- 您現在的位置：買賣IC網 > PDF目錄370429 > HB52E169E12 (Hitachi,Ltd.) 128 MB Registered SDRAM DIMM(128 MB 寄存同步DRAM DIMM) PDF資料下載
參數資料
| 型號： | HB52E169E12 |
| 廠商： | Hitachi,Ltd. |
| 英文描述： | 128 MB Registered SDRAM DIMM(128 MB 寄存同步DRAM DIMM) |
| 中文描述： | 128 MB的注冊SDRAM的內存（128 MB的寄存同步的DRAM內存） |
| 文件頁數： | 42/53頁 |
| 文件大?。?/td> | 1737K |
| 代理商： | HB52E169E12 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁
HB52E169E12-F
42
Others
Power-down mode:
The SDRAM module enters power-down mode when CKE goes Low in the IDLE state.
In power down mode, power consumption is suppressed by deactivating the input initial circuit. Power down
mode continues while CKE is held Low. In addition, by setting CKE to High, the SDRAM module exits from
the power down mode, and command input is enabled from the next clock. In this mode, internal refresh is
not performed.
Clock suspend mode:
By driving CKE to Low during a bank-active or read/write operation, the SDRAM
module enters clock suspend mode. During clock suspend mode, external input signals are ignored and the
internal state is maintained. When CKE is driven High, the SDRAM module terminates clock suspend mode,
and command input is enabled from the next clock. For details, refer to the "CKE Truth Table".
Power-up sequence:
The SDRAM module should be gone on the following sequence with power up.
The CK, CKE, S, DQMB and DQ pins keep low till power stabilizes.
The CK pin is stabilized within 100
μ
s after power stabilizes before the following initialization sequence.
The CKE and DQMB is driven to high between power stabilizes and the initialization sequence.
This SDRAM module has V
CC
clamp diodes for CK, CKE, S, DQMB and DQ pins. If these pins go high
before power up, the large current flows from these pins to V
CC
through the diodes.
Initialization sequence:
When 200
μ
s or more has past after the above power-up sequence, all banks must
be precharged using the precharge command (PALL). After t
RP
delay, set 8 or more auto refresh commands
(REF). Set the mode register set command (MRS) to initialize the mode register. We recommend that by
keeping DQM, DQMU/DQML to High, the output buffer becomes High-Z during Initialization sequence, to
avoid DQ bus contention on memory system formed with a number of device.
Initialization sequence:
When 200
μ
s or more has past after the above power-up sequence, all banks must
be precharged using the precharge command (PALL). After t
RP
delay, set 8 or more auto refresh commands
(REF). Set the mode register set command (MRS) to initialize the mode register. We recommend that by
keeping DQMB to High, the output buffer becomes High-Z during Initialization sequence, to avoid DQ bus
contention on memory system formed with a number of device.
Stabilization time:
The PLL requires a stabilization time to achieve phase lock of the feedback signal to the
reference signal. This stabilization time is required following power-up. So this SDRAM module needs dam-
my cycle for 50
μ
s after power-up.
V
CC
Power up sequence
Initialization sequence
100
μ
s
0 V
Low
Low
Low
CKE, DQMB
CK
S
, DQ
200
μ
s
Power stabilize
相關PDF資料 |
PDF描述 |
|---|---|
| HB52E648EN | 512 MB Unbuffered SDRAM DIMM(512 MB 未緩沖同步DRAM DIMM) |
| HB52E649EN | 512 MB Unbuffered SDRAM DIMM(512 MB 未緩沖同步DRAM DIMM) |
| HB52E649E12 | THERMISTOR, NTC; Series:B575; Thermistor type:NTC; Resistance:10kR; Tolerance, resistance:+/-1%; Beta value:3450; Temperature, lower limit, beta value:0(degree C); Temperature, upper limit, beta value:100(degree C); Temp, op. RoHS Compliant: Yes |
| HB52E649E12-A6B | 512 MB Registered SDRAM DIMM 64-Mword 】 72-bit, 100 MHz Memory Bus, 1-Bank Module (18 pcs of 64 M 】 4 Components) PC100 SDRAM |
| HB52E649E12-B6B | 512 MB Registered SDRAM DIMM 64-Mword 】 72-bit, 100 MHz Memory Bus, 1-Bank Module (18 pcs of 64 M 】 4 Components) PC100 SDRAM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| HB52E169E1-B6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:x72 SDRAM Module |
| HB52E169EN-B6 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:x72 SDRAM Module |
| HB52E328EM-A6B | 制造商:ELPIDA 制造商全稱:Elpida Memory 功能描述:256MB Unbuffered SDRAM DIMM |
| HB52E328EM-B6B | 制造商:ELPIDA 制造商全稱:Elpida Memory 功能描述:256MB Unbuffered SDRAM DIMM |
| HB52E329EM-A6B | 制造商:ELPIDA 制造商全稱:Elpida Memory 功能描述:256MB Unbuffered SDRAM DIMM |
發布緊急采購，3分鐘左右您將得到回復。