參數資料
型號: MC916X1CTH16B1
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: 16-BIT, FLASH, 16.78 MHz, MICROCONTROLLER, PQFP120
封裝: QFP-120
文件頁數: 90/172頁
文件大小: 1200K
代理商: MC916X1CTH16B1
MOTOROLA
MC68HC916X1
24
MC68HC916X1TS/D
W — Frequency Control Bit
This bit controls a prescaler tap in the synthesizer feedback loop. Setting the bit increases the VCO
speed by a factor of four. VCO relock delay is required.
X — Frequency Control Bit
This bit controls a divide by two prescaler that is not in the synthesizer feedback loop. Setting it doubles
clock speed without changing VCO speed. There is no VCO relock delay.
Y[5:0] — Frequency Control
The Y field controls the modulus down counter in the synthesizer feedback loop, which effectively allows
frequency multiplication by a value of Y + 1. VCO relock delay is required.
EDIV — ECLK Divide Rate
0 = ECLK frequency is system clock divided by 8
1 = ECLK frequency is system clock divided by 16
ECLK is an external M6800 bus clock available on pin ADDR23. Refer to 3.9 Chip Selects for more
information.
SLOCK — Synthesizer Lock Flag
0 = VCO is enabled, but has not locked
1 = VCO has locked on the desired frequency (or system clock is external)
The MCU remains in reset until the synthesizer locks, but SLOCK does not indicate synthesizer lock
status until after the user writes to SYNCR.
STSCIM — Stop Mode SCIM Clock
0 = When LPSTOP is executed, the SCIM clock is driven from the crystal oscillator and the VCO is
turned off to conserve power.
1 = When LPSTOP is executed, the SCIM clock is driven from the VCO.
STEXT — Stop Mode External Clock
0 = When LPSTOP is executed, the CLKOUT signal is held negated to conserve power.
1 = When LPSTOP is executed, the CLKOUT signal is driven from the SCIM clock, as determined
by the state of the STSCIM bit.
3.3.4 Periodic Interrupt Timer
The periodic interrupt timer (PIT) generates interrupts of specified priorities at specified intervals.
Timing for the PIT is provided by a programmable prescaler driven by the system clock.
This register contains information concerning periodic interrupt priority and vectoring. Bits [10:0]
can be read or written at any time. Bits [15:11] are unimplemented and always return zero.
PIRQL[2:0] — Periodic Interrupt Request Level
Table 14 shows what interrupt request level is asserted when a periodic interrupt is generated. If a PIT
interrupt and an external interrupt request of the same priority occur simultaneously, the PIT interrupt
is serviced first. The periodic timer continues to run when the interrupt is disabled.
PICR — Periodic Interrupt Control Register
$YFFA22
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
PIRQL[2:0]
PIV[7:0]
RESET:
0
1
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料
PDF描述
SPMC916X1CTH16 16-BIT, FLASH, 16.78 MHz, MICROCONTROLLER, PQFP120
MC68HCL05J1ADWR2 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO20
MC68HC05J1AVDWR2 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDSO20
MC68HCP11A1CFNE3 8-BIT, EEPROM, 3 MHz, MICROCONTROLLER, PQCC52
MC68HLC705KJ1C 8-BIT, OTPROM, 4 MHz, MICROCONTROLLER, PDIP16
相關代理商/技術參數
參數描述
MC92052 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:FTTC User Framer
MC92053 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad FTTC Network Framer
MC92101CO 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC921G 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC92300 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:VITERBI Decoder for Digital TV