- 您現在的位置：買賣IC網 > PDF目錄256038 > BX80530C1400512 (INTEL CORP) 32-BIT, 1400 MHz, MICROPROCESSOR, CPGA370 PDF資料下載
參數資料
| 型號： | BX80530C1400512 |
| 廠商： | INTEL CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 32-BIT, 1400 MHz, MICROPROCESSOR, CPGA370 |
| 封裝： | FLIP CHIP, PGA-370 |
| 文件頁數： | 16/94頁 |
| 文件大?。?/td> | 1775K |
| 代理商： | BX80530C1400512 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁
Datasheet
15
Intel Pentium III Processor with 512KB L2 Cache at 1.13GHz to 1.40GHz
2.7
Processor System Bus Unused Pins
All RESERVED pins must remain unconnected unless specifically noted. Connection of these pins
to VCCCORE, VREF, VSS, VTT or to any other signal (including each other) can result in component
malfunction or incompatibility with future processors. See Section 5.4 for a pin listing of the
processor and the location of each RESERVED pin.
PICCLK must be driven with a valid clock input and the PICD[1:0] signals must be pulled-up to
VCCCMOS1.5 even when the APIC will not be used. A separate pull-up resistor must be provided for
each PICD signal.
For reliable operation, always connect unused inputs or bidirectional signals to their deasserted
signal level. The pull-up or pull-down resistor values are system dependent and should be chosen
specifications of non-AGTL signals.
For unused AGTL inputs, the on-die termination will be sufficient. No external R
TT is necessary on
the motherboard
For unused CMOS inputs, active low signals should be connected through a pull-up resistor to
VCCCMOS1.5 and meet VIH requirements. Unused active high CMOS inputs should be connected
through a pull-down resistor to ground (VSS) and meet VIL requirements. Unused CMOS outputs
can be left unconnected. A resistor must be used when tying bidirectional signals to power or
ground. When tying any signal to power or ground, a resistor will also allow for system testability.
2.8
Processor System Bus Signal Groups
To simplify the following discussion, the processor system bus signals have been combined into
groups by buffer type. All P6 family processor system bus outputs are open drain and require a
high-level source provided termination resistors. However, the Intel Pentium III processor with
512KB L2 Cache includes on-die termination for AGTL signals and termination resistors placed on
the platform are not necessary except for the RESET# signal which still requires external
termination.
AGTL input signals have differential input buffers which use VREF as a reference signal. AGTL
output signals require termination to 1.25 V. In this document, the term “AGTL Input” refers to the
AGTL input group as well as the AGTL I/O group when receiving. Similarly, “AGTL Output”
refers to the AGTL output group as well as the AGTL I/O group when driving.
The PWRGOOD signal input is a 1.8V signal level and must be pulled up to VCCCMOS1.8. The
VTT_PWRGD is not 1.8V tolerant and must be connected to VTT (1.25V). Other CMOS inputs
(A20M#, IGNNE#, INIT#, LINT0/INTR, LINT1/NMI, PREQ#, SMI, SLP#, and STPCLK#) are
only 1.5 V tolerant and must be pulled up to VCCCMOS1.5. The CMOS, APIC, and TAP outputs are
open drain and must be pulled to the appropriate level to meet the input specifications of the
interfacing device.
The groups and the signals contained within each group are shown in Table 4. Refer to Section 7.0
for a description of these signals.
相關PDF資料 |
PDF描述 |
|---|---|
| BU-61743F3-222L | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| BU-61743F3-270K | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| BU-61743F3-410Z | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| BU-61743F3-472Q | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
| BU-61743F3-482K | 2 CHANNEL(S), 1M bps, MIL-STD-1553 CONTROLLER, CQFP72 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| BX80530F1100256 | 制造商:Intel 功能描述:CELERON PROCESSOR - Boxed Product (Development Kits) |
| BX80530F1200256 | 制造商:Intel 功能描述:MPU CELERON PROCESSOR 64-BIT 0.13UM 1.2GHZ 370-PIN FCPGA2 - Boxed Product (Development Kits) |
| BX80530F1300256 | 制造商:Intel 功能描述:MPU CELERON PROCESSOR 64-BIT 0.13UM 1.3GHZ 370-PIN FCPGA2 - Boxed Product (Development Kits) |
| BX80530F1400256 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| BX80531NK170G | 制造商:Intel 功能描述:MPU PENTIUM 4 PROCESSOR NETBURST 64-BIT 0.18UM 1.7GHZ - Boxed Product (Development Kits) 制造商:Intel 功能描述:P4 Socket 478 1.7GHz with fan |
發(fā)布緊急采購，3分鐘左右您將得到回復。