參數資料
型號: L84225
英文描述: L84225 100BaseTX/FX/10BaseT Physical Layer Device technical manual 4/02
中文描述: L84225 100BaseTX/FX/10BaseT物理層設備的技術手冊,4月2日
文件頁數: 86/118頁
文件大?。?/td> 890K
代理商: L84225
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁當前第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁
86 of 118
April, 2002
L84225 Quad 100BaseTX/FX/10BaseT Phys. Layer Device - Technical Manual
Copyright 1999-2002 by LSI Logic Corporation. All rights reserved.
All GNDs should be connected as close as possible to the device with a
large ground plane. If the GNDs vary in potential by even a small
amount, noise and latchup can result. The GND pins should be kept to
within 50 mV of each other.
A 0.01-0.1uF decoupling capacitor should be connected between the
VDD group and GND on each of the 4 sides of the L84225 as close as
possible to the device pins, preferably within 0.5 in. The value should be
chosen depending on whether the noise from VDD-GND is high or low
frequency. A conservative approach would be to use two decoupling
capacitors on each side, one 0.1uf for low frequencies, and one 0.001 uf
for high frequency noise on the power supply.
The VDD connection to the transmit transformer center tap shown in
Figure 11
and
Figure 12
must be well decoupled in order to minimize
common mode noise injection from the supply into the twisted pair cable.
It is recommended that a 0.01 uF decoupling capacitor be placed
between the transformer center tap VDD connection and the L84225
GND plane. This decoupling capacitor should be physically placed as
close as possible to the transformer center tap, preferably within 0.5 in.
The PCB layout and power supply decoupling discussed above should
provide sufficient decoupling to achieve the following when measured at
the device:
1.
the resultant AC noise voltage measured across each VDD/GND set
should be less than 100 mVpp,
2.
all VDDs should be within 50 mVpp of each other, and
3.
all GNDs should be within 50 mVpp of each other.
相關PDF資料
PDF描述
L84302 L84302 Quad 100/10 Mbps 4-Port Ethernet Controller with RMON/SNMP Management Counters technical manual 4/02
L8560 Low-Power SLIC with Ringing
L8567 SLIC for Peoples Republic of China Applications
L8567-32PLCC Telecommunication IC
L8567-44PLCC Telecommunication IC
相關代理商/技術參數
參數描述
L84225/B1 制造商:LSI Corporation 功能描述:
L8446-04 制造商:HAMAMATSU 制造商全稱:Hamamatsu Corporation 功能描述:CW LASER DIODES
L8446-06 制造商:HAMAMATSU 制造商全稱:Hamamatsu Corporation 功能描述:CW LASER DIODES
L8446-07 制造商:HAMAMATSU 制造商全稱:Hamamatsu Corporation 功能描述:CW LASER DIODES
L8446-41 制造商:HAMAMATSU 制造商全稱:Hamamatsu Corporation 功能描述:CW LASER DIODES