- 您現在的位置：買賣IC網 > PDF目錄366550 > AM79C970A (Advanced Micro Devices, Inc.) PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product PDF資料下載
參數資料
| 型號： | AM79C970A |
| 廠商： | Advanced Micro Devices, Inc. |
| 英文描述： | PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| 中文描述： | PCnet - 2的PCI單芯片全雙工以太網控制器，適用于PCI總線產品 |
| 文件頁數： | 71/219頁 |
| 文件大小： | 1065K |
| 代理商： | AM79C970A |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁當前第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁第162頁第163頁第164頁第165頁第166頁第167頁第168頁第169頁第170頁第171頁第172頁第173頁第174頁第175頁第176頁第177頁第178頁第179頁第180頁第181頁第182頁第183頁第184頁第185頁第186頁第187頁第188頁第189頁第190頁第191頁第192頁第193頁第194頁第195頁第196頁第197頁第198頁第199頁第200頁第201頁第202頁第203頁第204頁第205頁第206頁第207頁第208頁第209頁第210頁第211頁第212頁第213頁第214頁第215頁第216頁第217頁第218頁第219頁
P R E L I M I N A R Y
AMD
71
Am79C970A
the PCnet-PCI II controller returns ownership for the last
buffer of the first frame.
If an error occurs in the transmission before all of the
bytes of the current buffer have been transferred, trans-
mit status of the current buffer will be immediately up-
dated. If the buffer does not contain the end of packet,
the PCnet-PCI II controller will skip over the rest of the
frame which experienced the error. This is done by re-
turning to the polling microcode where the PCnet-PCI II
controller will clear the OWN bit for all descriptors with
OWN = 1 and STP = 0 and continue in like manner until a
descriptor with OWN = 0 (no more transmit frames in the
ring) or OWN = 1 and STP = 1 (the first buffer of a new
frame) is reached.
At the end of any transmit operation, whether successful
or with errors, immediately following the completion of
the descriptor updates, the PCnet-PCI II controller will
always perform another polling operation. As described
earlier, this polling operation will begin with a check of
the current RDTE, unless the PCnet-PCI II controller al-
ready owns that descriptor. Then the PCnet-PCI II con-
troller will poll the next TDTE. If the transmit descriptor
OWN bit has a ZERO value, the PCnet-PCI II controller
will resume incrementing the poll time counter. If the
transmit descriptor OWN bit has a value of ONE, the
PCnet-PCI II controller will begin filling the FIFO with
transmit data and initiate a transmission. This end-of-
operation poll coupled with the TDTE lookahead opera-
tion allows the PCnet-PCI II controller to avoid inserting
poll time counts between successive transmit frames.
By default, whenever the PCnet-PCI II controller com-
pletes a transmit frame (either with or without error) and
writes the status information to the current descriptor,
then the TINT bit of CSR0 is set to indicate the comple-
tion of a transmission. This causes an interrupt signal if
the IENA bit of CSR0 has been set and the TINTM bit of
CSR3 is cleared. The PCnet-PCI II controller provides
two modes to reduce the number of transmit interrupts.
The interrupt of a successfully transmitted frame can be
suppressed by setting TINTOKD (CSR5, bit 15) to ONE.
Another mode, which is enabled by setting LTINTEN
(CSR5, bit 14) to ONE, allows suppression of interrupts
for successful transmissions for all but the last frame in
a sequence.
Receive Descriptor Table Entry
If the PCnet-PCI II controller does not own both the cur-
rent and the next Receive Descriptor Table Entry
(RDTE) then the PCnet-PCI II controller will continue to
poll according to the polling sequence described above.
If the receive descriptor ring length is one, then there is
no next descriptor to be polled.
If a poll operation has revealed that the current and the
next RDTE belong to the PCnet-PCI II controller then
additional poll accesses are not necessary. Future poll
operations will not include RDTE accesses as long as
the PCnet-PCI II controller retains ownership of the cur-
rent and the next RDTE.
When receive activity is present on the channel, the
PCnet-PCI II controller waits for the complete address
of the message to arrive. It then decides whether to ac-
cept or reject the frame based on all active addressing
schemes. If the frame is accepted the PCnet-PCI II con-
troller checks the current receive buffer status register
CRST (CSR41) to determine the ownership of the
current buffer.
If ownership is lacking, the PCnet-PCI II controller will
immediately perform a final poll of the current RDTE. If
ownership is still denied, the PCnet-PCI II controller has
no buffer in which to store the incoming message. The
MISS bit will be set in CSR0 and the Missed Frame
Counter (CSR112) will be incremented. An interrupt will
be generated if IENA (CSR0, bit 6) is set to ONE and
MISSM (CSR3, bit 12) is cleared to ZERO. Another
poll of the current RDTE will not occur until the frame
has finished.
If the PCnet-PCI II controller sees that the last poll
(either a normal poll, or the final effort described in the
above paragraph) of the current RDTE shows valid own-
ership, it proceeds to a poll of the next RDTE. Following
this poll, and regardless of the outcome of this poll,
transfers of receive data from the FIFO may begin.
Regardless of ownership of the second receive
descriptor, the PCnet-PCI II controller will continue to
perform receive data DMA transfers to the first buffer. If
the frame length exceeds the length of the first buffer,
and the PCnet-PCI II controller does not own the second
buffer, ownership of the current descriptor will be
passed back to the system by writing a ZERO to
the OWN bit of RMD1 and status will be written
indicating buffer (BUFF = 1) and possibly overflow
(OFLO = 1) errors.
If the frame length exceeds the length of the first (cur-
rent) buffer, and the PCnet-PCI II controller does own
the second (next) buffer, ownership will be passed back
to the system by writing a ZERO to the OWN bit of
RMD1 when the first buffer is full. The OWN bit is the
only bit modified in the descriptor. Receive data
transfers to the second buffer may occur before the
PCnet-PCI II controller proceeds to look ahead to the
ownership of the third buffer. Such action will depend
upon the state of the FIFO when the OWN bit has been
updated in the first descriptor. In any case, lookahead
will be performed to the third buffer and the information
gathered will be stored in the chip, regardless of the
state of the ownership bit.
This activity continues until the PCnet-PCI II controller
recognizes the completion of the frame (the last byte of
this receive message has been removed from the
FIFO). The PCnet-PCI II controller will subsequently
相關PDF資料 |
PDF描述 |
|---|---|
| AM79C970AVCW | PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970 | PCnetTM-PCI Single-Chip Ethernet Controller for PCI Local Bus |
| AM79C971VCW | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C971 | PCnet⑩-FAST Single-Chip Full-Duplex 10/100 Mbps Ethernet Controller for PCI Local Bus |
| AM79C971KCW | IC LOGIC 16211 24-BIT FET BUS SWITCH -40+85C TSSOP-56 35/TUBE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AM79C970AKC | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
| AM79C970AKC\\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Advanced Micro Devices 功能描述: |
| AM79C970AKC\W | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| AM79C970AKCW | 制造商:AMD 制造商全稱:Advanced Micro Devices 功能描述:PCnet-PCI II Single-Chip Full-Duplex Ethernet Controller for PCI Local Bus Product |
發布緊急采購，3分鐘左右您將得到回復。