- 您現在的位置：買賣IC網 > PDF目錄369993 > pentium II cpu (Intel Corp.) Pentium II Processor AT 450MHZ(工作頻率450兆赫茲奔II處理器) PDF資料下載
參數資料
| 型號： | pentium II cpu |
| 廠商： | Intel Corp. |
| 英文描述： | Pentium II Processor AT 450MHZ(工作頻率450兆赫茲奔II處理器) |
| 中文描述： | 奔騰II處理器在450MHz（工作頻率450兆赫茲奔二處理器） |
| 文件頁數： | 14/84頁 |
| 文件大?。?/td> | 1092K |
| 代理商： | PENTIUM II CPU |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁
Pentium
II Processor at 350 MHz, 400 MHz, and 450 MHz
14
Datasheet
While in Deep Sleep state, the processor is incapable of responding to snoop transactions or
latching interrupt signals. No transitions or assertions of signals are allowed on the system bus
while the processor is in Deep Sleep state. Any transition on an input signal before the processor
has returned to Stop-Grant state will result in unpredictable behavior.
2.2.7
Clock Control
The processor provides the clock signal to the L2 cache. During AutoHALT Power Down and
Stop-Grant states, the processor will process a system bus snoop. The processor will not stop the
clock to the L2 cache during AutoHALT Power Down or Stop-Grant states. Entrance into the Halt/
Grant Snoop state will allow the L2 cache to be snooped, similar to the Normal state.
When the processor is in Sleep and Deep Sleep states, it will not respond to interrupts or snoop
transactions. During the Sleep state, the clock to the L2 cache is not stopped. During the Deep
Sleep state, the clock to the L2 cache is stopped. The clock to the L2 cache will be restarted only
after the internal clocking mechanism for the processor is stable (i.e., the processor has re-entered
Sleep state).
PICCLK should not be removed during the AutoHALT Power Down or Stop-Grant states.
PICCLK can be removed during the Sleep or Deep Sleep states. When transitioning from the Deep
Sleep state to the Sleep state, PICCLK must be restarted with BCLK.
2.3
Power and Ground Pins
The operating voltage of the processor die and of the L2 cache die differ from each other. There are
two groups of power inputs on the Pentium II processor package to support this voltage difference
between the components in the package. There are also five pins defined on the package for voltage
identification (VID). These pins specify the voltage required by the processor core. These have
been added to cleanly support voltage specification variations on current and future Pentium II
processors.
For clean on-chip power distribution, Pentium II processors have 27 V
CC
(power) and 30 V
SS
(ground) inputs. The 27 V
CC
pins are further divided to provide the different voltage levels to the
components. V
CC
inputs for the processor core and some L2 cache components account for 19
of the V
CC
pins, while 4 V
TT
inputs (1.5 V) are used to provide an AGTL+ termination voltage to
the processor and 3 V
CC
inputs (3.3 V) are for use by the L2 cache TagRAM and BSRAMs. One
V
CC5
pin is provided for use by the Slot 1 Test Kit. V
CC5
, V
CCL2
, and V
CC
must remain electrically
separated from each other. On the circuit board, all V
CC
pins must be connected to a voltage
island and all V
CCL2
pins must be connected to a separate voltage island (an island is a portion of a
power plane that has been divided, or an entire plane). Similarly, all V
SS
pins must be connected to
a system ground plane.
2.4
Decoupling Guidelines
Due to the large number of transistors and high internal clock speeds, the processor is capable of
generating large average current swings between low and full power states. This causes voltages on
power planes to sag below their nominal values if bulk decoupling is not adequate. Care must be
taken in the board design to ensure that the voltage provided to the processor remains within the
specifications listed in
Table 5
. Failure to do so can result in timing violations or a reduced lifetime
of the component.
相關PDF資料 |
PDF描述 |
|---|---|
| pentium II processor | 32 bit processor AT 233MHZ，266MHZ，300MHZ and 333MHZ(工作頻率233，266，300和333兆赫茲32位處理器) |
| pentium II xeon processor | pentium II xeon processor at 400 and 450 MHZ(工作頻率400和450兆赫茲奔II處理器) |
| Pentium III cpu with mobile | Pentium III processor Mobile Module Connector 2 (MMC-2)(帶移動模塊連接器2奔III處理器) |
| pentium III CPU | Pentium III Processor for the SC242 at 450MHz to 1.0GHz(SC242工作頻率450MHZ到1GHZ奔III處理器) |
| pentium III processor | 32 bit Processor Mobile Module(32 位帶移動模塊處理器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| P-ENV568K3G3 | 制造商:Panasonic Industrial Company 功能描述:TUNER |
| PEO14012 | 制造商:TE Connectivity 功能描述:RELAY SPCO 12VDC |
| PEO14024 | 制造商:TE Connectivity 功能描述:RELAY SPCO 24VDC |
| PEO96742 | 制造商:Delphi Corporation 功能描述:ASM TERM |
| PEOODO3A | 制造商:MACOM 制造商全稱:Tyco Electronics 功能描述:Versatile Power Entry Module with Small Footprint |
發布緊急采購，3分鐘左右您將得到回復。