參數資料
型號： MC92603VF
廠商： Freescale Semiconductor
文件頁數： 99/126頁
文件大?。?/td> 0K
描述： IC TXRX ETH QUAD GIG 256-MAPBGA
標準包裝： 1
類型： 收發器
驅動器/接收器數： 4/4
規程： 千兆位以太網
電源電壓： 4.5 V ~ 5.5 V
安裝類型： 表面貼裝
封裝/外殼： 256-LBGA
供應商設備封裝： 256-MAPBGA
包裝： 托盤
System Design Considerations
MC92603 Quad Gigabit Ethernet Transceiver Reference Manual, Rev. 1
5-6
Freescale Semiconductor
5.7
Power Supply Requirements
The recommended board for the MC92603 has a minimum of two solid planes of 1-ounce copper. One
plane is to be used as a ground plane and the second plane is to be used for the 1.8-V supply. It is
recommended that the board has its own 1.8- and 3.3-V regulators with less than 50-mV ripple.
5.8
Phase-Locked Loop (PLL) Power Supply Filtering
An analog power supply is required. The PLLAVDD signal provides power for the analog portions of the
PLL. To ensure stability of the internal clock, the power supplied to the PLL is filtered using a circuit
similar to the one shown in Figure 5-1. For maximum effectiveness, the filter circuit is placed as close as
possible to the PLLAVDD ball to ensure that it filters out as much noise as possible. The ground connection
should be near the PLLAGND ball. The 0.01-
F capacitor is closest to the ball, followed by the 1-F
capacitor, and finally the 1-
resistor to VDD on the 1.8-V power plane. The capacitors are connected from
PLLAGND to the ground plane. Ceramic chip capacitors with the highest possible self-resonant frequency
should be used. All traces should be kept short, wide, and direct.
Figure 5-1. PLL Power Supply Filter Circuits
TST_0, TST_1
Test mode identifiers
Must be low and remain low during normal
operation. Device must be reset if changed.
LBOE
Loopback output enable
Enable/disable transmit links during testing
(LBOE = high). No recovery action necessary,
STNDBY
Puts PLL in standby mode
Receiver must re-establish byte and word
synchronization
RESET
System reset bar
Device is reset
ENABLE_RED
Enable redundant mode
Device must be reset
Table 5-3. Asynchronous Configuration and Control Signals (continued)
Signal Name
Description
Effect of Changed State
VDD
1
0.01 F
PLLAVDD
1.0 F
GND
相關PDF資料
PDF描述
MC92604VM IC ETH TXRX DUAL GIG 196-MAPBGA
MC92604ZT IC TXRX ETH DUAL GIG 196-MAPBGA
MCP2120T-I/SL IC ENCODR/DECODR 2.5V IR 14-SOIC
MCP2122-E/P IC ENCODER/DECODER IRDA 8-DIP
MCP2122T-E/SNG IC ENCODER/DECODR INFRARED 8SOIC
相關代理商/技術參數
參數描述
MC92603VM 功能描述:IC ETH TXRX QUAD GIG 256-MAPBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR)
MC92604VM 功能描述:IC ETH TXRX DUAL GIG 196-MAPBGA RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 標準包裝:1,000 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:3 V ~ 5.5 V 安裝類型:表面貼裝 封裝/外殼:16-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:16-SOIC 包裝:帶卷 (TR)
MC92604ZT 功能描述:IC TXRX ETH DUAL GIG 196-MAPBGA RoHS:否 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件
MC92610 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES
MC92610VF 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:Quad 3.125 Gbaud SERDES
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*