參數資料
型號: LPC47B34X
廠商: STANDARD MICROSYSTEMS CORP
元件分類: 外設及接口
英文描述: 128 Pin Enhanced Super I/O with LPC Interface for Consumer Applications
中文描述: MULTIFUNCTION PERIPHERAL, PQFP128
封裝: QFP-128
文件頁數: 15/250頁
文件大?。?/td> 645K
代理商: LPC47B34X
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁
15
Indication of 32kHz Clock
There is a bit to indicate whether or not the 32kHz clock input is connected to the LPC47B34x. This
bit is located at bit 0 of the CLOCKI32 register at 0xF0 in Logical Device A. This register is powered
by VTR and reset on a VTR POR.
Bit[0] (CLK32_PRSN) is defined as follows:
0=32kHz clock is connected to the CLKI32 pin (default)
1=32kHz clock is not connected to the CLKI32 pin (pin is grounded).
Bit 0 controls the source of the 32kHz (nominal) clock for the WDT, ring filter, the LED blink logic, the
“wake on specific key” logic. When the external 32kHz clock is connected (CLK32_PRSN=0), that will
be the source for these functions. When the external 32kHz clock is not connected (CLK32_PRSN=1),
an internal 32kHz clock source will be derived from the 14MHz clock for these functions when VCC is
active.
The internal ring oscillator can be used for the LED blink and the wake on specific key logic, when the
32kHz clock is not available. See the Internal Ring Oscillator section.
The following functions will not work under VTR power (VCC removed) if the external 32kHz clock is
not connected. These functions will work under VCC power.
Ring Filter
WDT
Internal Ring Oscillator
The internal ring oscillator may be used when the 32kHz trickle input clock is not active. This ring
oscillator can be used for the following functions when VCC=0:
LED blink
Wake on Specific Key Feature
When the ring oscillator is used, there is a frequency range on the LED blink rates as follows (the duty
cycle is in parenthesis).
0.25 Hz max, 0.084-0.25Hz (10%)
0.5 Hz max, 0.17-0.5 Hz (25%)
1.0 Hz max, 0.33-1.0 Hz (50%)
2.0 Hz max, 0.67-2.0 Hz (50%)
3.0 Hz max, 1.0 - 3.0 Hz (50%)
4.0 Hz max, 1.33-4.0 Hz (50%)
See the LED register (offset 0x5B) in the “Runtime Registers” section for the bit combinations to select
these blink rates.
The Oscillator Select register contains the bits that are used to determine whether the 32kHz trickle
clock is used or the ring oscillator is used, as follows:
If bits[1:0] are set to ‘10’ then the 32kHz input is always used for the functions described above.
In this case, the internal ring oscillator is not used. This is the default condition. The
CLK32_PRSN bit is set to ‘0’.
If bits[1:0] are set to ‘01’ then the internal ring oscillator is always used for the functions described
above while VCC=0 (S3, S4/S5 sleep states). When VCC is active, the 32kHz clock signal is
相關PDF資料
PDF描述
LPC47B37X 100 Pin Enhanced Super I/O for LPC Bus with SMBus Controller for Commercial Applications
LPC47M14X-NC 128 PIN ENGANCED SUPER I/O CONTROLLER WITH AN LPC INTERFACE AND USB HUB
LPC47M14Y-NC 128 PIN ENGANCED SUPER I/O CONTROLLER WITH AN LPC INTERFACE AND USB HUB
LPC47M14Z-NC 128 PIN ENGANCED SUPER I/O CONTROLLER WITH AN LPC INTERFACE AND USB HUB
LPC47M14C-NC BNC MALE TO RJ11/SCREW TESCA-BL10
相關代理商/技術參數
參數描述
LPC47B351-NC 制造商:Rochester Electronics LLC 功能描述:- Bulk
LPC47B357-NC 制造商:SMSC 功能描述:ELECTRONIC COMPONENT
LPC47B373QFP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:SMSC 功能描述:
LPC47B373QFP WAF 制造商:SMSC 功能描述:
LPC47B377QFP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:SMSC 功能描述: