- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C970 (Advanced Micro Devices, Inc.) PCnetTM-PCI Single-Chip Ethernet Controller for PCI Local Bus PDF資料下載
參數資料
| 型號： | AM79C970 |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnetTM-PCI Single-Chip Ethernet Controller for PCI Local Bus |
| 中文描述： | PCnetTM - PCI單芯片以太網控制器的PCI總線 |
| 文件頁數： | 46/168頁 |
| 文件大小： | 943K |
| 代理商： | AM79C970 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁當前第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁
P R E L I M I N A R Y
AMD
1-913
Am79C970
Buffer Management Unit (BMU)
The buffer management unit is a micro-coded state ma-
chine which implements the initialization procedure and
manages the descriptors and buffers. The buffer man-
agement unit operates at half the speed of the
CLKinput.
Initialization
PCnet-PCI initialization includes the reading of the in-
itialization block in memory to obtain the operating pa-
rameters. The initialization block is read when the INIT
bit in CSR0 is set. The INIT bit should be set before or
concurrent with the STRT bit to insure correct operation.
Two DWORDs are read during each period of bus ma-
stership. When SSIZE32 = 1 (BCR20, bit 8), this results
in a total of 4 arbitration cycles (3 arbitration cycles if
SSIZE32 = 0). Once the initialization block has been
completely read in and internal registers have been up-
dated, IDON will be set in CSR0, and an interrupt gener-
ated (if IENA is set). At this point, the BMU knows where
the receive and transmit descriptor rings and hence,
normal network operations will begin.
The PCnet-PCI controller obtains the start address of
the Initialization Block from the contents of CSR1 (least
significant 16 bits of address) and CSR2 (most signifi-
cant 16 bits of address). The host must write CSR1 and
CSR2 before setting the INIT bit. The block contains the
user defined conditions for PCnet-PCI operation, to-
gether with the base addresses and length information
of the transmit and receive descriptor rings.
There is an alternative method to initialize the PCnet-
PCI controller. Instead of initialization via the initializa-
tion block in memory, data can be written directly into the
appropriate registers. Either method may be used at the
discretion of the programmer. If the registers are written
to directly, the INIT bit must not be set, or the initializa-
tion block will be read in, thus overwriting the previously
written information. Please refer to Appendix C for de-
tails on this alternative method.
If initialization is done by writing directly to registers, the
Polling Interval register (CSR47) must be initialized in
addition to those registers that can be loaded automati-
cally from the initialization block.
Re-Initialization
The transmitter and receiver sections of the PCnet-PCI
controller can be turned on via the initialization block
(MODE Register DTX, DRX bits; CSR15[1:0]). The
states of the transmitter and receiver are monitored by
the host through CSR0 (RXON, TXON bits). The PCnet-
PCI controller should be reinitialized if the transmitter
and/or the receiver were not turned on during the origi-
nal initialization, and it was subsequently required to ac-
tivate them or if either section was shut off due to the
detection of an error condition (MERR, UFLO, TX
BUFFerror).
Reinitialization may be done via the initialization block or
by setting the STOP bit in CSR0, followed by writing to
CSR15, and then setting the START bit in CSR0. Note
that this form of restart will not perform the same in the
PCnet-PCI controller as in the LANCE. In particular,
upon restart, the PCnet-PCI controller reloads the trans-
mit and receive descriptor pointers with their respective
base addresses. This means that the software must
clear the descriptor own bits and reset its descriptor ring
pointers before the restart of the PCnet-PCI controller.
The reload of descriptor base addresses is performed in
the LANCE only after initialization, so a restart of the
LANCE without initialization leaves the LANCE pointing
at the same descriptor locations as before the restart.
Buffer Management
Buffer management is accomplished through message
descriptor entries organized as ring structures in mem-
ory. There are two rings, a receive ring and a transmit
ring. The size of a message descriptor entry is 4
DWORDs, or 16 bytes, when SSIZE32 = 1. The size of a
message descriptor entry is 4 words, or 8 bytes, when
SSIZE32 = 0.
Descriptor Rings
Each descriptor ring must be organized in a contiguous
area of memory. At initialization time (setting the INIT bit
in CSR0), the PCnet-PCI controller reads the user-de-
fined base address for the transmit and receive descrip-
tor rings, as well as the number of entries contained in
the descriptor rings. Descriptor ring base addresses
must be on a 16-byte boundary when SSIZE32=1, and
8-byte boundary when SSIZE=0. A maximum of 128 (or
512, depending upon the value of SSIZE32) ring entries
is allowed when the ring length is set through the TLEN
and RLEN fields of the initialization block. However, the
ring lengths can be set beyond this range (up to 65535)
by writing the transmit and receive ring length registers
(CSR76, CSR78) directly.
Each ring entry contains the following information:
1. The address of the actual message data buffer in
user or host memory
2. The length of the message buffer
3. Status information indicating the condition of the
buffer
To permit the queuing and de-queuing of message buff-
ers, ownership of each buffer is allocated to either the
PCnet-PCI controller or the host. The OWN bit within the
descriptor status information, either TMD or RMD (see
section on TMD or RMD), is used for this purpose.
OWN= “1” signifies that the PCnet-PCI controller cur-
rently has ownership of this ring descriptor and its asso-
ciated buffer. Only the owner is permitted to relinquish
ownership or to write to any field in the descriptor entry.
A device that is not the current owner of a descriptor en-
try cannot assume ownership or change any field in the
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C971VCW | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C971 | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C971KCW | IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE |
| AM79C972BKCW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BKIW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C970A | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970AKC | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970AKC\\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Advanced Micro Devices 功能描述: |
| AM79C970AKC\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
發布緊急采購，3分鐘左右您將得到回復。