- 您現在的位置：買賣IC網 > PDF目錄98071 > S5933QE (APPLIEDMICRO INC) PCI BUS CONTROLLER, PQFP160 PDF資料下載
參數資料
| 型號： | S5933QE |
| 廠商： | APPLIEDMICRO INC |
| 元件分類： | 總線控制器 |
| 英文描述： | PCI BUS CONTROLLER, PQFP160 |
| 封裝： | PLASTIC, QFP-160 |
| 文件頁數： | 171/176頁 |
| 文件大?。?/td> | 823K |
| 代理商： | S5933QE |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁當前第171頁第172頁第173頁第174頁第175頁第176頁
3-106
ADD-ON BUS INTERFACE
S5933
The internal interfaces of the S5933 allow Add-On
Operation Registers to be accessed asynchronous to
BPCLK (synchronous to the rising edge of the read
or write strobe). The exception to this is the Add-On
General Control/Status Register. This is due to the
async nature of FIFO status bits changing as the PCI
bus reads data. For Pass-Thru operations, the Pass-
Thru Data Register accesses are synchronous to
BPCLK to support burst transfers. The FIFO port may
also be accessed synchronous to BPCLK, if config-
ured to do so.
Asynchronous Register Accesses
For many Add-On applications, Add-On logic does not
operate at the PCI bus frequency. This is especially true
for Add-Ons implementing a microprocessor, which
may be operating at a lower (or higher) frequency. Fig-
ures 1 and 2 show asynchronous Add-On Operation
Register accesses. Exact AC timings are detailed in the
Electrical and AC Characteristics chapter (Chapter 13).
For asynchronous reads (Figure 1), data is driven on
the data bus when RD# is asserted. When RD# is not
asserted, the DQ[31:0] outputs float. A valid address
and valid byte enables must be presented before cor-
rect data is driven. RD# has both a minimum inactive
time and a minimum active time for asynchronous ac-
cesses.
For asynchronous writes (Figure 2), data is clocked
into the S5933 on the rising edge of the WR# input.
Address, byte enables, and data must all meet setup
and hold times relative to the rising edge or WR#.
WR# has both a minimum inactive time and a mini-
mum active time for asynchronous accesses
Synchronous FIFO and Pass-Thru
Data Register Accesses
To obtain the highest data transfer rates possible,
Add-On logic should operate synchronously with the
PCI clock. The buffered PCI clock (BPCLK) is pro-
vided for this purpose. A synchronous interface with
Pass-Thru mode or the FIFO allows data to be trans-
ferred at the maximum PCI bus bandwidth (132
MBytes/sec) by allowing burst accesses with the Add-
On interface. The RD# and WR# inputs become en-
ables, using BPCLK to clock data into and out of
registers. This section applies only to synchronous ac-
cesses to the FIFO (AFIFO) and Pass-Thru Data
(APTD) registers.
Figures 3 and 4 show single-cycle, synchronous
FIFO and Pass-Thru Operation Register accesses.
Exact AC timings are detailed in the Electrical and
AC Characteristics chapter.
For synchronous reads (Figure 3), data is driven onto
the data bus when RD# (or RDFIFO#) is asserted.
When RD# is not asserted, the DQ[31:0] outputs
float. The address, byte enable, and RD# inputs must
meet setup and hold times relative to the rising edge
of BPCLK. Burst reads may be performed by holding
RD# low.
For synchronous writes (Figure 4), data is clocked
into the register on the rising edge of BPCLK. Ad-
dress, byte enables, and data must all meet setup
and hold times relative to the rising edge or BPCLK.
Burst writes may be performed by holding WR# (or
WRFIFO#) low. When holding WR# low, data is
clocked in on each BPCLK rising edge.
nv Memory Accesses Through the Add-On
General Control/Status Register
To access nv memory contents through the Add-On
General Control/Status Register (AGCSTS), special
considerations must be made. Internally, all nv memory
accesses by the S5933 are synchronized to a divided-
down version of the PCI bus clock. Because of this, if
nv memory accesses are performed through the
AGCSTS register, the register access must be synchro-
nized to BPCLK. The rising edge RD# or WR# is still
used to clock data, but these inputs along with the ad-
dress and byte enables are synchronized to BPCLK.
Accesses to AGCSTS for monitoring FIFO or mailbox
status, etc., may be done asynchronous to BPCLK.
MAILBOX BUS INTERFACE
The mailbox register names may need some clarifi-
cation. For the Add-On interface, an outgoing mail-
box refers to a mailbox sending information to the
PCI bus. An incoming mailbox refers to a mailbox
receiving information from the PCI bus. An outgoing
mailbox on the Add-On interface is, internally, the
same as the corresponding incoming mailbox on the
PCI interface and vice-versa.
相關PDF資料 |
PDF描述 |
|---|---|
| S6A0032 | 16 X 80 DOTS DOT MAT LCD DRVR AND DSPL CTLR, UUC138 |
| S6A0069 | 16 X 40 DOTS DOT MAT LCD DRVR AND DSPL CTLR, UUC80 |
| S6A0078 | 34 X 120 DOTS DOT MAT LCD DRVR AND DSPL CTLR, UUC183 |
| S80296SA40 | 16-BIT, 40 MHz, MICROCONTROLLER, PQFP100 |
| S80486-DX4-75-S-V-8-B | 32-BIT, 75 MHz, MICROPROCESSOR, PQFP208 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| S5935 | 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PCI Product |
| S5935_07 | 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PCI Product |
| S59355QRC | 制造商:AppliedMicro 功能描述: |
| S5935QF | 制造商:AMCC 制造商全稱:Applied Micro Circuits Corporation 功能描述:PCI Product |
| S5935QRC | 制造商:AppliedMicro 功能描述:PCI Master Device 160-Pin PQFP |
發布緊急采購，3分鐘左右您將得到回復。