国欧美品嫩模酒店援交视频处,91桃色视频下载

您現在的位置：買賣IC網 > PDF目錄67761 > M32185F4VFP 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144 PDF資料下載

型號：	M32185F4VFP
元件分類：	微控制器/微處理器
英文描述：	32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
封裝：	20 X 20 MM, 0.50 MM PITCH, PLASTIC, LQFP-144
文件頁數：	383/1032頁
文件大?。?/td>	5750K
代理商：	M32185F4VFP

10.4 TIO (Input/Output-Related 16-Bit Timer)

MULTIJUNCTION TIMERS

32185/32186 Group Hardware Manual

Rev.1.10 REJ09B0235-0110 May 15, 07

10.4.12 Operation in TIO Single-shot Output Mode (without Correction Function)

(1) Outline of TIO single-shot output mode

In single-shot output mode, the timer generates a pulse in width of "reload 0 register set value + 1" only once

and then stops.

When the timer is enabled " by writing to the enable bit in software or by external input "after setting the

reload 0 register, the counter is loaded with the content of the "reload 0 register -1" and starts counting

synchronously with the count clock at the next cycle. The counter counts down and when the minimum

count is reached, stops upon underflow.

The F/F output waveform in single-shot output mode is inverted " F/F output level changes from "L" to "H" or

vice versa" at startup and upon underflow, generating a single-shot pulse waveform in width of " reload 0

Furthermore, it is possible to generate an interrupt request and a DMA transfer request (for only the TIO8

and TIO9) upon underflow of the counter.

The count value is " reload 0 register set value + 1." (For counting operation, see also Section 10.3.9,

“Operation of TOP Single-shot Output Mode.” )

(2) Precautions about using TIO single-shot output mode

The following describes precautions to be observed when using TIO single-shot output mode.

If the counter stops due to an underflow in the same clock period as the timer is enabled by external input,

the former has priority so that the counter stops.

If the counter stops due to an underflow in the same clock period as count is enabled by writing to the

enable bit, the latter has priority so that count is enabled.

If the timer is enabled by external input in the same clock period as count is disabled by writing to the

enable bit, the latter has priority so that count is disabled.

Because the timer operates synchronously with the count clock, up to one count clock-dependent delay

is generated before F/F output is inverted after writing to the enable bit.

相關PDF資料	PDF描述
M32185F4VFP	32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
M34283G2GP	4-BIT, MROM, 4 MHz, MICROCONTROLLER, PDSO20
M34283G2-XXXGP	4-BIT, MROM, 4 MHz, MICROCONTROLLER, PDSO20
M34502E4FP	4-BIT, OTPROM, MICROCONTROLLER, PDSO24
M34502M4-XXXFP	4-BIT, MROM, MICROCONTROLLER, PDSO24

相關代理商/技術參數	參數描述
M32186F8VFP	制造商:Renesas Electronics Corporation 功能描述:
M3219	功能描述:電纜固定件和配件 LTCG PG-16 BLACK With 3173 NUT RoHS:否制造商:Heyco 類型:Cable Grips, Liquid Tight 材料:Nylon 顏色:Black 安裝方法:Cable 最大光束直徑:11.4 mm 抗拉強度:
M32192F8TFP#U0	制造商:Renesas Electronics Corporation 功能描述:MCU 32-bit M32R RISC 1024KB Flash 3.3V/5V 144-Pin LQFP
M32192F8VFP	制造商:Renesas Electronics Corporation 功能描述:
M321-SERIES	制造商:未知廠家制造商全稱:未知廠家功能描述:Peripheral IC

發布緊急采購，3分鐘左右您將得到回復。

(若只采購一條型號，填寫一行即可)

*型號	*數量	廠商	批號	封裝