參數資料
型號： S70WS512N00BFWAB2
廠商： Spansion Inc.
英文描述： Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory
中文描述： 同硅晶片堆疊多芯片產品（MCP）的512兆位（32兆× 16位）的CMOS 1.8伏，只有同時讀/寫，突發模式閃存
文件頁數： 39/93頁
文件大?。?/td> 846K
代理商： S70WS512N00BFWAB2
40
S70WS512N00 Based MCPs
S70WS512N00_00_A0 March 14, 2005
A d v a n c e I n f o r m a t i o n
After the erase operation has been suspended, the bank enters the erase-suspend-read mode.
The system can read data from or program data to any sector not selected for erasure. (The de-
vice
erase suspends
all sectors selected for erasure.) Reading at any address within erase-
suspended sectors produces status information on DQ7-DQ0. The system can use DQ7, or DQ6,
and DQ2 together, to determine if a sector is actively erasing or is erase-suspended. Refer to
Table 8.23
for information on these status bits.
After an erase-suspended program operation is complete, the bank returns to the erase-suspend-
read mode. The system can determine the status of the program operation using the DQ7 or DQ6
status bits, just as in the standard program operation.
In the erase-suspend-read mode, the system can also issue the Autoselect command sequence.
See
Write Buffer Programming
and
Autoselect
for details.
To resume the sector erase operation, the system must write the Erase Resume command. The
bank address of the erase-suspended bank is required when writing this command. Further writes
of the Resume command are ignored. Another Erase Suspend command can be written after the
chip has resumed erasing.
The following is a C source code example of using the erase suspend function. Refer to the
Spansion Low Level Driver User’s Guide
(available on
www.amd.com
and
www.fujitsu.com
)
for general information on Spansion Flash memory software development guidelines.
/* Example: Erase suspend command */
*( (UINT16 *)bank_addr + 0x000 ) = 0x00B0; /* write suspend command */
The following is a C source code example of using the erase resume function. Refer to the
Spansion Low Level Driver User’s Guide
(available on
www.amd.com
and
www.fujitsu.com
)
for general information on Spansion Flash memory software development guidelines.
/* Example: Erase resume command */
*( (UINT16 *)bank_addr + 0x000 ) = 0x0030; /* write resume command */
/* The flash needs adequate time in the resume state */
8.5.6
Program Suspend/ Program Resume Commands
The Program Suspend command allows the system to interrupt an embedded programming op-
eration or a
Write to Buffer
programming operation so that data can read from any non-
suspended sector. When the Program Suspend command is written during a programming pro-
cess, the device halts the programming operation within t
PSL
(program suspend latency) and
updates the status bits. Addresses are
don't-cares
when writing the Program Suspend command.
Software Functions and Sample Code
Table 8.16 Erase Suspend
(LLD Function = lld_ EraseSuspendCmd)
Cycle
Operation
Byte Address
Word Address
Data
1
Write
Bank Address
Bank Address
00B0h
Table 8.17 Erase Resume
(LLD Function = lld_ EraseResumeCmd)
Cycle
Operation
Byte Address
Word Address
Data
1
Write
Bank Address
Bank Address
0030h
相關PDF資料
PDF描述
S70WS512N00BFWAB3 Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory
S71AL016D Stacked Multi-Chip Product (MCP) Flash Memory and RAM
S71AL016D02 Stacked Multi-Chip Product (MCP) Flash Memory and RAM
S71AL016D02-B7 Stacked Multi-Chip Product (MCP) Flash Memory and RAM
S71AL016D02BAWBF0 Stacked Multi-Chip Product (MCP) Flash Memory and RAM
相關代理商/技術參數
參數描述
S70WS512N00BFWAB3 制造商:SPANSION 制造商全稱:SPANSION 功能描述:Same-Die Stacked Multi-Chip Product (MCP) 512 Megabit (32M x 16 bit) CMOS 1.8 Volt-only Simultaneous Read/Write, Burst-mode Flash Memory
S70Y 功能描述:整流器 1600V 70A Std. Recovery RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel
S70YR 功能描述:整流器 1600V 70A REV Leads Std. Recovery RoHS:否 制造商:Vishay Semiconductors 產品:Standard Recovery Rectifiers 配置: 反向電壓:100 V 正向電壓下降: 恢復時間:1.2 us 正向連續電流:2 A 最大浪涌電流:35 A 反向電流 IR:5 uA 安裝風格:SMD/SMT 封裝 / 箱體:DO-221AC 封裝:Reel
S-70Z 制造商:Triad Magnetics 功能描述:
S710 功能描述:MOUNTING NUT RoHS:是 類別:電位計，可變電阻器 >> 配件 系列:- 標準包裝:50 系列:- 附件類型:支架 適用于相關產品:Bourns 3250 和 3252 系列電位計 配用:3252X-502LF-ND - TRIMMER 5K OHM 0.75W TH3252X-202LF-ND - TRIMMER 2K OHM 0.75W TH3252X-103LF-ND - TRIMMER 10K OHM 0.75W TH3252W-503LF-ND - TRIMMER 50K OHM 0.75W TH3252W-502LF-ND - TRIMMER 5K OHM 0.75W TH3252W-501LF-ND - TRIMMER 500 OHM 0.75W TH3252W-204LF-ND - TRIMMER 200K OHM 0.75W TH3252W-203LF-ND - TRIMMER 20K OHM 0.75W TH3252W-202LF-ND - TRIMMER 2K OHM 0.75W TH3252W-201LF-ND - TRIMMER 200 OHM 0.75W TH更多... 其它名稱:H26S
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*