- 您現在的位置：買賣IC網 > PDF目錄370034 > 28222-13 (Conexant Systems, Inc.) ATM Transmitter/Receiver with UTOPIA Interface PDF資料下載
參數資料
| 型號： | 28222-13 |
| 廠商： | Conexant Systems, Inc. |
| 英文描述： | ATM Transmitter/Receiver with UTOPIA Interface |
| 中文描述： | 自動柜員機發射機/接收機的UTOPIA接口 |
| 文件頁數： | 105/161頁 |
| 文件大?。?/td> | 1832K |
| 代理商： | 28222-13 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁當前第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁第136頁第137頁第138頁第139頁第140頁第141頁第142頁第143頁第144頁第145頁第146頁第147頁第148頁第149頁第150頁第151頁第152頁第153頁第154頁第155頁第156頁第157頁第158頁第159頁第160頁第161頁
CN8223
3.0 Registers
ATM Transmitter/Receiver with UTOPIA Interface
3.5 Receive Control Registers
100046C
Conexant
3-19
enabled with this bit, none of the other ports should be programmed for 53-octet
output.
3.5 Receive Control Registers
0x14
—
CELL_VAL (Cell Validation Control Register)
The CELL_VAL register is located at address 0x14. Validation checks performed by the validation process can
be individually disabled with the
“
Disable
”
control bits. These disable bits are global disables for all ports. Port
disables for payload length and payload CRC checks can also be found in CONFIG_4.
Bit
Field
Size
Name
Description
15
1
Start-of-Cell/Write
Error Output
Selects the function of the FCTRL_OUT[10] pin. When this bit is low, the output
indicates a FIFO write error. When this bit is high, the output is a start-of-cell
marker for the received cell data on the FIFO data port.
14
1
Disable Cell Receiver
Disables all cell validation and output after physical layer reception. This disable
control is internally synchronized to take effect on cell boundaries.
13
1
Enable Status Octet
Enables status output in 53-octet mode on port 3. See
Section 2.6
, for additional
information. When this bit is high, the HEC octet position in the FIFO output data is
omitted and a status word is appended to the end of the cell as octet number 53. In
53-octet cell formats, if status output is enabled with this bit, none of the other
ports should be programmed for 53-octet output.
12
1
Header Only Output
Enables a 5-octet output mode on port 3 only. See
Section 2.6
, for additional
information. Only the 4 header octets of cells addressed to port 3 and the status
octet are output to the FIFO port. In 53-octet cell formats, if status output is
11
1
Disable Payload CRC
Disables the payload CRC check. This disable controls only the output of cells to
the FIFO interface and does not control the counting of payload CRC errors. (This
applies for all ports.)
10
1
Disable Payload Len
Disables the payload length check. This disable controls only the output of cells to
the FIFO interface and does not control the counting of payload length errors. (This
applies for all ports.)
9
1
Disable HEC Check
Disables the check of the header error control octet. The CN8223 will pass cells
with HEC errors if this bit is set to 1. This bit is not functional in UTOPIA mode.
8
1
Enable HEC
Correction
Enables the HEC correction mode for single-bit header errors. If this bit is set to 0,
then no correction is performed but error detection is always performed. Error
correction must be disabled if HEC coverage is set for SMDS/802.6 mode or if
Enable HEC Coset (bit 0) in CONFIG_3 is not enabled.
7
–
6
2
Cell Output
Mode-Port 3
Number of ATM cell octets delivered to the FIFO interface.
00 - 48 Octets: Payload only mode
01 - 52 Octets: Header + Payload, no HEC
10 - 53 Octets: Header + HEC + payload
11 - 57 Octets: PLCP mode for all table entries
相關PDF資料 |
PDF描述 |
|---|---|
| 28222-14 | ATM Transmitter/Receiver with UTOPIA Interface |
| 28233-11 | ATM Transmitter/Receiver with UTOPIA Interface |
| 28C010TRPDB-12 | 150 x 32 pixel format, LED Backlight available |
| 28C010TRT1DE-15 | 1 Megabit (128K x 8-Bit) EEPROM |
| 28C010TRT1DE-20 | 1 Megabit (128K x 8-Bit) EEPROM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 28222-14 | 制造商:CONEXANT 制造商全稱:CONEXANT 功能描述:ATM Transmitter/Receiver with UTOPIA Interface |
| 282222-003 | 制造商:TE Connectivity 功能描述:81044/12-16-2 - Cable Rools/Shrink Tubing |
| 282223-003 | 制造商:TE Connectivity 功能描述:81044/12-16-3 - Cable Rools/Shrink Tubing |
| 282224-003 | 制造商:TE Connectivity 功能描述:81044/12-16-4 - Cable Rools/Shrink Tubing |
| 282224-1 | 功能描述:汽車連接器 ECONOSEAL RCPT CONT .5MM RoHS:否 制造商:Amphenol SINE Systems 產品:Contacts 系列:ATP 位置數量: 型式:Female 安裝風格: 端接類型: 觸點電鍍:Nickel |
發布緊急采購，3分鐘左右您將得到回復。