參數資料
型號: DSP1627
英文描述: TVS 400W 6.5V BIDIRECT SMA
中文描述: DSP1627數字信號處理器
文件頁數: 33/154頁
文件大?。?/td> 2365K
代理商: DSP1627
Data Sheet
March 2000
DSP1627 Digital Signal Processor
Lucent Technologies Inc.
33
4 Hardware Architecture
(continued)
Software Stop.
In this case, all internal clocking is disabled. INT0, INT1, or RSTB may be used to reenable the
clocks. If the device uses the crystal oscillator or small-signal clock option, the power management must be done in
correct sequence.
powerc = 0x4000
2*nop
powerc = 0xD000
inc = NOINT0
sopor:powerc = 0xF000
/* SLOWCKI asserted */
/* Wait for it to take effect */
/* XTLOFF asserted if applicable and INT0EN asserted */
/* Disable the INT0 interrupt */
/* NOCK asserted, all clocks stop */
/* Minimum switching power consumed here */
/* Some nops will be needed */
/* INT0 pin clears the NOCK field, clocking resumes */
/* INT0EN cleared and XTLOFF cleared, if applicable*/
/* Wait for the crystal oscillator/small-signal to */
/* stabilize, if applicable*/
/* Clear SLOWCKI field, back to high speed */
/* Wait for it to take effect */
/* Clear the INT0 status bit */
3*nop
cont: powerc = 0x4000
call waitxtl
powerc = 0x0
2*nop
ins = 0x0010
In this case also, the wake-up latency is dominated by the crystal oscillator or small-signal start-up period.
The previous examples do not provide an exhaustive list of options available to the user. Many different clocking
possibilities exist for which the target device may be programmed, depending on:
I
The clock source to the processor.
I
Whether the user chooses to power down the peripheral units.
I
The operational state of the crystal oscillator/small-signal clock input, powered or unpowered.
I
Whether the internal processor clock is disabled through hardware or software.
I
The combination of power management modes the user chooses.
I
Whether or not the PLL is enabled.
An example subroutine for xtlwait follows:
xtlwait:
timer0 = 0x2710
timerc = 0x0010
inc = 0x0000
a0 = ins
a0 = a0 & 0x0100
if eq goto loop1
ins = 0x0100
return
/* Load a count of 10,000 into the timer
/* Start the timer with a PRESCALE of two */
/* Disable the interrupts
/* Poll the ins register
/* Check bit 8 (TIME) of the ins register */
/* Loop if the bit is not set
/* Clear the TIME interrupt bit
/* Return to the main program
*/
*/
*/
loop1:
*/
*/
*/
相關PDF資料
PDF描述
DSP1629 TVS 400W 64V UNIDIRECT SMA
DSP16410C TVS 400W 7.0V UNIDIRECT SMA
DSP16410 16-bit fixed point DSP with Flash
DSP25-16AR Phase-leg Rectifier Diode
DSP25 Phase-leg Rectifier Diode
相關代理商/技術參數
參數描述
DSP1627F32K10IR 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|QFP|100PIN|PLASTIC
DSP1627F32K10IT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|QFP|100PIN|PLASTIC
DSP1627F32K11I 制造商:未知廠家 制造商全稱:未知廠家 功能描述:16-Bit Digital Signal Processor
DSP1627F32K11IR 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|QFP|100PIN|PLASTIC
DSP1627F32K11IT 制造商:未知廠家 制造商全稱:未知廠家 功能描述:DSP|16-BIT|CMOS|QFP|100PIN|PLASTIC