- 您現在的位置：買賣IC網 > PDF目錄364551 > 8XC196LX 8XC196Lx - 8XC196Lx Supplement to 8X196Kx. 8X196Jx. 87C196CA User＇s Manual PDF資料下載
參數資料
| 型號： | 8XC196LX |
| 英文描述： | 8XC196Lx - 8XC196Lx Supplement to 8X196Kx. 8X196Jx. 87C196CA User＇s Manual |
| 中文描述： | 8XC196Lx - 8XC196Lx補編8X196Kx。 8X196Jx。 87C196CA用戶手冊 |
| 文件頁數： | 71/136頁 |
| 文件大?。?/td> | 659K |
| 代理商： | 8XC196LX |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁當前第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁
8-5
J1850 COMMUNICATIONS CONTROLLER
8.3.1.2
Bus Contention
Bus contention arises when multiple nodes attempt to access and transmit message frames across
the J1850 bus simultaneously. This creates a conflict on the bus. The recognition of conflicting
symbols or bits on the bus is referred to as
contention detection
. For example, if a node observes
a difference between a symbol it transmits to the J1850 bus and the symbol that it detects on the
bus, that node has detected contention to the transmission of its message frame. Only one message
frame from one node vying for the bus wins arbitration on each symbol or bit of its frame. This
winning message frame does not experience or detect contention. The message frames that were
not awarded arbitration will experience contention.
8.3.1.3
Bit Arbitration
A
bit arbitration
scheme is used to resolve such conflicts as bus contention. The J1850 protocol
uses the carrier sense multiple access (CSMA) bit arbitration scheme. Bit arbitration is the pro-
cess of settling conflicts that occur when multiple nodes attempt to transmit one bit or symbol at
a time across a single bus. A symbol is simply a timing-level formatted bit. By definition, a node
that detects contention has lost arbitration and will discontinue transmitting any further symbols
remaining in its message frame. Remaining nodes vying for the bus will continue to send their
symbols until the next instance of contention is detected or arbitration is awarded. This process
continues until a complete message frame from one node has been transmitted. For details on this
arbitration scheme, refer to the
“Bit Arbitration Example” on page 8-7.
8.3.1.4
Error Detection
The J1850 controller’s error detection logic monitors the bus for four error conditions, and sets
the J1850BE interrupt pending bit in the J_STAT register if an error occurs. The following list
describes each error type:
CRC error — the calculated CRC checksum received on incoming messages has a value
other than C4H (the expected value for all received message frames).
bus symbol timing error — the symbol stream on the J1850 bus contains an invalid symbol.
An invalid symbol is any signal that is between 8 μs and 34 μs in duration.
incomplete byte error — an EOD/EOF symbol occurred,but was not on a byte boundary;
the number of bits recieved was not a multiple of eight.
no echo — the message is transmitted; however, the transmission’s echo back through the
feedback loop to the receiver has not been detected within the allowable 60 μs window.
8.3.2
Symbol Synchronization and Timing Circuitry
The symbol synchronization and timing (SST) circuitry consists of a clock prescaler, digital filter,
delay compensation circuitry, and synchronization and symbol encoding/decoding circuitry. The
SST supports Huntzicker encoding of symbols, which entails 10.4 Kb/s variable pulse-width
(VPW) operation for valid edge detection on message receptions.
相關PDF資料 |
PDF描述 |
|---|---|
| 8XC51FA | 8-bit CMOS (low voltage, low power and high speed) microcontroller families |
| 8XC51FC | 8-bit CMOS (low voltage, low power and high speed) microcontroller families |
| 8XC51RD | 8-bit CMOS (low voltage, low power and high speed) microcontroller families |
| 8XC80C32 | 8-bit CMOS (low voltage, low power and high speed) microcontroller families |
| 8XC51FB | Low power single card reader |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 8XC196MC | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:INDUSTRIAL MOTOR CONTROL MICROCONTROLLER |
| 8XC196MD | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:INDUSTRIAL MOTOR CONTROL MICROCONTROLLER |
| 8XC196MH | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:8XC196MH INDUSTRIAL MOTOR CONTROL CHMOS MICROCONTROLLER |
| 8XC196NP | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:COMMERCIAL CHMOS 16-BIT MICROCONTROLLER |
| 8XC196NT | 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:CHMOS MICROCONTROLLER WITH 1 MBYTE LINEAR ADDRESS SPACE |
發布緊急采購，3分鐘左右您將得到回復。