參數資料
型號： 82559
廠商： INTEL CORP
元件分類： 微控制器/微處理器
英文描述： Fast Ethernet Multifunction PCI/CARD bus controller(快速以太網多功能PCI/CARD 總線控制器)
中文描述： 1 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PBGA196
封裝： 15 X 15 MM, BGA-196
文件頁數： 53/124頁
文件大小： 1332K
代理商： 82559
Networking Silicon — 82559
Datasheet
43
5.1.3.5
100BASE-TX Receive Error Detection and Reporting
In 100BASE-TX mode, the PHY unit can detect errors in receive data in a number of ways. Any of
the following conditions is considered an error:
Link integrity fails in the middle of frame reception.
The Start of Stream Delimiter (SSD) “JK” symbol is not fully detected after idle.
An invalid symbol is detected at the 4B/5B decoder.
Idle is detected in the middle of a frame (before “TR” is detected).
When any of the above error conditions occurs, the PHY unit immediately asserts its receive error
indication to the CSMA unit. The receive error indication is held active as long as the receive error
condition persists on the receive pair.
5.1.4
100BASE-TX Collision Detection
100BASE-TX collisions in half duplex mode only are detected similarly to 10BASE-T collision
detection, via simultaneous transmission and reception.
5.1.5
100BASE-TX Link Integrity and Auto-Negotiation Solution
The 82559 Auto-Negotiation function automatically configures the device to the technology,
media, and speed to operate with its link partner. Auto-Negotiation is widely described in IEEE
specification 802.3u, clause 28. The PHY unit supports 10BASE-T half duplex, 10BASE-T full
duplex, 100BASE-TX half duplex, and 100BASE-TX full duplex.
The PHY unit has two Physical Media Attachment (PMA) technologies with its link integrity
function, 10BASE-T and 100BASE-TX.
5.1.5.1
Link Integrity
In 100BASE-TX, the link integrity function is determined by a stable signal status coming from the
TP-PMD block. Signal status is asserted when the PMD detects breaking squelch energy and the
right bit error rate according to the ANSI specification.
5.1.5.2
Auto-Negotiation
The PHY unit fully supports IEEE 802.3u, clause 28. The technology, 10BASE-T or 100BASE-
TX, is determined by the Auto-Negotiation result.
Speed and duplex auto-select are functions of Auto-Negotiation. However, these parameters may
be manually configured via the MII management interface (MDI registers).
5.1.6
Auto 10/100 Mbps Speed Selection
The MAC may either allow the PHY unit to automatically select its operating speed or force the
PHY into 10 Mbps or 100 Mbps mode. The Management Data Interface (MDI) can control the
PHY unit speed mode.
相關PDF資料
PDF描述
8255A-5 PROGRAMMABLE PERIPHEAL INTERFACE
8255A IC LOGIC 3257 4-BIT 1-OF-2 FET MULTIPLEXER/DEMULTIPLEXER -40+85C SSOP-16 - OBSOLETE
8255A Programmable Peripheral Interface iAPX86 Family
8255A-5 12-Bit, 2.7 V to 5.25 V, 1.5 MSPS Low Power ADC; Package: SOIC - Wide; No of Pins: 24; Temperature Range: Industrial
82562G Mbps Platform LAN Connect
相關代理商/技術參數
參數描述
82-5590 制造商:Amphenol RF 功能描述:Connector Twinax Receptacle 0Hz to 500MHz Solder Straight Ca
825590-1 功能描述:手工工具 HANDTOOL FOR TIMER CONT RoHS:否 制造商:Molex 產品:Extraction Tools 類型: 描述/功能:Extraction tool
82-5590-2RFX 功能描述:RF 連接器 FRONT MNT BH RECEPT RoHS:否 制造商:Bomar Interconnect 產品:Connectors 射頻系列:BNC 型式:Jack (Female) 極性: 觸點電鍍:Gold 阻抗: 端接類型:Solder 主體類型:Straight Bulkhead 電纜類型:
82-5590-RFX 功能描述:RF 連接器 BULKHEAD JACK S/CUP FRONT MOUNT RoHS:否 制造商:Bomar Interconnect 產品:Connectors 射頻系列:BNC 型式:Jack (Female) 極性: 觸點電鍍:Gold 阻抗: 端接類型:Solder 主體類型:Straight Bulkhead 電纜類型:
825591 功能描述:手工工具 D.A. HANDTOOL ASSY RoHS:否 制造商:Molex 產品:Extraction Tools 類型: 描述/功能:Extraction tool
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*