- 您現在的位置：買賣IC網 > PDF目錄364674 > AMIS-53000-M Frequency Agile Transceiver PDF資料下載
參數資料
| 型號： | AMIS-53000-M |
| 英文描述： | Frequency Agile Transceiver |
| 中文描述： | 捷變頻收發器 |
| 文件頁數： | 53/99頁 |
| 文件大小： | 2638K |
| 代理商： | AMIS-53000-M |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁當前第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁
AMIS-53000
Frequency Agile Transceiver
Data Sheet
Table 37: Slice Threshold - 0X1D [29]
Bit
Name
7:0
SL_THRESH [7:0]
AM Data Filter and Slice Options
This register contains settings for determining the method of slicing for AM receive mode.
AM_FILTER:
Sets the post-detection filter bandwidth for RSSI during AM receive. These filter bandwidths are set for the
corresponding data rates. These filter settings can also be used with custom data rates.
AM_HYST:
Sets the amount of hysteresis in the AM slice comparator.
AM_SLICE:
Used to select the method for providing a reference to the AM slice comparator. DAC Mode: This is a fixed
threshold level programmed into the slice threshold register.
Average Mode:
This is an automatic threshold level where the AMIS-53000 sets the threshold level to the average level of
the RSSI signal. An external capacitor is required on the PEAK pin to set a bandwidth for the low pass filter response of the
averaging circuit. Due to the potential for long strings of 1’s or 0’s in NRZ data this threshold method is not recommended for
use with NRZ data.
Peak Mode:
This is similar to the average mode, but only the highest level is determined from the incoming signal and the
AMIS-53000 sets the threshold to a level 6dB lower than the peak value. An external capacitor on the PEAK pin determines a
bleed off (discharge) rate for the peak detector circuit.
Table 38: AM Data Filter and Slice Options - 0X1E [30]
Bit
Name
State
Comment
000
001
010
011
100
101
110
111
RSSI filter bandwidth = 38.4kHz
4
NU
00
01
10
11
DAC mode: Slice threshold set in register 1Bh
00
01
10
11
100mV slice hysteresis
FM FFT
The AMIS-53000 receiver uses a FFT function to recover data from a FM/FSK modulated signal when the data rate is higher than
20kbps. The FFT detector uses a two-bit DFFT to demodulate the incoming IF signal. This circuit also uses the same clock recovery
block (CDR) as the AM detector (See Section 6.1.4) to detect the data.
A pattern of 1’s and 0’s is required as a preamble. A SOF is not required unless Manchester encoded data is used, requiring a unique
preamble to bit-align the Manchester decoder to the recovered data.
Setup registers descriptions:
Data Rate
- Can be specified in the discrete data rate register, or specified as a 16-bit word for a user defined data rate. (See
Section 7.1.3)
Peak Deviation
- The peak deviation register stores the value to be used for both transmit and receive. In the FFT FM receive
mode, this value is used to set-up the FFT bins. (See Sections 6.4.1.5 and 6.4.1.6)
Comment
AM slice threshold in DAC Mode = SL_THRESH*7.8125mV
[7:5]
AM_FILTER[2:0]
RSSI filter bandwidth =300Hz
RSSI filter bandwidth = 600Hz
RSSI filter bandwidth = 1.2kHz
RSSI filter bandwidth = 2.4kHz
RSSI filter bandwidth = 4.8kHz
RSSI filter bandwidth = 9.6kHz
RSSI filter bandwidth = 19.2kHz
[3:2]
AM_SLICE[1:0]
DAC mode: Slice threshold set in register 1Bh
Average mode: AM threshold set using averaging filter
Peak detect mode: AM threshold set using peak detector
[1:0]
AM_HYST[1:0]
0mV slice hysteresis
25mV slice hysteresis
50mV slice hysteresis
53
AMI Semiconductor
– Aug. 05, Rev. 1.0
www.amis.com
相關PDF資料 |
PDF描述 |
|---|---|
| AMIS-53050 | Frequency Agile Transceiver |
| AMIS-710650 | Color CIS Module Analog Video Output |
| AMIS-710650-A6 | Color CIS Module Analog Video Output |
| AMIS-710651 | Color CIS Module |
| AMIS-710651-A4 | Color CIS Module |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AMIS-53050 | 制造商:ON Semiconductor 功能描述:WIRELESS LOW POWER TRANSC - 300-960MHZ, XTRA LOW RX PW, LQFP - Trays 制造商:ON Semiconductor 功能描述:WIRELESS LOW POWER TRANSC - 300-960MHZ, XTRA LOW RX PW, LQFP - Tape and Reel 制造商:ON Semiconductor 功能描述:WIRELESS LP TRANSC - 300-960MHZ, SPI INTERFACE:GANG XC, LQFP - Trays 制造商:ON Semiconductor 功能描述:WIRELESS LP TRANSC - 300-960MHZ, SPI INTERFACE:GANG XC, LQFP - Tape and Reel |
| AMIS-53050-I/A | 制造商:AMI 制造商全稱:AMI 功能描述:Frequency Agile Transceiver |
| AMIS-53050-XTD | 功能描述:射頻收發器 AMIS-53050 WLESS TRNSCVR RoHS:否 制造商:Atmel 頻率范圍:2322 MHz to 2527 MHz 最大數據速率:2000 Kbps 調制格式:OQPSK 輸出功率:4 dBm 類型: 工作電源電壓:1.8 V to 3.6 V 最大工作溫度:+ 85 C 接口類型:SPI 封裝 / 箱體:QFN-32 封裝:Tray |
| AMIS-70020 | 制造商:ON Semiconductor 功能描述:POWER FAILURE ELAPSED TIME COUNTER, SOIC - Rail/Tube 制造商:ON Semiconductor 功能描述:POWER FAILURE ELAPSED TIME COUNTER, SOIC - Tape and Reel |
| AMIS-710200 | 制造商:AMI 制造商全稱:AMI 功能描述:200dpi CIS Module |
發布緊急采購，3分鐘左右您將得到回復。