參數資料
型號: DATASHEET
英文描述: ST10F168 - 16-BIT MCU - 8KB RAM - 256KB FLASH MEMORY - 111 I/O - 1 CAN 2.0B INTERFACE
中文描述: ST10F168 - 16位MCU - 8KB的內存- 256KB的快閃記憶體- 111的I / O - 1 CAN 2.0B總線接口
文件頁數: 42/74頁
文件大?。?/td> 897K
代理商: DATASHEET
ST10F168
42/74
18 - POWER REDUCTION MODES
Two different power reduction modes with different
levels of power reduction can be entered under
software control.
In
Idle mode
the CPU is stopped, while the
peripherals continue their operation. Idle mode
can be terminated by any reset or interrupt
request.
In
Power Down mode
both the CPU and the
peripherals are stopped. Power Down mode can
be configured by software in order to be termi-
nated only by a hardware reset or by an external
interrupt source on fast external interrupt pins.
There are two different operating Power Down
modes:
Protected power down mode:
selected by set-
ting bit PWDCFG in the SYSCON register to ‘0’.
This mode can be used in conjunction with an
external power failure signal which pulls the NMI
pin low when a power failure is imminent. The
microcontroller enters the NMI trap routine and
saves the internal state into RAM. The trap rou-
tine then sets a flag or writes a bit pattern into
specific RAM locations, and executes the
PWRDN instruction. If the NMI pin is still low at
this time, Power Down mode will be entered, if
not program execution continues. During power
down the voltage at the V
CC
pins can be lowered
to 2.5 V and the contents of the internal RAM will
still be preserved.
Interruptible
mode is selected by setting bit PWDCFG in the
SYSCON register. The CPU and peripheral
clocks are frozen, and the oscillator and PLL are
stopped. To exit power down mode with an ex-
ternal interrupt, an EXxIN (x = 7...0) pin has to
be asserted for at least 40ns. This signal ena-
bles the internal oscillator and PLL circuitry, and
turns on the weak pulldown. If the Interrupt was
enabled before entering power down mode, the
device executes the interrupt service routine,
and then resumes execution after the PWRDN
instruction. If the interrupt was disabled, the de-
vice executes the instruction following PWRDN
instruction, and the Interrupt Request Flag re-
mains set until it is cleared by software.
power
down
mode:
this
All external bus actions are completed before Idle
or Power Down mode is entered. However, Idle or
Power Down mode is
not
entered if READY is
enabled, but has not been activated (driven low for
negative polarity, or driven high for positive polar-
ity) during the last bus access.
相關PDF資料
PDF描述
DAV-SB100 Ensemble Home Cinema
DB-3 EMI Filter; Filter Type:Standard; Current Rating:20A; Voltage Rating:250V; Depth:151mm; Height:35mm; Series:MB; Weight:530g; Width:52mm RoHS Compliant: Yes
DB-CE110 EMI Filter; Filter Type:Standard; Current Rating:36A; Voltage Rating:250V; Depth:151mm; Height:35mm; Series:MB; Weight:660g; Width:67mm RoHS Compliant: Yes
DB1000
DB1001
相關代理商/技術參數
參數描述
DATAVS1-08-DC-K 制造商:IDEC Corporation 功能描述:Sensor, Vision, Compact Image Based Control Unit w/ 3.5 In. Color Configurator
DATAVS2-06-DE-AOR 制造商:IDEC Corporation 功能描述:Smart Vision Sensor, Advance object recognition, 6mm lens
DATAVS2-06-DE-OBJ 制造商:IDEC Corporation 功能描述:Vision sensor, 6mm lens, ethernet conn., object recognition
DATAVS2-08-DE-AOR 制造商:IDEC Corporation 功能描述:Sensor, Vision, Compact Image Based Control Unit, P.C. Config., Adv'd Obj. Recog
DATAVS2-08-DE-OBJ 制造商:IDEC Corporation 功能描述:Sensor, Vision, Compact Image Based Control Unit, P.C. Configured, Object Recog. 制造商:IDEC Corporation 功能描述:Vision sensors 8mm lens