- 您現在的位置：買賣IC網 > PDF目錄379205 > IBM3209K3114 (IBM Microeletronics) IBM Packet Routing Switch Serial Interface Converter(IBM封裝路線選擇開關串行接口轉換器) PDF資料下載
參數資料
| 型號： | IBM3209K3114 |
| 廠商： | IBM Microeletronics |
| 英文描述： | IBM Packet Routing Switch Serial Interface Converter(IBM封裝路線選擇開關串行接口轉換器) |
| 中文描述： | IBM的分組路由交換機串行接口轉換器（IBM的封裝路線選擇開關串行接口轉換器） |
| 文件頁數： | 13/152頁 |
| 文件大?。?/td> | 2390K |
| 代理商： | IBM3209K3114 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁當前第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁
IBM3209K3114
Advance
IBM Packet Routing Switch Serial Interface Converter
prssi.01
July 12, 2000
Converter Ingress/Egress Data Flow
Page 3 of 142
2. Converter Ingress/Egress Data Flow
The ingress block is the receive path between the protocol engine device (PE) and the rest of the IBM Packet
Routing Switch Serial Interface Converter logic. The egress block is the transmit path between the converter
transmit logic and the PE. This section provides an overview of functions implemented in the converter
ingress and egress data flows. Some functions are duplicated to support two switch planes.
2.1 Ingress Data Flow
2.1.1 Protocol Engine (PE) Ingress Interface
The converter connects to the PE via a 32-bit bus. Ingress data packets are simultaneously routed to PATH X
and to PATH Y. Idle packets are inserted in the word stream when there is no data to transfer and are used to
maintain a synchronous packet operation in the ingress interface. Idle packets are identified by a bit in the
packet qualifier byte.
A Receive Start of Packet (RXSOP) synchronized with the data packet is used to delin-
eate packets.
Combined with the RXPRTY signal issued from the PE, the ingress interface checks the parity coherency on
each incoming RXDATA [31:0]. A specific bit in the configuration table registers can be set so each parity
error issued from the parity checker is reported.
Under the control of the configuration table, RXPRTY_error assertion indicates that the cell that is currently
pushed into the ingress reshuffling buffer will be optionally ignored and will not be sent to the ingress FIFO.
Cells which are pushed into the ingress FIFOs (X/Y RX FIFOs) are always good and can be treated by the
data flow.
2.1.2 Ingress Packet Reshuffling
The ingress logical unit framing block maps incoming data packets into the IBM 28.4 G Packet Routing
Switch (switch) logical units (LUs) by moving the five bytes (the packet qualifier and the bit map fields)
selected from the configuration register into the master LU, which becomes the switch header information
field. The framing block also extracts the IBFC information, discards idle packets, and performs parity
checking on the switch header.
2.1.3 Ingress Receive FIFO
The ingress receive FIFOs provide packet synchronization between the 50 - 125 MHz PE interface and the
110 - 125 MHz switch core interface.
2.1.4 Ingress Data Aligned Serial Link Interface (IDI)
The IDI sends packets continuously. Synchronization packets are sent during the DASL synchronization
sequence. Data or idle packets are sent once data mode is active. On request, through the configuration
table, the LU serializer is filled with a yellow packet and the incoming data packet is buffered while the yellow
packet is sent. When there is no data packet to be transmitted to the switch core, the IDI inserts an idle
packet, computes the inter idle CRC for each LU, and inserts it as the last byte of each LU.
相關PDF資料 |
PDF描述 |
|---|---|
| IBM32NPCXX1EPABBE66 | IBM Processor for Network Resources(異步轉換模式（ATM）32位微處理器（用于網絡資源管理）) |
| IBM39MPEGCS24DPFA16C | High Performance Audio/Video Decoder(高性能音頻/視頻譯碼器) |
| IBM39MPEGCS24PFA16C | High Performance Audio/Video Decoder(高性能音頻/視頻譯碼器) |
| IBM39STB130x0 | STB130x0 A/V Transport/Decoders(STB130x0 音頻/視頻的傳送譯碼器) |
| IBM42F10SNNAA20 | SFF-1063/1250N-SW PTH Serial Optical Transceiver(SFF-1063/1250N-SW PTH串行光纖收發器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IBM3209K4060 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecom Switching Circuit |
| IBM3288H2848 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| IBM32NPR100EXXCAB133 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| IBM32NPR101EPXCAC133 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Microprocessor |
| IBM35CPC945C03C-2 | 制造商:IBM 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。