參數資料
型號： W9712G8JB-3
廠商： WINBOND ELECTRONICS CORP
元件分類： DRAM
英文描述： DDR DRAM, PBGA60
封裝： 8 X 12.50 MM, ROHS COMPLIANT, WBGA-60
文件頁數： 18/86頁
文件大小： 1039K
代理商： W9712G8JB-3
W9712G8JB
Publication Release Date: Oct. 12, 2010
- 25 -
Revision A01
Therefore the Burst Stop command is not supported on DDR2 SDRAM devices.
Table 3 – Burst Length and Sequence
Burst Length
Starting Address
(A2 A1 A0)
Sequential Addressing
(decimal)
Interleave Addressing
(decimal)
4
x00
0, 1, 2, 3
x01
1, 2, 3, 0
1, 0, 3, 2
x10
2, 3, 0, 1
x11
3, 0, 1, 2
3, 2, 1, 0
8
000
0, 1, 2, 3, 4, 5, 6, 7
001
1, 2, 3, 0, 5, 6, 7, 4
1, 0, 3, 2, 5, 4, 7, 6
010
2, 3, 0, 1, 6, 7, 4, 5
011
3, 0, 1, 2, 7, 4, 5, 6
3, 2, 1, 0, 7, 6, 5, 4
100
4, 5, 6, 7, 0, 1, 2, 3
101
5, 6, 7, 4, 1, 2, 3, 0
5, 4, 7, 6, 1, 0, 3, 2
110
6, 7, 4, 5, 2, 3, 0, 1
111
7, 4, 5, 6, 3, 0, 1, 2
7, 6, 5, 4, 3, 2, 1, 0
7.4.3
Burst read mode operation
Burst Read is initiated with a READ command. The address inputs determine the starting column
address for the burst. The delay from the start of the command to when the data from the first cell
appears on the outputs is equal to the value of the read latency (RL). The data strobe output (DQS) is
driven LOW one clock cycle before valid data (DQ) is driven onto the data bus. The first bit of the burst
is synchronized with the rising edge of the data strobe (DQS). Each subsequent data-out appears on
the DQ pin in phase with the DQS signal in a source synchronous manner. The RL is equal to an
additive latency (AL) plus CAS Latency (CL). The CL is defined by the Mode Register Set (MRS). The
AL is defined by the Extended Mode Register EMR (1). (Example timing waveforms refer to 10.7 and
10.8 Data output (read) timing and Burst read operation diagram in Chapter 10)
7.4.4
Burst write mode operation
Burst Write is initiated with a WRITE command. The address inputs determine the starting column
address for the burst. Write Latency (WL) is defined by a Read Latency (RL) minus one and is equal
to (AL + CL -1); and is the number of clocks of delay that are required from the time the write
command is registered to the clock edge associated to the first DQS strobe. A data strobe signal
(DQS) should be driven LOW (preamble) nominally half clock prior to the WL. The first data bit of the
burst cycle must be applied to the DQ pins at the first rising edge of the DQS following the preamble.
The tDQSS specification must be satisfied for each positive DQS transition to its associated clock edge
during write cycles. The subsequent burst bit data are issued on successive edges of the DQS until
the burst length is completed, which is 4 or 8 bit burst. When the burst has finished, any additional
data supplied to the DQ pins will be ignored. The DQ Signal is ignored after the burst write operation is
complete. The time from the completion of the burst write to bank precharge is the write recovery time
(WR). (Example timing waveforms refer to 10.9 and 10.10 Data input (write) timing and Burst write
operation diagram in Chapter 10)
相關PDF資料
PDF描述
W971GG6IB-25 32M X 16 DDR DRAM, 0.4 ns, PBGA84
W9751G6JB-25A 32M X 16 DDR DRAM, 0.4 ns, PBGA84
W9751G8JB-18 DDR DRAM, PBGA84
W9812G21H-6I 4M X 32 SYNCHRONOUS DRAM, 5 ns, PDSO86
W9812G21H-6C 4M X 32 SYNCHRONOUS DRAM, 4.5 ns, PDSO86
相關代理商/技術參數
參數描述
W971GG6JB 制造商:WINBOND 制造商全稱:Winbond 功能描述:8M ? 8 BANKS ? 16 BIT DDR2 SDRAM
W971GG6JB-18 制造商:Winbond Electronics Corp 功能描述:1GB DDR2 制造商:Winbond Electronics Corp 功能描述:IC DDR2 SDRAM 1GBIT 1.875NS
W971GG6JB-25 制造商:Winbond Electronics Corp 功能描述:DRAM Chip DDR2 SDRAM 1G-Bit 64Mx16 1.8V 84-Pin WBGA 制造商:Winbond Electronics 功能描述:64MBX16 DDR2 制造商:Winbond 功能描述:DRAM Chip DDR2 SDRAM 1G-Bit 64Mx16 1.8V 84-Pin WBGA
W971GG6JB25I 功能描述:IC DDR2 SDRAM 1GBIT 84WBGA RoHS:是 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:3,000 系列:- 格式 - 存儲器:EEPROMs - 串行 存儲器類型:EEPROM 存儲容量:32K (4K x 8) 速度:100kHz，400kHz 接口:I²C，2 線串口 電源電壓:2.5 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOIC 包裝:帶卷 (TR) 其它名稱:CAV24C32WE-GT3OSTR
W971GG6JB-25I 制造商:Winbond Electronics 功能描述:-40~85 1GB DDR2 FOR INDUSTRY
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*