- 您現在的位置：買賣IC網 > PDF目錄67723 > ISP1362EE,551 (NXP SEMICONDUCTORS) UNIVERSAL SERIAL BUS CONTROLLER, PBGA64 PDF資料下載
參數資料
| 型號： | ISP1362EE,551 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 總線控制器 |
| 英文描述： | UNIVERSAL SERIAL BUS CONTROLLER, PBGA64 |
| 封裝： | 6 X 6 MM, 0.80 HEIGHT, PLASTIC, MO-195, SOT-543-1, TFBGA-64 |
| 文件頁數： | 78/152頁 |
| 文件大?。?/td> | 677K |
| 代理商： | ISP1362EE,551 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁當前第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁
ISP1362_5
NXP B.V. 2007. All rights reserved.
Product data sheet
Rev. 05 — 8 May 2007
31 of 152
NXP Semiconductors
ISP1362
Single-chip USB OTG Controller
10. On-The-Go (OTG) Controller
10.1 Introduction
OTG is a supplement to the Hi-Speed USB (USB 2.0) specication that augments existing
USB peripherals by adding to these peripherals limited host capability to support other
targeted USB peripherals. It is primarily targeted at portable devices because it addresses
concerns related to such devices, such as a small connector and low power. Non-portable
devices (even standard hosts), nevertheless, can also benet from OTG features.
The ISP1362 OTG Controller is designed to perform all the tasks specied in the OTG
supplement. It supports Host Negotiation Protocol (HNP) and Session Request Protocol
(SRP) for dual-role devices. The ISP1362 uses software implementation of HNP and SRP
for maximum exibility. A set of OTG registers provides the control and status monitoring
capabilities to support software HNP or SRP.
Besides the normal USB transceiver, timers and analog components required by OTG are
also integrated on-chip. The analog components include:
Built-in 3.3 V-to-5 V charge pump
Voltage comparators
Pull-up or pull-down resistors on data lines
Charge or discharge resistors for VBUS
10.2 Dual-role device
When port 1 of the ISP1362 is congured in OTG mode, it can be used as an OTG
dual-role device. A dual-role device is a USB device that can function either as a host or
as a peripheral. As a host, the ISP1362 can support all four types of transfers (control,
bulk, isochronous and interrupt) at full-speed or low-speed. As a peripheral, the ISP1362
can support two control endpoints and up to 14 congurable endpoints, which can be
programmed to any of the four transfer types.
The default role of the ISP1362 is controlled by the ID pin, which in turn is controlled by
the type of plug connected to the mini-AB receptacle. If ID = LOW (mini-A plug
connected), it becomes an A-device, which is a host by default. If ID = HIGH (mini-B plug
connected), it becomes a B-device, which is a peripheral by default.
Both the A-device and the B-device work on a session base. A session is dened as the
period of time in which devices exchange data. A session starts when VBUS is driven and
ends when VBUS is turned off. Both the A-device and the B-device may start a session.
During a session, the role of the host can be transferred back and forth between the
A-device and the B-device any number of times by using HNP.
If the A-device wants to start a session, it turns on VBUS by enabling the charge pump. The
B-device detects that VBUS has risen above the B_SESS_VLD level and assumes the role
of a peripheral, asserting its pull-up resistor on the DP line. The A-device detects the
remote pull-up resistor and assumes the role of a host. Then, the A-device can
communicate with the B-device as long as it wishes. When the A-device nishes
communicating with the B-device, the A-device turns-off VBUS and both the devices nally
相關PDF資料 |
PDF描述 |
|---|---|
| ISP1520BD,557 | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| ISP1520BD,557 | UNIVERSAL SERIAL BUS CONTROLLER, PQFP64 |
| ISP1561BM,557 | UNIVERSAL SERIAL BUS CONTROLLER, PQFP128 |
| ISP1561BM,557 | UNIVERSAL SERIAL BUS CONTROLLER, PQFP128 |
| ISP1563BM | UNIVERSAL SERIAL BUS CONTROLLER, PQFP100 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ISP1362EE-S | 功能描述:IC USB CTRL SNGL CHIP 64TFBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| ISP1362EE-T | 功能描述:USB 接口集成電路 USB OTG HOST RoHS:否 制造商:Cypress Semiconductor 產品:USB 2.0 數據速率: 接口類型:SPI 工作電源電壓:3.15 V to 3.45 V 工作電源電流: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:WLCSP-20 |
| ISP1362EEUM | 功能描述:IC USB OTG CONTROLLER 64-TFBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 控制器 系列:- 標準包裝:4,900 系列:- 控制器類型:USB 2.0 控制器 接口:串行 電源電壓:3 V ~ 3.6 V 電流 - 電源:135mA 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:36-VFQFN 裸露焊盤 供應商設備封裝:36-QFN（6x6） 包裝:* 其它名稱:Q6396337A |
| ISP1362PCI/DOSOTG | 制造商:NXP Semiconductors 功能描述: |
| ISP1501 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Hi-Speed Universal Serial Bus peripheral transceiver |
發布緊急采購，3分鐘左右您將得到回復。