- 您現在的位置：買賣IC網 > PDF目錄293971 > 5962D1022901QXC 64M X 40 SYNCHRONOUS DRAM, 5.4 ns, CQFP128 PDF資料下載
參數資料
| 型號： | 5962D1022901QXC |
| 元件分類： | DRAM |
| 英文描述： | 64M X 40 SYNCHRONOUS DRAM, 5.4 ns, CQFP128 |
| 封裝： | CERAMIC, QFP-128 |
| 文件頁數： | 16/68頁 |
| 文件大?。?/td> | 1475K |
| 代理商： | 5962D1022901QXC |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁
23
Data from any READ burst may be truncated with a subsequent WRITE command, and data from a fixed-length READ burst may
be immediately followed by data from a WRITE command (subject to bus turnaround limitations). The WRITE burst may be
initiated on the clock edge immediately following the last (or last desired) data element from the READ burst, provided that I/O
contention can be avoided. In a given system design, there may be a possibility that the device driving the input data will go Low-Z
before the SDRAM DQs go High-Z. In this case, at least a single-cycle delay should occur between the last read data and the
WRITE command.
The DQM input is used to avoid I/O contention, as shown in Figure 12 and Figure 13. The DQM signal must be asserted (HIGH) at
least two clocks prior to the WRITE command (DQM latency is two clocks for output buffers) to suppress dataout from the READ.
After the WRITE command is registered, the DQs go High-Z (or remain High-Z), regardless of the state of the DQM signal,
provided the DQM was active on the clock just prior to the WRITE command that truncated the READ command. If not, the second
WRITE will be an invalid WRITE. For example, if DQM was LOW during T4 in Figure 13, then the WRITEs at T5 and T7 would
be valid, while the WRITE at T6 would be invalid.
The DQM signal must be de-asserted prior to the WRITE command (DQM latency is zero clocks for input buffers) to ensure that the
written data is not masked. Figure 12 shows the case where the clock frequency allows for bus contention to be avoided without add-
ing a NOP cycle, and Figure 13 shows the case where the additional NOP is needed.
Figure 12: READ-to-WRITE
READ
NOP
WRITE
BANK
Dout n
Din b
T5
T4
T3
T2
T1
T0
tHZ
tDS
tCK
Notes:
1.
CL = 3 is used for illustration. The READ or WRITE Command may be to any bank.
CLK
DQM
Command
Address
DQ
If a burst of one is used, DQM is not required.
Don’t Care
Transitioning Data
COL n
BANK
COL b
相關PDF資料 |
PDF描述 |
|---|---|
| 5962F0253401VXC | 2.5 V FIXED POSITIVE REGULATOR, CDFP16 |
| L491333DIE2V | 3.3 V FIXED POSITIVE REGULATOR, UUC |
| 5962F9654403QXA | OTHER DECODER/DRIVER, CDFP16 |
| 5962F9657601QCX | AC SERIES, 4-BIT LOOK-AHEAD CARRY GENERATOR, TRUE OUTPUT, CDIP16 |
| 5962F9657701VXC | ACT SERIES, 4-BIT LOOK-AHEAD CARRY GENERATOR, TRUE OUTPUT, CDFP16 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 5962D9563201VXC | 制造商:STMicroelectronics 功能描述:RS-432LINE DRIVERQUADFLAT16, GOLD - Bulk |
| 5962D9666301VXC | 制造商:STMicroelectronics 功能描述:RS-432LINE DRIVERQUADFLAT16, GOLD - Bulk |
| 5962F0052301QXC | 制造商:Intersil Corporation 功能描述: |
| 5962F0052301VXC | 制造商:Intersil Corporation 功能描述: |
| 5962F0151001VXC | 制造商:Intersil Corporation 功能描述:RAD SEU HARD QUAD COMPARATOR, CLASS V - Bulk |
發布緊急采購，3分鐘左右您將得到回復。