參數資料
型號: AM79C971
廠商: Advanced Micro Devices, Inc.
英文描述: PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus
中文描述: PCnet⑩快速單芯片全雙工10/100 Mbps以太網控制器,PCI總線
文件頁數: 59/265頁
文件大?。?/td> 3190K
代理商: AM79C971
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁當前第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁第251頁第252頁第253頁第254頁第255頁第256頁第257頁第258頁第259頁第260頁第261頁第262頁第263頁第264頁第265頁
Am79C971
59
If a poll operation has revealed that the current and the
next RDTE belong to the Am79C971 controller, then
additional poll accesses are not necessary. Future poll
operations will not include RDTE accesses as long as
the Am79C971 controller retains ownership of the cur-
rent and the next RDTE.
When receive activity is present on the channel, the
Am79C971 controller waits for the complete address of
the message to arrive. It then decides whether to ac-
cept or reject the frame based on all active addressing
schemes. If the frame is accepted, the Am79C971 con-
troller checks the current receive buffer status register
CRST (CSR41) to determine the ownership of the cur-
rent buffer.
If ownership is lacking, the Am79C971 controller will
immediately perform a final poll of the current RDTE. If
ownership is still denied, the Am79C971 controller has
no buffer in which to store the incoming message. The
MISS bit will be set in CSR0 and the Missed Frame
Counter (CSR112) will be incremented. Another poll of
the current RDTE will not occur until the frame has fin-
ished.
If the Am79C971 controller sees that the last poll (ei-
ther a normal poll, or the final effort described in the
above paragraph) of the current RDTE shows valid
ownership, it proceeds to a poll of the next RDTE. Fol-
lowing this poll, and regardless of the outcome of this
poll, transfers of receive data from the FIFO may begin.
Regardless of ownership of the second receive de-
scriptor, the Am79C971 controller will continue to per-
form receive data DMA transfers to the first buffer. If the
frame length exceeds the length of the first buffer, and
the Am79C971 controller does not own the second
buffer, ownership of the current descriptor will be
passed back to the system by writing a 0 to the OWN
bit of RMD1. Status will be written indicating buffer
(BUFF = 1) and possibly overflow (OFLO = 1) errors.
If the frame length exceeds the length of the first (cur-
rent) buffer, and the Am79C971 controller does own
the second (next) buffer, ownership will be passed back
to the system by writing a 0 to the OWN bit of RMD1
when the first buffer is full. The OWN bit is the only bit
modified in the descriptor. Receive data transfers to the
second buffer may occur before the Am79C971 con-
troller proceeds to look ahead to the ownership of the
third buffer. Such action will depend upon the state of
the FIFO when the OWN bit has been updated in the
first descriptor. In any case, lookahead will be per-
formed to the third buffer and the information gathered
will be stored in the chip, regardless of the state of the
ownership bit.
This activity continues until the Am79C971 controller
recognizes the completion of the frame (the last byte of
this receive message has been removed from the
FIFO). The Am79C971 controller will subsequently up-
date the current RDTE status with the end of frame
(ENP) indication set, write the message byte count
(MCNT) for the entire frame into RMD2, and overwrite
the
current
entries in the CSRs with the
next
entries.
Receive Frame Queuing
The Am79C971 controller supports the lack of RDTEs
when external SRAM (SRAM SIZE in BCR 25, bits 7-0)
is present through the Receive Frame Queuing mech-
anism. When the SRAM SIZE = 0, then the Am79C971
controller reverts back to the PCnet PCI II mode of op-
eration. This operation is automatic and does not re-
quire any programming by the host. When SRAM is
present, the Receive Frame Queuing mechanism
allows a slow protocol to manage more frames without
the high frame loss rate normally attributed to FIFO
based network controllers.
The Am79C971 controller will store the incoming
frames in the extended FIFOs until polling takes place;
if enabled, it discovers it owns an RDTE. The stored
frames are not altered in any way until written out into
system buffers. When the receive FIFO overflows, fur-
ther incoming receive frames will be missed during that
time. As soon as the network receive FIFO is empty, in-
coming frames are processed as normal. Status on a
per frame basis is not kept during the overflow process.
Statistic counters are maintained and accurate during
that time.
During the time that the Receive Frame Queuing mech-
anism is in operation, the Am79C971 controller relies
on the Receive Poll Time Counter (CSR 48) to control
the worst case access to the RDTE. The Receive Poll
Time Counter is programmed through the Receive Poll-
ing Interval (CSR49) register. The Received Polling In-
terval defaults to approximately 2 ms. The Am79C971
controller will also try to access the RDTE during nor-
mal descriptor accesses whether they are transmit or
receive accesses. The host can force the Am79C971
controller to immediately access the RDTE by setting
the RDMD (CSR 7, bit 13) to 1. Its operation is similar
to the transmit one. The polling process can be dis-
abled by setting the RXDPOLL (CSR7, bit 12) bit. This
will stop the automatic polling process and the host
must set the RDMD bit to initiate the receive process
into host memory. Receive frames are still stored even
when the receive polling process is disabled.
Software Interrupt Timer
The Am79C971 controller is equipped with a software
programmable free-running interrupt timer. The timer is
constantly running and will generate an interrupt STINT
(CSR 7, bit 11) when STINITE (CSR 7, bit 10) is set to
1. After generating the interrupt, the software timer will
load the value stored in STVAL and restart. The timer
value STVAL (BCR31, bits 15-0) is interpreted as an
unsigned number with a resolution of 12.8
μ
s. For in-
stance, a value of 122 ms would be programmed with
相關PDF資料
PDF描述
AM79C971KCW IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE
AM79C972BKCW PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support
AM79C972BKIW PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support
AM79C972BVCW PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support
AM79C972 PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support
相關代理商/技術參數
參數描述
AM79C971AKC 制造商:Advanced Micro Devices 功能描述:
AM79C971AVC 制造商:Advanced Micro Devices 功能描述:10/100 MBPS ETHERNET - Trays
AM79C971AVC\\W 制造商:Rochester Electronics LLC 功能描述:- Bulk
AM79C971AVC\W 制造商:Rochester Electronics LLC 功能描述:- Bulk
AM79C971AWW WAF 制造商:Advanced Micro Devices 功能描述: