參數資料
型號: EP7209
廠商: Cirrus Logic, Inc.
英文描述: Ultra-Low-Power Audio Decoder System-on-Chip
中文描述: 超低功耗音頻解碼器系統級芯片
文件頁數: 83/128頁
文件大?。?/td> 1382K
代理商: EP7209
EP7209
DS453PP2
83
5.15
5.15.1
SS2 Registers
SS2DR Synchronous Serial Interface 2 Data Register
ADDRESS: 0x8000.1500
This is the 16-bit wide data register for the full-duplex master/slave SSI2 synchronous serial interface.
Writing data to this register will initiate a transfer. Writes need to be word writes and the bottom 16
bits are transferred to the TX FIFO. Reads will be 32 bits as well; the low 16 bits contain RX data and
the upper 16-bits should be ignored. Although the interface is byte-oriented, data is written in two
bytes at a time to allow higher bandwidth transfer. It is up to the software to assemble the bytes for
the data stream in an appropriate manner.
All reads/writes to this register must be word reads/writes.
5.15.2
SS2POP Synchronous Serial Interface 2 Pop Residual Byte
ADDRESS: 0x8000.16C0
This is a write-only location which will cause the contents of the RX shift register to be popped into
the RX FIFO, thus enabling a residual byte to be read. The data value written to this register is ig-
nored. This location should be used in conjunction with the RESVAL and RESFRM bits in the
SYSFLG2 register.
5.16
DAI Register Definitions
There are five registers within the DAI Interface, one control register, three data registers, and one
status register. The control register is used to mask or unmask interrupt requests to service the DAI
s
FIFOs, and to select whether an on-chip or off-chip clock is used to drive the bit rate, and to en-
able/disable operation. The first pair of data register addresses the top of the right channel transmit
FIFO and the bottom of the right channel receive FIFO. A read accesses the receive FIFOs, and a
write the transmit FIFOs. Note that these are four physically separate FIFOs to allow full-duplex trans-
mission. The status register contains bits which signal FIFO overrun and underrun errors and transmit
and receive FIFO service requests. Each of these status conditions signal an interrupt request to the
interrupt controller. The status register also flags when the transmit FIFOs are not full when the re-
ceive FIFOs are not empty.
相關PDF資料
PDF描述
EP7211 HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER
EP7211-CP-A HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER
EP7211-CV-A HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER
EP7212 HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
EP7212-CB-A HIGH-PERFORMANCE, LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER AND DIGITAL AUDIO INTERFACE(DAI)
相關代理商/技術參數
參數描述
EP7209-CB-D 制造商:Rochester Electronics LLC 功能描述:- Bulk
EP7209-CV-D 制造商:Rochester Electronics LLC 功能描述:- Bulk
EP7211 制造商:CIRRUS 制造商全稱:Cirrus Logic 功能描述:HIGH-PERFORMANCE ULTRA-LOW-POWER SYSTEM-ON-CHIP WITH LCD CONTROLLER
EP7211(208LQFP) 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Logic IC
EP7211(256PBGA) 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Logic IC