參數資料
型號: ATA6285N-PNPW
廠商: ATMEL CORP
元件分類: 通信及網絡
英文描述: SPECIALTY TELECOM CIRCUIT, QCC32
封裝: 5 X 5MM, QFN-32
文件頁數: 103/121頁
文件大小: 9917K
代理商: ATA6285N-PNPW
82
4958B–AUTO–11/10
Atmel ATA6285/ATA6286 [Preliminary]
If the “ATA6289” is combined with ATA5756/ATA5757 as stacked die the pins PD5/T2O1 and
PD6/T2O2 are internally bonded with the “ASK” - and “FSK” - pins of ATA5756/ATA5757
respectively, see Figure 2-2 on page 4. So you can use the SSI of the Timer2 modulator stage to
modulate the ATA5756/ATA5757 (ASK - or FSK - modulation).
The Timer2 Compare Register (T2COR) and Timer2 Input Capture Register (T2ICR) are all
16-bit registers. Special procedures must be followed when accessing the 16-bit registers.
These procedures are described in the Section 3.13.2 “Accessing 16-bit Registers” on page 70.
The Timer2 control/mode registers (T2CRA, T2CRB, T2MRA, T2MRB, T2MDR) are 8-bit regis-
ters and have no CPU access restrictions.
The comparator output is controlled by a control register (T2CRA) and contains mask bits for the
actions (counter reset, output toggle, timer interrupt) which can be triggered by a compare match
event or the counter overflow. This architecture enables the timer for various modes.
The functions of the output modulator are controlled by two registers (T2MRB, T2MDR). The SSI
transmit data buffer register (TXB) and the SSI Receive data buffer (RXB) register share the
same I/O address referred to the SSI data register (T2MDR). The modes of Timer2 operations
and also the modulator I/O pins are controlled by the T2MRB register.
Interrupt requests (shorten as Int.Req.) signals are all visible in the Timer Interrupt Flag Register
(T2IFR). All interrupts are individually masked with the Timer Interrupt Mask register (T2IMR).
The counter2 input clock (CL2) can be supplied via the I/O Clock (CLK
I/O), the external input
clock (T2I), the external input clock (T3I), the Timer0 output clock (CLK
T0), the Timer1 output
clock (CLK
T1), the Timer3 output clock (CLKT3), the output clock of the Sensor Interface Block
(SENO) or the Timer clock (CLT).
The Output Compare Registers (T2COR) is compared with the Timer/Counter value at all time.
The result of the compare can be used by the modulator stage to generate a PWM or variable
frequency output on the two selectable modulator output pins (T2O1/T2O2).
The TOP value, or maximum Timer/Counter value, can in some modes of operation be defined
by either the T2MRA Register. The Timer2 has three selectable fixed TOP values.
3.13.5.1
Definitions
The following definitions are used extensively throughout the section:
The Timer2 Compare Data Values
16-bit compare register (T2COR) data value range:
m = y +1
-->
0
≤ y ≤ 65535
Three different fixed TOP data values:
n = 0x00FF, 0x01FF or 0x03FF
Table 3-36.
Definitions
Name
Description
MAX
The counter reaches its MAXimum when it becomes 0xFFFF (decimal 65535).
TOP
The counter reaches the TOP when it becomes equal to the highest value defined by
the fixed TOP values: 0x00FF, 0x01FF, or 0x03FF. The assignment is dependent of
the mode of operation.
相關PDF資料
PDF描述
ATA6285N-PNQW SPECIALTY TELECOM CIRCUIT, QCC32
ATCB-B01-RM50 INTERCONNECTION DEVICE
ATEP-161100-SMA-P-01 INTERCONNECTION DEVICE
ATH15T05-9S 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE
ATO2815T 3-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE
相關代理商/技術參數
參數描述
ATA6285N-PNQW 功能描述:射頻微控制器 - MCU IC LF, Cap. Sens. Interface RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:Si100x 數據總線寬度:8 bit 最大時鐘頻率:24 MHz 程序存儲器大小:64 KB 數據 RAM 大小:4 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 85 C 封裝 / 箱體:LGA-42 安裝風格:SMD/SMT 封裝:Tube
ATA6285-PNPW 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:TPMS Control and Transmitter IC
ATA6285-PNQW 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:TPMS Control and Transmitter IC
ATA6286 制造商:ATMEL 制造商全稱:ATMEL Corporation 功能描述:TPMS Control and Transmitter IC
ATA6286C-PNPW 制造商:Atmel Corporation 功能描述:IC CTLR/XMITTER 433MHZ 32QFN 制造商:Atmel Corporation 功能描述:Active RFID AVR-uC, 125kHz + 433MHz