- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C970A (Advanced Micro Devices, Inc.) PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product PDF資料下載
參數資料
| 型號： | AM79C970A |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| 中文描述： | PCnet - 2的PCI單芯片全雙工以太網控制器，適用于PCI總線產品 |
| 文件頁數： | 84/219頁 |
| 文件大?。?/td> | 1065K |
| 代理商： | AM79C970A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁當前第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁
AMD
P R E L I M I N A R Y
84
Am79C970A
interrupts the receive oscillator. The oscillator is then re-
started at the second Manchester ZERO (bit time 4) and
is phase locked to it. As a result, the MENDEC acquires
the clock from the incoming Manchester bit pattern in 4
bit times with a 1010b Manchester bit pattern.
IRXCLK and IRXDAT are enabled 1/4 bit time after clock
acquisition in bit cell 5. IRXDAT is at a HIGH state when
the receiver is idle (no IRXCLK). IRXDAT however, is
undefined when clock is acquired and may remain HIGH
or change to LOW state whenever IRXCLK is enabled.
At 1/4 bit time into bit cell 5, the controller portion of the
PCnet-PCI II controller sees the first IRXCLK transition.
This also strobes in the incoming fifth bit to the MENDEC
as Manchester ONE. IRXDAT may make a transition af-
ter the IRXCLK rising edge in bit cell 5, but its state is still
undefined. The Manchester ONE at bit 5 is clocked to
IRXDAT output at 1/4 bit time in bit cell 6.
PLL Tracking
After clock acquisition, the phase-locked clock is com-
pared to the incoming transition at the bit cell center
(BCC) and the resulting phase error is applied to a cor-
rection circuit. This circuit ensures that the phase-
locked clock remains locked on the received signal.
Individual bit cell phase corrections of the Voltage Con-
trolled Oscillator (VCO) are limited to 10% of the phase
difference between BCC and phase-locked clock.
Hence, input data jitter is reduced in IRXCLK by 10 to 1.
Carrier Tracking and End of Message
The carrier detection circuit monitors the DI
±
inputs after
IRXEN is asserted for an end of message. IRXEN deas-
serts 1 to 2 bit times after the last positive transition on
the incoming message. This initiates the end of recep-
tion cycle. The time delay from the last rising edge of the
message to IRXEN deassert allows the last bit to be
strobed by IRXCLK and transferred to the controller sec-
tion, but prevents any extra bit(s) at the end of message.
Data Decoding
The data receiver is a comparator with clocked output to
minimize noise sensitivity to the DI
±
inputs. Input error is
less than
±
35 mV to minimize sensitivity to input rise
and fall time. IRXCLK strobes the data receiver output at
1/4 bit time to determine the value of the Manchester bit,
and clocks the data out on IRXDAT on the following
IRXCLK. The data receiver also generates the signal
used for phase detector comparison to the internal
MENDEC voltage controlled oscillator (VCO).
Jitter Tolerance Definition
The MENDEC utilizes a clock capture circuit to align its
internal data strobe with an incoming bit stream. The
clock acquisition circuitry requires four valid bits with the
values 1010b. The clock is phase-locked to the negative
transition at the bit cell center of the second ZERO in
the pattern.
Since data is strobed at 1/4 bit time, Manchester transi-
tions which shift from their nominal placement through
1/4 bit time will result in improperly decoded data. With
this as the criterion for an error, a definition of Jitter
Handling is:
The peak deviation approaching or crossing 1/4 bit cell
position from nominal input transition, for which the
MENDEC section will properly decode data.
Attachment Unit Interface
The Attachment Unit Interface (AUI) is the PLS (Physi-
cal Layer Signaling) to PMA (Physical Medium Attach-
ment) interface which effectively connects the DTE to a
MAU. The differential interface provided by the
PCnet-PCI II controller is fully compliant to Section 7 of
ISO 8802-3 (ANSI/IEEE 802.3).
After the PCnet-PCI II controller initiates a transmission
it will expect to see data “l(fā)ooped-back” on the DI
±
pair
(when the AUI port is selected). This will internally gen-
erate a “carrier sense”, indicating that the integrity of the
data path to and from the MAU is intact, and that the
MAU is operating correctly. This “carrier sense” signal
must be asserted before end of transmission. If ”carrier
sense” does not become active in response to the data
transmission, or becomes inactive before the end of
transmission, the loss of carrier (LCAR) error bit will be
set in the transmit descriptor ring (TMD2, bit 27) after the
frame has been transmitted.
Differential Input Termination
The differential input for the Manchester data (DI
±
) is
externally terminated by two 40.2
resistors and one
optional common-mode bypass capacitor, as shown in
the diagram below. The differential input impedance,
Z
IDF
, and the common-mode input impedance, Z
ICM
,
are specified so that the Ethernet specification for cable
termination impedance is met using standard 1% resis-
tor terminators. If SIP devices are used, 39 ohms is also
a suitable value. The CI
±
differential inputs are termi-
nated in exactly the same way as the DI
±
pair.
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C970AVCW | PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970 | PCnetTM-PCI Single-Chip Ethernet Controller for PCI Local Bus |
| AM79C971VCW | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C971 | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C971KCW | IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C970AKC | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970AKC\\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Advanced Micro Devices 功能描述: |
| AM79C970AKC\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| AM79C970AKCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
發布緊急采購，3分鐘左右您將得到回復。