- 您現在的位置：買賣IC網 > PDF目錄360999 > ISP1761BE (NXP SEMICONDUCTORS) Hi-Speed Universal Serial Bus On-The-Go controller PDF資料下載
參數資料
| 型號： | ISP1761BE |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 總線控制器 |
| 英文描述： | Hi-Speed Universal Serial Bus On-The-Go controller |
| 中文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PQFP128 |
| 封裝： | 14 X 20 MM, 1.40 MM HEIGHT, PLASTIC, MS-026, SOT425-1, LQFP-128 |
| 文件頁數： | 84/158頁 |
| 文件大小： | 724K |
| 代理商： | ISP1761BE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁當前第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁
9397 750 13258
Koninklijke Philips Electronics N.V. 2005. All rights reserved.
Product data sheet
Rev. 01 — 12 January 2005
84 of 158
Philips Semiconductors
ISP1761
Hi-Speed USB OTG controller
9.
OTG Controller
9.1 Introduction
OTG is a supplement to the Hi-Speed USB specification that augments existing USB
peripherals by adding to these peripherals limited host capability to support other targeted
USB peripherals. It is primarily targeted at portable devices because it addresses
concerns related to such devices, such as a small connector and low power. Non-portable
devices—even standard hosts—can also benefit from OTG features.
The ISP1761 OTG controller is designed to perform all the tasks specified in the OTG
supplement. It supports Host Negotiation Protocol (HNP) and Session Request Protocol
(SRP) for dual-role devices. The ISP1761 uses software implementation of HNP and SRP
for maximum flexibility. A set of OTG registers provides the control and status monitoring
capabilities to support software HNP and SRP.
Besides the normal USB transceiver, timers and analog components required by OTG are
also integrated on-chip. The analog components include:
Built-in 3.3 V-to-5 V charge pump
Voltage comparators
Pull-up or pull-down resistors on data lines
Charging or discharging resistors for V
BUS
.
9.2 Dual-role device
When port 1 of the ISP1761 is configured in the OTG mode, it can be used as an OTG
dual-role device. A dual-role device is a USB device that can function either as a host or
as a peripheral.
The default role of the ISP1761 is controlled by the ID pin, which in turn is controlled by
the type of plug connected to the mini-AB receptacle. If ID = LOW (mini-A plug
connected), it becomes an A-device, which is a host by default. If ID = HIGH (mini-B plug
connected), it becomes a B-device, which is a peripheral by default.
Both the A-device and the B-device work on a session base. A session is defined as the
period of time in which devices exchange data. A session starts when V
BUS
is driven and
ends when V
BUS
is turned off. Both the A-device and the B-device may start a session.
During a session, the role of the host can be transferred back and forth between the
A-device and the B-device any number of times by using HNP.
If the A-device wants to start a session, it turns on V
BUS
by enabling the charge pump. The
B-device detects that V
BUS
has risen above the B_SESS_VLD level and assumes the role
of a peripheral asserting its pull-up resistor on the DP line. The A-device detects the
remote pull-up resistor and assumes the role of a host. Then, the A-device can
communicate with the B-device as long as it wishes. When the A-device finishes
communicating with the B-device, the A-device turns-off V
BUS
and both the devices finally
go into the idle state. See
Figure 15
and
Figure 16
.
If the B-device wants to start a session, it must initiate SRP by ‘data line pulsing’ and
‘V
BUS
pulsing’. When the A-device detects any of these SRP events, it turns on its V
BUS
.
(Note: only the A-device is allowed to drive V
BUS
.) The B-device assumes the role of a
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1761ET | Hi-Speed Universal Serial Bus On-The-Go controller |
| ISP2100A | Telecommunication IC |
| ISP2100BN4 | Microprocessor |
| ISP2300 | Controller Miscellaneous - Datasheet Reference |
| ISP2310 | Controller Miscellaneous - Datasheet Reference |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1761BE,518 | 功能描述:USB 接口集成電路 USB HS OTG CONTROLLER RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1761BE,551 | 功能描述:USB 接口集成電路 DO NOT USE ORDER -T OR NO "-" RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1761BE,557 | 功能描述:USB 接口集成電路 USB HS OTG CTRLR RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1761BE518 | 制造商:ST-Ericsson 功能描述:IC CONTROLLER USB OTG 128LQFP |
| ISP1761BEGE | 功能描述:IC USB CTRL HI-SPEED 128LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
發布緊急采購，3分鐘左右您將得到回復。