參數資料
型號: NZ48F4L0QTY
廠商: Intel Corp.
英文描述: StrataFlash Wireless Memory
中文描述: 無線的StrataFlash存儲器
文件頁數: 66/106頁
文件大?。?/td> 1272K
代理商: NZ48F4L0QTY
Intel StrataFlash Wireless Memory (L18)
April 2005
66
Intel StrataFlash Wireless Memory (L18)
Order Number: 251902, Revision: 009
Datasheet
13.0
Security Modes
The device features security modes used to protect the information stored in the flash memory
array. The following sections describe each security mode in detail.
13.1
Block Locking
Individual instant block locking is used to protect user code and/or data within the flash memory
array. All blocks power up in a locked state to protect array data from being altered during power
transitions. Any block can be locked or unlocked with no latency. Locked blocks cannot be
programmed or erased; they can only be read.
Software-controlled security is implemented using the Block Lock and Block Unlock commands.
Hardware-controlled security can be implemented using the Block Lock-Down command along
with asserting WP#. Also, V
PP
data security can be used to inhibit program and erase operations
(see
Section 11.6, “Program Protection” on page 63
and
Section 12.4, “Erase Protection” on
page 65
).
13.1.1
Lock Block
To lock a block, issue the Lock Block Setup command. The next command must be the Lock Block
command issued to the desired block’s address (see
Section 9.2, “Device Commands” on page 47
and
Figure 45, “Block Lock Operations Flowchart” on page 91
). If the Set Read Configuration
Register command is issued after the Block Lock Setup command, the device configures the RCR
instead.
Block lock and unlock operations are not affected by the voltage level on V
PP
. The block lock bits
may be modified and/or read even if V
PP
is below V
PPLK
.
13.1.2
Unlock Block
The Unlock Block command is used to unlock blocks (see
Section 9.2, “Device Commands” on
page 47
). Unlocked blocks can be read, programmed, and erased. Unlocked blocks return to a
locked state when the device is reset or powered down. If a block is in a lock-down state, WP#
must be deasserted before it can be unlocked (see
Figure 28, “Block Locking State Diagram” on
page 67
).
13.1.3
Lock-Down Block
A locked or unlocked block can be locked-down by writing the Lock-Down Block command
sequence (see
Section 9.2, “Device Commands” on page 47
). Blocks in a lock-down state cannot
be programmed or erased; they can only be read. However, unlike locked blocks, their locked state
cannot be changed by software commands alone. A locked-down block can only be unlocked by
issuing the Unlock Block command with WP# deasserted. To return an unlocked block to locked-
down state, a Lock-Down command must be issued prior to changing WP# to V
IL
. Locked-down
blocks revert to the locked state upon reset or power up the device (see
Figure 28, “Block Locking
State Diagram” on page 67
).
相關PDF資料
PDF描述
NZ48F4L0QTZ StrataFlash Wireless Memory
NZD560A NPN Low Saturation Transistor
NZF220DFT1G EMI Filter with ESD Protection
NZF220TT1 EMI Filter with ESD Protection(帶ESD保護功能的EMI濾波器)
NZL5V1AXV3T1 Zener Voltage Regulators (SC-89 Dual Common Anode Zeners for ESD Protection)
相關代理商/技術參數
參數描述
NZ48F4L0QTZ 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:StrataFlash Wireless Memory
NZ600N18K 制造商:n/a 功能描述:Power Module
NZ9F10VST5G 功能描述:穩壓二極管 ZENER DIODE RoHS:否 制造商:Vishay Semiconductors 齊納電壓:12 V 電壓容差:5 % 電壓溫度系數:0.075 % / K 齊納電流: 功率耗散:3 W 最大反向漏泄電流:3 uA 最大齊納阻抗:7 Ohms 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AC 封裝:Reel
NZ9F10VT5G 功能描述:穩壓二極管 ZENER DIODE RoHS:否 制造商:Vishay Semiconductors 齊納電壓:12 V 電壓容差:5 % 電壓溫度系數:0.075 % / K 齊納電流: 功率耗散:3 W 最大反向漏泄電流:3 uA 最大齊納阻抗:7 Ohms 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AC 封裝:Reel
NZ9F11VST5G 功能描述:穩壓二極管 ZENER DIODE RoHS:否 制造商:Vishay Semiconductors 齊納電壓:12 V 電壓容差:5 % 電壓溫度系數:0.075 % / K 齊納電流: 功率耗散:3 W 最大反向漏泄電流:3 uA 最大齊納阻抗:7 Ohms 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AC 封裝:Reel