- 您現在的位置：買賣IC網 > PDF目錄69028 > MC68HC05G1B (MOTOROLA INC) 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP56 PDF資料下載
參數資料
| 型號： | MC68HC05G1B |
| 廠商： | MOTOROLA INC |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MROM, 2.1 MHz, MICROCONTROLLER, PDIP56 |
| 封裝： | SDIP-56 |
| 文件頁數： | 54/124頁 |
| 文件大?。?/td> | 732K |
| 代理商： | MC68HC05G1B |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁當前第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
MC68HC05G1
MOTOROLA
5-1
INTERRUPTS
5
INTERRUPTS
5.1
Introduction
The MC68HC05G1 is capable of handling eight types of interrupt, seven hardware and one
software. The interrupt mask bit (“I” bit in the Condition Code Register), if set, blocks all interrupts
except the software interrupt, SWI. Interrupts such as Timer, RTC, and SPI have several ags
which will cause the interrupt. Interrupt ags are found in “read only” status registers, while their
enables are in associated control registers. They are never mixed in the same register. If the
enable bit is “0”, it blocks the interrupt from occurring but does not inhibit the ag from being set.
A reset clears all enable bits. The general sequence for clearing an interrupt is a software
sequence of reading the status register while the ag is set followed by a read or write of an
associated register (except RTC, IRQ, INT1 and INT2). When any of these interrupts occur, and
if enabled, normal processing is suspended at the end of the current instruction execution. The
state of the machine is pushed onto the stack (see Figure 5-1 for stacking order) and the
appropriate vector points to the starting address of the interrupt service routine (see Table 5-1).
Also, the interrupt mask bit in the Condition Code register is set. This masks further interrupts. At
the completion of the service routine, the software normally contains an RTI instruction which,
when executed, restores the machine state and continues executing the interrupted program.
Figure 5-2 and Figure 5-3 shows the program ow for hardware interrupts.
Note:
The interrupt mask bit (I bit) will be cleared if and only if the corresponding bit stored
on the stack is zero.
TPG
33
相關PDF資料 |
PDF描述 |
|---|---|
| MC68HC705JB2DW | 8-BIT, OTPROM, 3 MHz, MICROCONTROLLER, PDSO20 |
| MC68HC705JB2P | 8-BIT, OTPROM, 3 MHz, MICROCONTROLLER, PDIP20 |
| MC68HC705JB4P | 8-BIT, OTPROM, 3 MHz, MICROCONTROLLER, PDIP28 |
| MC68HC705K1CDW | 8-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PDSO16 |
| MC68HC705K1CP | 8-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PDIP16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MC68HC05J1 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:HCMOS MICROCONTROLLER UNIT |
| MC68HC05J1A | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers |
| MC68HC05J1ACDW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers |
| MC68HC05J1ACP | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers |
| MC68HC05J1ADW | 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Microcontrollers |
發布緊急采購，3分鐘左右您將得到回復。