- 您現在的位置：買賣IC網 > PDF目錄10979 > AD9910BSVZ (Analog Devices Inc)IC DDS 1GSPS 14BIT PAR 100TQFP PDF資料下載
參數資料
| 型號： | AD9910BSVZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 42/64頁 |
| 文件大小： | 0K |
| 描述： | IC DDS 1GSPS 14BIT PAR 100TQFP |
| 產品培訓模塊： | Direct Digital Synthesis Tutorial Series (1 of 7): Introduction Direct Digital Synthesizer Tutorial Series (7 of 7): DDS in Action Direct Digital Synthesis Tutorial Series (3 of 7): Angle to Amplitude Converter Direct Digital Synthesis Tutorial Series (6 of 7): SINC Envelope Correction Direct Digital Synthesis Tutorial Series (4 of 7): Digital-to-Analog Converter Direct Digital Synthesis Tutorial Series (2 of 7): The Accumulator |
| 設計資源： | Synchronizing Multiple AD9910 1 GSPS Direct Digital Synthesizers (CN0121) |
| 標準包裝： | 1 |
| 分辨率（位）： | 14 b |
| 主 fclk： | 1GHz |
| 調節字寬（位）： | 32 b |
| 電源電壓： | 1.8V, 3.3V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 100-TQFP 裸露焊盤 |
| 供應商設備封裝： | 100-TQFP-EP（14x14） |
| 包裝： | 托盤 |
| 產品目錄頁面： | 552 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁
Data Sheet
AD9910
Rev. D | Page 47 of 64
POWER SUPPLY PARTITIONING
The AD9910 features multiple power supplies, and their power
consumption varies with its configuration. This section covers
which power supplies can be grouped together and how the
power consumption of each block varies with frequency.
The values quoted in this section are for comparison only. Refer
to Table 1 for exact values. With each group, use 0.1 μF or 0.01 μF
bypass capacitors in parallel with a 10 μF capacitor.
The recommendations here are for typical applications, for
which there are four groups of power supplies: 3.3 V digital,
3.3 V analog, 1.8 V digital, and 1.8 V analog.
Applications demanding the highest performance may require
additional power supply isolation.
3.3 V SUPPLIES
DVDD_I/O (3.3 V) (Pin 11, Pin 15, Pin 21, Pin 28, Pin 45,
Pin 56, and Pin 66)
These 3.3 V supplies can be grouped together. The power
consumption on these pins varies dynamically with serial port
activity.
AVDD (3.3 V) (Pin 74 to Pin 77 and Pin 83)
These are 3.3 V DAC power supplies that typically consume
about 28 mA. At a minimum, a ferrite bead should be used to
isolate these from other 3.3 V supplies, with a separate regulator
being ideal. The current consumption of these supplies consist
mainly of biasing current and do not vary with frequency.
1.8 V SUPPLIES
DVDD (1.8 V) (Pin 17, Pin 23, Pin 30, Pin 47, Pin 57, and
Pin 64)
These pins can be grouped together. Their current consumption
increases linearly with the system clock frequency. See Figure 17
and Figure 18 for typical current consumption curves. There is
also a slight (~5%) increase as fOUT increases from 50 MHz to
400 MHz.
AVDD (1.8 V) (Pin 3)
This 1.8 V supply powers the REFCLK multiplier (PLL) and
consumes about 7 mA. For applications demanding the highest
performance with the PLL enabled, this supply should be
isolated from other 1.8 V AVDD supplies with a separate
regulator. For less demanding applications, this supply can be
run off the same regulator as Pin 89 and Pin 92 with a ferrite
bead to isolate Pin 3 from Pin 89 and Pin 92.
The loop filter for the PLL should directly connect to Pin 3. If
the PLL is bypassed, Pin 3 should still be powered, but isolation
is not critical.
AVDD (1.8 V) (Pin 6)
This pin can be grouped together with the DVDD 1.8 V supply
pins. For the highest performance, a ferrite bead should be used
for isolation, with a separate regulator being ideal.
AVDD (1.8 V) (Pin 89 and Pin 92)
This 1.8 V supply for the REFCLK input consumes about
15 mA. These pins can run off the supply of Pin 3 with a ferrite
bead to isolate Pin 3 from Pin 89 and Pin 92. At a minimum, a
ferrite bead should be used to isolate these from other 1.8 V
supplies. However, for applications demanding the highest
performance, a separate regulator is recommended.
相關PDF資料 |
PDF描述 |
|---|---|
| MCF51EM128CLL | IC MCU 32BIT 128KB FLASH 100LQFP |
| AD9957BSVZ | IC DDS 1GSPS 14BIT IQ 100TQFP |
| AD9956YCPZ | IC SYNTHESIZER 1.8V 48LFCSP |
| S9S08DZ60F1MLH | MCU 60K FLASH MASK AUTO 64-LQFP |
| AD9952YSVZ | IC DDS 14BIT DAC 1.8V 48-TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9910BSVZ | 制造商:Analog Devices 功能描述:IC DDS 1GHZ TQFP-100 制造商:Analog Devices 功能描述:IC, DDS, 1GHZ, TQFP-100 |
| AD9910BSVZ-REEL | 功能描述:IC DDS 1GSPS 14BIT PAR 100TQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 直接數字合成 (DDS) 系列:- 產品變化通告:Product Discontinuance 27/Oct/2011 標準包裝:2,500 系列:- 分辨率（位）:10 b 主 fclk:25MHz 調節字寬（位）:32 b 電源電壓:2.97 V ~ 5.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
| AD9911 | 制造商:AD 制造商全稱:Analog Devices 功能描述:500 MSPS Direct Digital Synthesizer with 10-Bit DAC |
| AD9911/PCB | 制造商:Analog Devices 功能描述:500 MSPS DIRECT DGTL SYNTHESIZER W/ 10-BIT DAC AD9911/PCB - Bulk |
| AD9911/PCBZ | 功能描述:BOARD EVAL FOR AD9911 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:AgileRF™ 標準包裝:1 系列:PCI Express® (PCIe) 主要目的:接口，收發器，PCI Express 嵌入式:- 已用 IC / 零件:DS80PCI800 主要屬性:- 次要屬性:- 已供物品:板 |
發布緊急采購，3分鐘左右您將得到回復。