參數資料
型號： W9712G8JB-3
廠商： WINBOND ELECTRONICS CORP
元件分類： DRAM
英文描述： DDR DRAM, PBGA60
封裝： 8 X 12.50 MM, ROHS COMPLIANT, WBGA-60
文件頁數： 42/86頁
文件大小： 1039K
代理商： W9712G8JB-3
W9712G8JB
Publication Release Date: Oct. 12, 2010
- 47 -
Revision A01
Notes:
1. All voltages are referenced to VSS.
2. Tests for AC timing, IDD, and electrical AC and DC characteristics may be conducted at nominal reference/supply voltage
levels, but the related specifications and device operation are guaranteed for the full voltage range specified. ODT is
disabled for all measurements that are not ODT-specific.
3. AC timing reference load:
DQ
DQS
Output
Timing
reference
point
VTT = VDDQ/2
25
VDDQ
DUT
Figure 16
– AC timing reference load
4. This is a minimum requirement. Minimum read to precharge timing is AL + BL / 2 provided that the tRTP and tRAS(min)
have been satisfied.
5. If refresh timing is violated, data corruption may occur and the data must be re-written with valid data before a valid READ
can be executed.
6. This is an optional feature. For detailed information, please refer to “operating temperature condition” section 9.2 in this data
sheet.
7. tCKE min of 3 clocks means CKE must be registered on three consecutive positive clock edges. CKE must remain at the
valid input level the entire time it takes to achieve the 3 clocks of registration. Thus, after any CKE transition, CKE may not
transition from its valid level during the time period of tIS + 2 x tCK + tIH.
8. A minimum of two clocks (2 *nCK) is required irrespective of operating frequency.
9. tWTR is at least two clocks (2 * nCK) independent of operation frequency.
10. There are two sets of values listed for Command/Address input setup time: tIS(base) and tIS(ref). The tIS(ref) value (for
reference only) is equivalent to the baseline value of tIS(base) at VREF when the slew rate is 1.0 V/nS. The baseline value
tIS(base) is the JEDEC defined value, referenced from the input signal crossing at the VIH(ac) level for a rising signal and
VIL(ac) for a falling signal applied to the device under test. See Figure 17. If the Command/Address slew rate is not equal to
1.0 V/nS, then the baseline values must be derated by adding the values from table of tIS/tIH derating values for DDR2-667,
DDR2-800 and DDR2-1066 (page 55).
CLK
tIS(base) tIH(base)
VDDQ
VIH(ac) min
VIH(dc) min
VREF(dc)
VIL(dc) max
VIL(ac) max
VSS
tIS(ref)
tIH(ref)
tIS(ref)
tIH(ref)
Logic levels
VREF levels
Figure 17
– Differential input waveform timing – tIS and tIH
相關PDF資料
PDF描述
W971GG6IB-25 32M X 16 DDR DRAM, 0.4 ns, PBGA84
W9751G6JB-25A 32M X 16 DDR DRAM, 0.4 ns, PBGA84
W9751G8JB-18 DDR DRAM, PBGA84
W9812G21H-6I 4M X 32 SYNCHRONOUS DRAM, 5 ns, PDSO86
W9812G21H-6C 4M X 32 SYNCHRONOUS DRAM, 4.5 ns, PDSO86
相關代理商/技術參數
參數描述
W971GG6JB 制造商:WINBOND 制造商全稱:Winbond 功能描述:8M ? 8 BANKS ? 16 BIT DDR2 SDRAM
W971GG6JB-18 制造商:Winbond Electronics Corp 功能描述:1GB DDR2 制造商:Winbond Electronics Corp 功能描述:IC DDR2 SDRAM 1GBIT 1.875NS
W971GG6JB-25 制造商:Winbond Electronics Corp 功能描述:DRAM Chip DDR2 SDRAM 1G-Bit 64Mx16 1.8V 84-Pin WBGA 制造商:Winbond Electronics 功能描述:64MBX16 DDR2 制造商:Winbond 功能描述:DRAM Chip DDR2 SDRAM 1G-Bit 64Mx16 1.8V 84-Pin WBGA
W971GG6JB25I 功能描述:IC DDR2 SDRAM 1GBIT 84WBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:3,000 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:32K (4K x 8) 速度:100kHz，400kHz 接口:I²C，2 線串口 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) 其它名稱:CAV24C32WE-GT3OSTR
W971GG6JB-25I 制造商:Winbond Electronics 功能描述:-40~85 1GB DDR2 FOR INDUSTRY
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*