參數資料
型號： AD9910BSVZ
廠商： Analog Devices Inc
文件頁數： 53/64頁
文件大?。?/td> 0K
描述： IC DDS 1GSPS 14BIT PAR 100TQFP
產品培訓模塊： Direct Digital Synthesis Tutorial Series (1 of 7): Introduction
Direct Digital Synthesizer Tutorial Series (7 of 7): DDS in Action
Direct Digital Synthesis Tutorial Series (3 of 7): Angle to Amplitude Converter
Direct Digital Synthesis Tutorial Series (6 of 7): SINC Envelope Correction
Direct Digital Synthesis Tutorial Series (4 of 7): Digital-to-Analog Converter
Direct Digital Synthesis Tutorial Series (2 of 7): The Accumulator
設計資源： Synchronizing Multiple AD9910 1 GSPS Direct Digital Synthesizers (CN0121)
標準包裝： 1
分辨率（位）： 14 b
主 fclk： 1GHz
調節字寬（位）： 32 b
電源電壓： 1.8V, 3.3V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 100-TQFP 裸露焊盤
供應商設備封裝： 100-TQFP-EP（14x14）
包裝： 托盤
產品目錄頁面： 552 (CN2011-ZH PDF)
Data Sheet
AD9910
Rev. D | Page 57 of 64
Control Function Register 2 (CFR2)—Address 0x01
Four bytes are assigned to this register.
Table 19. Bit Descriptions for CFR2
Bit(s)
Mnemonic
Description
31:25
Open
24
Enable amplitude scale
from single tone profiles
Ineffective if CFR2[19 ] = 1 or CFR1[31] = 1 or CFR1[9] = 1.
0 = the amplitude scaler is bypassed and shut down for power conservation (default).
1 = the amplitude is scaled by the ASF from the active profile.
23
Internal I/O update active
This bit is effective without the need for an I/O update.
0 = serial I/O programming is synchronized with the external assertion of the
I/O_UPDATE pin, which is configured as an input pin (default).
1 = serial I/O programming is synchronized with an internally generated I/O update
signal (the internally generated signal appears at the I/O_UPDATE pin, which is
configured as an output pin).
22
SYNC_CLK enable
0 = the SYNC_CLK pin is disabled; static Logic 0 output.
1 = the SYNC_CLK pin generates a clock signal at f
SYSCLK; used for synchronization of the
serial I/O port (default).
21:20
Digital ramp destination
See Table 11 for details. Default is 00b. See the Digital Ramp Generator (DRG) section for
details.
19
Digital ramp enable
0 = disables digital ramp generator functionality (default).
1 = enables digital ramp generator functionality.
18
Digital ramp no-dwell high
See the Digital Ramp Generator (DRG) section for details.
0 = disables no-dwell high functionality (default).
1 = enables no-dwell high functionality.
17
Digital ramp no-dwell low
See the Digital Ramp Generator (DRG) section for details.
0 = disables no-dwell low functionality (default).
1 = enables no-dwell low functionality.
16
Read effective FTW
0 = a serial I/O port read operation of the FTW register reports the contents of the FTW
register (default).
1 = a serial I/O port read operation of the FTW register reports the actual 32-bit word
appearing at the input to the DDS phase accumulator.
15:14
I/O update rate control
Ineffective unless CFR2[23] = 1. Sets the prescale ratio of the divider that clocks the auto I/O
update timer as follows:
00 = divide-by-1 (default).
01 = divide-by-2.
10 = divide-by-4.
11 = divide-by-8.
13:12
Open
11
PDCLK enable
0 = the PDCLK pin is disabled and forced to a static Logic 0 state; the internal clock signal
continues to operate and provide timing to the data assembler.
1 = the internal PDCLK signal appears at the PDCLK pin (default).
10
PDCLK invert
0 = normal PDCLK polarity; Q-data associated with Logic 1, I-data with Logic 0 (default).
1 = inverted PDCLK polarity.
9
TxEnable invert
0 = no inversion.
1 = inversion.
8
Open
7
Matched latency enable
0 = simultaneous application of amplitude, phase, and frequency changes to the DDS
arrive at the output in the order listed (default).
1 = simultaneous application of amplitude, phase, and frequency changes to the DDS
arrive at the output simultaneously.
相關PDF資料
PDF描述
MCF51EM128CLL IC MCU 32BIT 128KB FLASH 100LQFP
AD9957BSVZ IC DDS 1GSPS 14BIT IQ 100TQFP
AD9956YCPZ IC SYNTHESIZER 1.8V 48LFCSP
S9S08DZ60F1MLH MCU 60K FLASH MASK AUTO 64-LQFP
AD9952YSVZ IC DDS 14BIT DAC 1.8V 48-TQFP
相關代理商/技術參數
參數描述
AD9910BSVZ 制造商:Analog Devices 功能描述:IC DDS 1GHZ TQFP-100 制造商:Analog Devices 功能描述:IC, DDS, 1GHZ, TQFP-100
AD9910BSVZ-REEL 功能描述:IC DDS 1GSPS 14BIT PAR 100TQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 直接數字合成 (DDS) 系列:- 產品變化通告:Product Discontinuance 27/Oct/2011 標準包裝:2,500 系列:- 分辨率（位）:10 b 主 fclk:25MHz 調節字寬（位）:32 b 電源電壓:2.97 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR)
AD9911 制造商:AD 制造商全稱:Analog Devices 功能描述:500 MSPS Direct Digital Synthesizer with 10-Bit DAC
AD9911/PCB 制造商:Analog Devices 功能描述:500 MSPS DIRECT DGTL SYNTHESIZER W/ 10-BIT DAC AD9911/PCB - Bulk
AD9911/PCBZ 功能描述:BOARD EVAL FOR AD9911 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:AgileRF™ 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*