參數資料
型號： MT48H8M16LFB4-8IT:JTR
元件分類： DRAM
英文描述： 8M X 16 SYNCHRONOUS DRAM, 6 ns, PBGA54
封裝： 8 X 8 MM, LEAD FREE, VFBGA-54
文件頁數： 10/61頁
文件大?。?/td> 2469K
PDF: 09005aef8237e877/Source: 09005aef8237e8d8
Micron Technology, Inc., reserves the right to change products or specifications without notice.
128Mb_x16 Mobile SDRAM_Y25M_2.fm - Rev. A 6/06 EN
18
2006 Micron Technology, Inc. All rights reserved.
128Mb: x16 Mobile SDRAM
Deep Power-Down
Preliminary
except CKE is disabled (LOW). Once the SELF REFRESH command is registered, all the
inputs to the SDRAM become “Don’t Care” with the exception of CKE, which must
remain LOW.
During Self Refresh, the device is refreshed as identified in the extended mode register
(see PASR setting). For the full array, all four banks are refreshed simultaneously with a
refresh frequency set by an internal self refresh oscillator. This oscillator changes due to
the temperature sensors input. As the case temperature of the Mobile SDR SDRAM
changes, the oscillation frequency changes to accommodate the change of temperature.
This happens because the DRAM capacitors lose charge faster at higher temperatures.
To ensure efficient power dissipation during self refresh, the oscillator changes to refresh
at the slowest rate possible to maintain data integrity. The SDRAM must remain in self
refresh mode for a minimum period equal to tRAS and may remain in self refresh mode
for an indefinite period beyond that.
The procedure for exiting self refresh requires a sequence of commands. First, CLK must
be stable (stable clock is defined as a signal cycling within timing constraints specified
for the clock pin) prior to CKE going back HIGH. Once CKE is HIGH, the SDRAM must
have NOP commands issued (a minimum of two clocks) for tXSR because time is
required for the completion of any internal refresh in progress.
Upon exiting the self refresh mode, AUTO REFRESH commands should be issued at
once and then every 15.625s or less, as both SELF REFRESH and AUTO REFRESH
utilize the row refresh counter.
Deep Power-Down
The operating mode deep power-down achieves maximum power reduction by elimi-
nating the power of the whole memory array of the device. Array data will not be
retained once the device enters deep power-down mode.
This mode is entered by having all banks idle then CS# and WE# held LOW with RAS#
and CAS# held HIGH at the rising edge of the clock, while CKE is LOW. This mode is
exited by asserting CKE HIGH.
Operation
Bank/Row Activation
Before any READ or WRITE commands can be issued to a bank within the SDRAM, a row
in that bank must be “opened.” This is accomplished via the ACTIVE command, which
selects both the bank and the row to be activated (see Figure 7 on page 19).
After opening a row (issuing an ACTIVE command), a READ or WRITE command may be
issued to that row, subject to the tRCD specification. tRCD (MIN) should be divided by
the clock period and rounded up to the next whole number to determine the earliest
clock edge after the ACTIVE command on which a READ or WRITE command can be
entered. For example, a tRCD specification of 20ns with a 125 MHz clock (8ns period)
results in 2.5 clocks, rounded to 3. This is reflected in Figure 8 on page 19, which covers
any case where 2 < tRCD (MIN)/tCK ≤ 3. (The same procedure is used to convert other
specification limits from time units to clock cycles.)
A subsequent ACTIVE command to a different row in the same bank can only be issued
after the previous active row has been “closed” (precharged). The minimum time
interval between successive ACTIVE commands to the same bank is defined by tRC.
相關PDF資料
PDF描述
MT48LC4M32TG-10 4M X 32 SYNCHRONOUS DRAM, 7 ns, PDSO54
MT48V8M16LFB4-8XT 8M X 16 SYNCHRONOUS DRAM, 7 ns, PBGA54
MT48LC4M32LFB5-10ES:G 4M X 32 SYNCHRONOUS DRAM, 7 ns, PBGA90
MT48V4M32TG-8XT 4M X 32 SYNCHRONOUS DRAM, 7 ns, PDSO54
MT48LC8M8A2TG-8EL:GIT 8M X 8 SYNCHRONOUS DRAM, 6 ns, PDSO54
相關代理商/技術參數
參數描述
MT48H8M16LFF3-7E 制造商:Micron Technology Inc 功能描述:
MT48H8M16LFF4-10 功能描述:IC SDRAM 128MBIT 100MHZ 54VFBGA RoHS:否 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1 系列:- 格式 - 存儲器:RAM 存儲器類型:SDRAM 存儲容量:256M（8Mx32） 速度:143MHz 接口:并聯 電源電壓:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 封裝/外殼:90-VFBGA 供應商設備封裝:90-VFBGA（8x13） 包裝:托盤 其它名稱:Q2841869
MT48H8M16LFF4-10 IT 功能描述:IC SDRAM 128MBIT 100MHZ 54VFBGA RoHS:否 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1 系列:- 格式 - 存儲器:RAM 存儲器類型:SDRAM 存儲容量:256M（8Mx32） 速度:143MHz 接口:并聯 電源電壓:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 封裝/外殼:90-VFBGA 供應商設備封裝:90-VFBGA（8x13） 包裝:托盤 其它名稱:Q2841869
MT48H8M16LFF4-8 功能描述:IC SDRAM 128MBIT 125MHZ 54VFBGA RoHS:否 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1 系列:- 格式 - 存儲器:RAM 存儲器類型:SDRAM 存儲容量:256M（8Mx32） 速度:143MHz 接口:并聯 電源電壓:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 封裝/外殼:90-VFBGA 供應商設備封裝:90-VFBGA（8x13） 包裝:托盤 其它名稱:Q2841869
MT48H8M16LFF4-8 IT 功能描述:IC SDRAM 128MBIT 125MHZ 54VFBGA RoHS:否 類別:集成電路 (IC) >> 存儲器 系列:- 標準包裝:1 系列:- 格式 - 存儲器:RAM 存儲器類型:SDRAM 存儲容量:256M（8Mx32） 速度:143MHz 接口:并聯 電源電壓:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 封裝/外殼:90-VFBGA 供應商設備封裝:90-VFBGA（8x13） 包裝:托盤 其它名稱:Q2841869
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*