參數資料
型號： NS32490D
廠商： National Semiconductor Corporation
英文描述： NIC Network Interface Controller(NIC網絡接口控制器)
中文描述： NIC網絡接口控制器（NIC網絡接口控制器）
文件頁數： 2/56頁
文件大?。?/td> 689K
代理商： NS32490D
2.0 Block Diagram
TL/F/8582–2
FIGURE 1
3.0 Functional Description
(Refer to Figure 1)
RECEIVE DESERIALIZER
The Receive Deserializer is activated when the input signal
Carrier Sense is asserted to allow incoming bits to be shift-
ed into the shift register by the receive clock. The serial
receive data is also routed to the CRC generator/checker.
The Receive Deserializer includes a synch detector which
detects the SFD (Start of Frame Delimiter) to establish
where byte boundaries within the serial bit stream are locat-
ed. After every eight receive clocks, the byte wide data is
transferred to the 16-byte FIFO and the Receive Byte Count
is incremented. The first six bytes after the SFD are
checked for valid comparison by the Address Recognition
Logic. If the Address Recognition Logic does not recognize
the packet, the FIFO is cleared.
CRC GENERATOR/CHECKER
During transmission, the CRC logic generates a local CRC
field for the transmitted bit sequence. The CRC encodes all
fields after the synch byte. The CRC is shifted out MSB first
following the last transmit byte. During reception the CRC
logic generates a CRC field from the incoming packet. This
local CRC is serially compared to the incoming CRC ap-
pended to the end of the packet by the transmitting node. If
the local and received CRC match, a specific pattern will be
generated and decoded to indicate no data errors. Trans-
mission errors result in a different pattern and are detected,
resulting in rejection of a packet.
TRANSMIT SERIALIZER
The Transmit Serializer reads parallel data from the FIFO
and serializes it for transmission. The serializer is clocked by
the transmit clock generated by the Serial Network Interface
(DP8391). The serial data is also shifted into the CRC gen-
erator/checker. At the beginning of each transmission, the
Preamble and Synch Generator append 62 bits of 1,0 pre-
amble and a 1,1 synch pattern. After the last data byte of
the packet has been serialized the 32-bit FCS field is shifted
directly out of the CRC generator. In the event of a collision
the Preamble and Synch generator is used to generate a
32-bit JAM pattern of all 1’s
ADDRESS RECOGNITION LOGIC
The address recognition logic compares the Destination Ad-
dress Field (first 6 bytes of the received packet) to the Phys-
ical address registers stored in the Address Register Array.
If any one of the six bytes does not match the pre-pro-
grammed physical address, the Protocol Control Logic re-
jects the packet. All multicast destination addresses are fil-
tered using a hashing technique. (See register description.)
If the multicast address indexes a bit that has been set in
the filter bit array of the Multicast Address Register Array
the packet is accepted, otherwise it is rejected by the Proto-
col Control Logic. Each destination address is also checked
for all 1’s which is the reserved broadcast address.
FIFO AND FIFO CONTROL LOGIC
The NIC features a 16-byte FIFO. During transmission the
DMA writes data into the FIFO and the Transmit Serializer
reads data from the FIFO and transmits it. During reception
the Receive Deserializer writes data into the FIFO and the
DMA reads data from the FIFO. The FIFO control logic is
used to count the number of bytes in the FIFO so that after
a preset level, the DMA can begin a bus access and write/
read data to/from the FIFO before a FIFO underflow//over-
flow occurs.
2
相關PDF資料
PDF描述
NS32828 1 Megabit High Speed Dynamic RAM Controller/Drivers
NS32829 1 Megabit High Speed Dynamic RAM Controller/Drivers
NS32FX16-15 FILM/M CAPACITANCE=0.001 VOLT=630
NS32FX16-20 Imaging/Signal Processor
NS32FX16-25 Imaging/Signal Processor
相關代理商/技術參數
參數描述
NS32491 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Serial Network Interface
NS32491A 制造商:未知廠家 制造商全稱:未知廠家 功能描述:
NS32492B 制造商:NSC 制造商全稱:National Semiconductor 功能描述:Coaxial Transceiver Interface
NS32532-20 制造商:未知廠家 制造商全稱:未知廠家 功能描述:
NS32532-25 制造商:未知廠家 制造商全稱:未知廠家 功能描述:
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*