- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C971 (Advanced Micro Devices, Inc.) PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus PDF資料下載
參數資料
| 型號： | AM79C971 |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| 中文描述： | PCnet⑩快速單芯片全雙工10/100 Mbps以太網控制器，PCI總線 |
| 文件頁數： | 238/265頁 |
| 文件大?。?/td> | 3190K |
| 代理商： | AM79C971 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁第220頁第221頁第222頁第223頁第224頁第225頁第226頁第227頁第228頁第229頁第230頁第231頁第232頁第233頁第234頁第235頁第236頁第237頁當前第238頁第239頁第240頁第241頁第242頁第243頁第244頁第245頁第246頁第247頁第248頁第249頁第250頁第251頁第252頁第253頁第254頁第255頁第256頁第257頁第258頁第259頁第260頁第261頁第262頁第263頁第264頁第265頁
D-2
Am79C971
Setup
The driver should set up descriptors in groups of three,
with the OWN and STP bits of each set of three de-
scriptors to read as follows: 11b, 10b, 00b.
An option bit (LAPPEN) exists in CSR3, bit position 5;
the software should set this bit. When set, the LAPPEN
bit directs the Am79C971 controller to generate an IN-
TERRUPT when STP has been written to a receive de-
scriptor by the Am79C971 controller.
Flow
The Am79C971 controller polls the current receive de-
scriptor at some point in time before a message arrives.
The Am79C971 controller determines that this receive
buffer is OWNed by the Am79C971 controller and it
stores the descriptor information to be used when a
message does arrive.
N0
Frame preamble appears on the wire, followed
by SFD and destination address.
N1
The 64th byte of frame data arrives from the
wire. This causes the Am79C971 controller to
begin frame data DMA operations to the first
buffer.
C0
When the 64th byte of the message arrives, the
Am79C971 controller performs a lookahead
operation to the next receive descriptor. This
descriptor should be owned by the Am79C971
controller.
C1
The Am79C971 controller intermittently re-
quests the bus to transfer frame data to the first
buffer as it arrives on the wire.
S1
The driver remains idle.
C2
When the Am79C971 controller has completely
filled the first buffer, it writes status to the first
descriptor.
C3
When the first descriptor for the frame has been
written,
changing
ownership
Am79C971 controller to the CPU, the
Am79C971 controller will generate an SRP IN-
TERRUPT. (This interrupt appears as a RINT
interrupt in CSR0).
from
the
S1
The SRP INTERRUPT causes the CPU to
switch tasks to allow the Am79C971 controller
’
s
driver to run.
C4
During the CPU interrupt-generated task
switching, the Am79C971 controller is perform-
ing a lookahead operation to the third descrip-
tor. At this point in time, the third descriptor is
owned by the CPU.
Note:
Even though the third buffer is not owned by the
Am79C971 controller, existing AMD Ethernet control-
lers will continue to perform data DMA into the buffer
space that the controller already owns (i.e., buffer num-
ber 2). The controller does not know if buffer space in
buffer number 2 will be sufficient or not for this frame,
but it has no way to tell except by trying to move the en-
tire message into that space. Only when the message
does not fit will it signal a buffer error condition--there is
no need to panic at this point that it discovers that it
does not yet own descriptor number 3.
S2
The first task of the drivers interrupt service
routing is to collect the header information from
the Am79C971 controller
’
s first buffer and pass
it to the application.
S3
The application will return an application buffer
pointer to the driver. The driver will add an offset
to the application data buffer pointer, since the
Am79C971 controller will be placing the first
portion of the message into the first and second
buffers. (the modified application data buffer
pointer will only be directly used by the
Am79C971 controller when it reaches the third
buffer.) The driver will place the modified data
buffer pointer into the final descriptor of the
group (#3) and will grant ownership of this de-
scriptor to the Am79C971 controller.
C5
Interleaved with S2, S3, and S4 driver activity,
the Am79C971 controller will write frame data
to buffer number 2.
S4
The driver will next proceed to copy the con-
tents of the Am79C971 controller
’
s first buffer
to the beginning of the application space. This
copy will be to the exact (unmodified) buffer
pointer that was passed by the application.
S5
After copying all of the data from the first buffer
into the beginning of the application data buffer,
the driver will begin to poll the ownership bit of
the second descriptor. The driver is waiting for
the Am79C971 controller to finish filling the sec-
ond buffer.
C6
At this point, knowing that it had not previously
owned the third descriptor and knowing that the
current message has not ended (there is more
data in the FIFO), the Am79C971 controller will
make a last ditch lookahead to the final (third)
descriptor. This time the ownership will be
TRUE (i.e., the descriptor belongs tot he con-
troller), because the driver wrote the application
pointer into this descriptor and then changed
the ownership to give the descriptor to the
Am79C971 controller back at S3. Note that if
steps S1, S2, and S3 have not completed at
this time, a BUFF error will result.
C7
After filling the second buffer and performing
the last chance lookahead to the next descrip-
tor, the Am79C971 controller will write the sta-
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C971KCW | IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE |
| AM79C972BKCW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BKIW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972BVCW | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
| AM79C972 | PCnet⑩-FAST+ Enhanced 10/100 Mbps PCI Ethernet Controller with OnNow Support |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C971AKC | 制造商:Advanced Micro Devices 功能描述: |
| AM79C971AVC | 制造商:Advanced Micro Devices 功能描述:10/100 MBPS ETHERNET - Trays |
| AM79C971AVC\\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| AM79C971AVC\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| AM79C971AWW WAF | 制造商:Advanced Micro Devices 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。