- 您現在的位置：買賣IC網 > PDF目錄385949 > TSB81BA3I (Texas Instruments, Inc.) IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER PDF資料下載
參數資料
| 型號： | TSB81BA3I |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | IEEE 1394b THREE-PORT CABLE TRANSCEIVER/ARBITER |
| 中文描述： | 的IEEE 1394b三端口電纜收發器/仲裁者 |
| 文件頁數： | 51/57頁 |
| 文件大小： | 810K |
| 代理商： | TSB81BA3I |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁當前第51頁第52頁第53頁第54頁第55頁第56頁第57頁
SLLS559B DECEMBER 2002 REVISED OCTOBER 2003
51
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
PRINCIPLES OF OPERATION (1394B INTERFACE)
receive (continued)
The sequence of events for a null packet reception is as follows:
(a) Receive operation initiated. The PHY indicates a receive operation by asserting receive on the CTL lines.
Normally, the interface is idle when receive is asserted. However, the receive operation may interrupt a
status transfer operation that is in progress so that the CTL lines may change from status to receive without
an intervening idle.
(b) Data-on indication. The PHY asserts the data-on indication code on the D lines for one or more cycles.
(c) Receive operation terminated. The PHY terminates the receive operation by asserting idle on the CTL lines.
The PHY asserts at least one idle cycle following a receive operation.
Table 35. Receive Speed Codes and Format
D0D7
DATA RATE AND FORMAT
0000 0000
S100 legacy
0000 0001
S100 beta
0000 0100
S200 legacy
0000 0101
S200 beta
0000 1000
S400 legacy
0000 1001
S400 beta
0000 1101
S800 beta
1111 1111
Data-on indication
All Others
Reserved
NOTE: Y = Output as 1 by PHY, ignored by LLC.
X = Output as 0 by PHY, ignored by LLC.
transmit
When the LLC issues a bus request through the LREQ terminal, the PHY arbitrates to gain control of the bus.
If the PHY wins arbitration for the serial bus, then the PHY-LLC interface bus is granted to the LLC by asserting
the grant state (11b) on the CTL terminals and the grant type on the D terminals for one PCLK cycle, followed
by idle for one clock cycle. The LLC then takes control of the bus by asserting either idle (00b), hold (11b) or
transmit (01b) on the CTL terminals. If the PHY does not detect a hold or transmit state within eight PCLK cycles,
then the PHY takes control of the PHY-link interface. The hold state is used by the LLC to retain control of the
bus while it prepares data for transmission. The LLC may assert hold for zero or more clock cycles (that is, the
LLC need not assert hold before transmit). During the hold state, the LLC is expected to drive the D lines to 0.
The PHY asserts data-prefix on the serial bus during this time.
When the LLC is ready to send data, the LLC asserts transmit on the CTL terminals as well as sending the first
bits of packet data on the D lines. The transmit state is held on the CTL terminals until the last bits of data have
been sent. The LLC then asserts either hold or idle on the CTL terminals for one clock cycle. If the hold is
asserted, then the hold is immediately followed by one clock cycle of idle. The link then releases the PHY-link
interface by putting the CTL and D terminals in a high-impedance state. The PHY then regains control of the
PHY-link interface.
相關PDF資料 |
PDF描述 |
|---|---|
| TSE-0155-32S-P1-3 | SINGLE MODE SINGLE FIBER TRANSCEIVER |
| TSL230 | PROGRAMMABLE LIGHT-TO-FREQUENCY CONVERTERS |
| TSL235(中文) | Programmable Light-To-Frequency Converter(光頻轉換器) |
| TSL245(中文) | IR Light-To-Frequency Converter(紅外光頻轉換器) |
| TSL250(中文) | Light-To-Voltage Converter(光壓轉換器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TSB81BA3IPFP | 功能描述:射頻收發器 s800 3-Port Cable Xcvr/Arbiter RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| TSB81BA3IPFPEP | 功能描述:射頻收發器 Mil Enh 3-Port Cable Xcvr/Arbiter RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| TSB81BA3PFP | 功能描述:射頻收發器 s800 3-Port Cable Xcvr/Arbiter RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| TSB81BA3PFPG4 | 功能描述:射頻收發器 s800 3-Port Cable Xcvr/Arbiter RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| TSB82AA2 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:1394b OHCI-LYNX CONTROLLER |
發布緊急采購，3分鐘左右您將得到回復。