參數資料
型號: 16F872
廠商: Microchip Technology Inc.
英文描述: CAT 5E CROSSOVER PATCH CORD CABLE GREEN 10 FT
中文描述: 28引腳,8位閃存微控制器的CMOS
文件頁數: 38/160頁
文件大?。?/td> 2600K
代理商: 16F872
PIC16F872
DS30221A-page 38
Preliminary
1999 Microchip Technology Inc.
5.2
Using Timer0 with an External Clock
When no prescaler is used, the external clock input is
the same as the prescaler output. The synchronization
of T0CKI with the internal phase clocks is accom-
plished by sampling the prescaler output on the Q2 and
Q4 cycles of the internal phase clocks. Therefore, it is
necessary for T0CKI to be high for at least 2T
OSC
(and
a small RC delay of 20 ns) and low for at least 2T
OSC
(and a small RC delay of 20 ns). Refer to the electrical
specification of the desired device.
5.3
Prescaler
There is only one prescaler available, which is mutually
exclusively shared between the Timer0 module and the
watchdog timer. A prescaler assignment for the Timer0
module means that there is no prescaler for the watch-
dog timer, and vice-versa. This prescaler is not readable
or writable (see Figure 5-1).
The PSA and PS<2:0> bits (OPTION_REG<3:0>) deter-
mine the prescaler assignment and prescale ratio.
When assigned to the Timer0 module, all instructions
writing to the TMR0 register (i.e.,
CLRF
1,
MOVWF
1,
BSF
1,x
...., etc.) will clear the prescaler. When
assigned to WDT, a
CLRWDT
instruction will clear the
prescaler along with the Watchdog Timer. The pres-
caler is not readable or writable.
REGISTER 5-1:
OPTION_REG REGISTER
Note:
Note:
Writing to TMR0, when the prescaler is
assigned to Timer0, will clear the prescaler
count, but will not change the prescaler
assignment.
R/W-1
RBPU
bit 7
R/W-1
INTEDG
R/W-1
T0CS
R/W-1
T0SE
R/W-1
PSA
R/W-1
PS2
R/W-1
PS1
R/W-1
PS0
R = Readable bit
W = Writable bit
U = Unimplemented bit,
read as ‘0’
- n = Value at POR reset
bit 0
bit 7:
bit 6:
bit 5:
RBPU
INTEDG
T0CS
: TMR0 Clock Source Select bit
1
= Transition on T0CKI pin
0
= Internal instruction cycle clock (CLKOUT)
T0SE
: TMR0 Source Edge Select bit
1
= Increment on high-to-low transition on T0CKI pin
0
= Increment on low-to-high transition on T0CKI pin
PSA
: Prescaler Assignment bit
1
= Prescaler is assigned to the WDT
0
= Prescaler is assigned to the Timer0 module
PS<2:0>
: Prescaler Rate Select bits
bit 4:
bit 3:
bit 2-0:
000
001
010
011
100
101
110
111
1 : 2
1 : 4
1 : 8
1 : 16
1 : 32
1 : 64
1 : 128
1 : 256
1 : 1
1 : 2
1 : 4
1 : 8
1 : 16
1 : 32
1 : 64
1 : 128
Bit Value
TMR0 Rate
WDT Rate
To avoid an unintended device RESET, the instruction sequence shown in the PICmicro Mid-Range MCU
Family Reference Manual (DS33023) must be executed when changing the prescaler assignment from
Timer0 to the WDT. This sequence must be followed even if the WDT is disabled.
相關PDF資料
PDF描述
16F876A 28/40-pin Enhanced FLASH Microcontrollers
16F876 CAT 5E CROSSOVER, GREEN 15 FT PATCH CABLE
16F877 CAT 5E CROSSOVER PATCH CORD CABLE GREEN 20 FT
16FL100S02 6A, 12A AND 16A FAST RECOVERY RECTIFIERS
16FL100S05 6A, 12A AND 16A FAST RECOVERY RECTIFIERS
相關代理商/技術參數
參數描述
16F876 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:28/40-pin 8-Bit CMOS FLASH Microcontrollers
16F876A 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:28/40-pin Enhanced FLASH Microcontrollers
16F877 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:28/40-pin 8-Bit CMOS FLASH Microcontrollers
16F9040 制造商:未知廠家 制造商全稱:未知廠家 功能描述:COMPACT DIGITALMULTIMETER TRUE RMS
16F9041 制造商:未知廠家 制造商全稱:未知廠家 功能描述:COMPACT DMM MIT RS232