參數資料
型號: P95020NQG
廠商: INTEGRATED DEVICE TECHNOLOGY INC
元件分類: 電源管理
英文描述: 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132
封裝: 10 X 10 MM, 0.85 MM HEIGHT, QFN-132
文件頁數: 91/169頁
文件大小: 4297K
代理商: P95020NQG
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁當前第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁
IDTP95020
Product Datasheet
September 2, 2011 Revision 1.3 Final
28
2011 Integrated Device Technology, Inc.
Audio – Reference Voltage Generator,
Buffer, and Filtering Caps
AVREF
The AVREF pin is part of the internal virtual ground
reference generator. A capacitor placed between AVREF
and AGND is necessary for acceptable power supply
rejection and anti-pop performance. A capacitor of 10
μF
is recommended to provide about a 10 second ramp-up
time.
ADCREF
The ADC reference also requires a capacitor of at least 1
F for proper operation.
AFILT
ADC1 augments its internal filter capacitors with external
filter capacitors to reduce noise outside of the audio band
before sampling. 1000 pF capacitors connected from the
AFILT1 and AFILT2 pins to AGND are recommended but
larger capacitors may be used if reduced signal bandwidth
is acceptable. Process variation will cause bandwidth to
vary from part to part. A 1000 pF capacitor will place the
filter pole far outside of the 20 kHz bandwidth supported
so that the ±1 dB 20 kHz bandwidth limit is guaranteed.
Audio – Analog and Class D Output
Block
The Audio subsection provides support for line level,
headphone and speaker outputs.
The analog line output port features a source MUX and
single ended output buffer designed to drive high
impedance loads. This port has selectable 0/3/6 db gain
for -6 dBV, -3 dBV or 0 dBV DAC output levels
respectively. The Cap-less Stereo Headphone Output
port is similar to the line level output port but can drive 32
ohm headphones and may operate without DC blocking
capacitors by connecting the physical headphone’s
ground return to the VIRT_GND pin.
A CLASS_D Mono BTL Output and Class D Stereo
Processor w/ digital volume control (See CLASS_D
section for more information) provides up to 2.5 W of
output power into a 4 ohm speaker.
The line output port, headphone port and CLASS_D BTL
Power Output can select from the mixer, DAC0, DAC1 or
the line input (LINE_IN). The line input selection is
intended for very low power LINE_IN to LINE_OUT pass-
thru when VDD_AUDIO33 and VDD_AUDIO18 power on,
and configure LINE_OUT_SCTRL (Setting 2h, see Table
81) to select LINE_OUT from LINE_IN.
Audio – Class D BTL Amplifier
The IDTP95020 implements a digital Class-D 2.5W (4
Ω)
BTL amplifier which supports both 8
Ω and 4 Ω loads.
Gain for the BTL amplifier is programmable from -91 dB to
+36 dB in 0.5 dB steps using the Volume 0/1 registers.
Gain changes and mute may be applied immediately, on
zero crossing or ramped from the current to target value
slowly. These settings are controlled using the Gain
Control HI/LO registers.
EQ
There are 5 bands of parametric EQ (bi-quad) per channel.
Due to the flexibility of the bi-quad implementation, each
filter band may be configured as a high-pass, low-pass,
band-pass, high shelving, low shelving or other function.
Each band has an independent set of coefficients. A bi-
quad filter has 6 coefficients.
One coefficient is
normalized to 1 and 5 are programmed into the core.
Each band supports up to +15 dB boost or up to -36 dB
cut.
Coefficients
The following equations describe each filter band. The
fundamental equation is a bi-quadratic of the form:
2
1
2
1
z
2
a
z
1
a
0
a
z
2
b
z
1
b
0
b
)
z
(
H
+
=
(1)
Rearranging slightly we can see that normalizing a0 or b0
can reduce the number of stored coefficients.
()
( )
()
2
1
2
1
z
0
a
2
a
z
0
a
1
a
1
z
0
b
2
b
z
0
b
1
b
1
0
a
0
b
)
z
(
H
+
×
=
(2)
相關PDF資料
PDF描述
P95020NQG8 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132
P95020ZNQGI8 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132
P95020ZLLG 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124
P95020ZLLGI 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, PBGA124
P95020ZNQGI 2-CHANNEL POWER SUPPLY MANAGEMENT CKT, QCC132
相關代理商/技術參數
參數描述
P95020NQG8 制造商:Integrated Device Technology Inc 功能描述:Power Management and Control 132-Pin QFN EP T/R 制造商:Integrated Device Technology Inc 功能描述:POWER MANAGEMENT AUDIO & CONTROL - Tape and Reel 制造商:Integrated Device Technology Inc 功能描述:Integrates Audio, LED B/Light Pwr Mgt
P95020ZDLLG 制造商:Integrated Device Technology Inc 功能描述:124-LGA - Bulk
P95020ZDLLG8 制造商:Integrated Device Technology Inc 功能描述:124-LGA - Tape and Reel
P95020ZDNQG 制造商:Integrated Device Technology Inc 功能描述:132-VFQFPN - Bulk
P95020ZDNQG8 制造商:Integrated Device Technology Inc 功能描述:132-VFQFPN - Tape and Reel