otherwise chosen through the DYB ordering option. The device
programmer or host system must then choose which sector protection method to use. Program-
ming (setting to
0
) any one of the following two one-time programmable, non-volatile bits locks
the part permanently in that mode:
Lock Register Persistent Protection Mode Lock Bit (DQ1)
Lock Register Password Protection Mode Lock Bit (DQ2)
For programming lock register bits refer to
Table 13.2
.
Notes
1. If the password mode is chosen, the password must be programmed before setting the cor-
responding lock register bit.
2. After the Lock Register Bits Command Set Entry command sequence is written, reads and
writes for Bank 0 are disabled, while reads from other banks are allowed until exiting this
mode.
3. If both lock bits are selected to be programmed (to zeros) at the same time, the operation
aborts.
4. Once the Password Mode Lock Bit is programmed, the Persistent Mode Lock Bit is permanently
disabled, and no changes to the protection scheme are allowed. Similarly, if the Persistent
Mode Lock Bit is programmed, the Password Mode is permanently disabled.
After selecting a sector protection method, each sector can operate in any of the following three
states:
1.
Constantly locked.
The selected sectors are protected and can not be reprogrammed unless
PPB lock bit is cleared via a password, hardware reset, or power cycle.
Dynamically locked.
The selected sectors are protected and can be altered via software
commands.
Unlocked.
The sectors are unprotected and can be erased and/or programmed.
2.
3.
These states are controlled by the bit types described in Sections
9.2
–
9.6
.
9.2
Persistent Protection Bits
The Persistent Protection Bits are unique and nonvolatile for each sector and have the same en-
durances as the Flash memory. Preprogramming and verification prior to erasure are handled by
the device, and therefore do not require system monitoring.
Table 9.1 Lock Register
Device
DQ15-05
DQ4
DQ3
DQ2
DQ1
DQ0
S29WS256N
1
1
1
Password
Protection
Mode Lock Bit
Persistent
Protection
Mode Lock Bit
Customer
Secured Silicon
Sector
Protection Bit
S29WS128N/
S29WS064N
Undefined
DYB Lock Boot Bit
0 = sectors
power up
protected
1 = sectors
power up
unprotected
PPB One-Time
Programmable Bit
0 = All PPB erase
command disabled
1 = All PPB Erase
command enabled
Password
Protection
Mode Lock Bit
Persistent
Protection
Mode Lock Bit
Secured Silicon
Sector
Protection Bit
相關PDF資料 |
PDF描述 |
|---|---|
| S70WS512N00BFWAB3 | Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S71AL016D | Stacked Multi-Chip Product (MCP) Flash Memory and RAM |
| S71AL016D02 | Stacked Multi-Chip Product (MCP) Flash Memory and RAM |
| S71AL016D02-B7 | Stacked Multi-Chip Product (MCP) Flash Memory and RAM |
| S71AL016D02BAWBF0 | Stacked Multi-Chip Product (MCP) Flash Memory and RAM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S70WS512N00BFWAB3 | 制造商:SPANSION 制造商全稱:SPANSION 功能描述:Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory |
| S70Y | 功能描述:整流器 1600V 70A Std. Recovery RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| S70YR | 功能描述:整流器 1600V 70A REV Leads Std. Recovery RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel |
| S-70Z | 制造商:Triad Magnetics 功能描述: |
| S710 | 功能描述:MOUNTING NUT RoHS:是 類別:電位計，可變電阻器 >> 配件 系列:- 標準包裝:50 系列:- 附件類型:支架 適用于相關產品:Bourns 3250 和 3252 系列電位計 配用:3252X-502LF-ND - TRIMMER 5K OHM 0.75W TH3252X-202LF-ND - TRIMMER 2K OHM 0.75W TH3252X-103LF-ND - TRIMMER 10K OHM 0.75W TH3252W-503LF-ND - TRIMMER 50K OHM 0.75W TH3252W-502LF-ND - TRIMMER 5K OHM 0.75W TH3252W-501LF-ND - TRIMMER 500 OHM 0.75W TH3252W-204LF-ND - TRIMMER 200K OHM 0.75W TH3252W-203LF-ND - TRIMMER 20K OHM 0.75W TH3252W-202LF-ND - TRIMMER 2K OHM 0.75W TH3252W-201LF-ND - TRIMMER 200 OHM 0.75W TH更多... 其它名稱:H26S |
發布緊急采購，3分鐘左右您將得到回復。