參數資料
型號： NZ48F4L0QTY
廠商： Intel Corp.
英文描述： StrataFlash Wireless Memory
中文描述： 無線的StrataFlash存儲器
文件頁數： 50/106頁
文件大?。?/td> 1272K
代理商： NZ48F4L0QTY
Intel StrataFlash Wireless Memory (L18)
April 2005
50
Intel StrataFlash Wireless Memory (L18)
Order Number: 251902, Revision: 009
Datasheet
10.0
Read Operations
The device supports two read modes: asynchronous page mode and synchronous burst mode.
Asynchronous page mode is the default read mode after device power-up or a reset. The Read
Configuration Register must be configured to enable synchronous burst reads of the flash memory
array (see
Section 10.3, “Read Configuration Register (RCR)” on page 51
).
Each partition of the device can be in any of four read states: Read Array, Read Identifier, Read
Status or Read Query. Upon power-up, or after a reset, all partitions of the device default to Read
Array. To change a partition’s read state, the appropriate read command must be written to the
device (see
Section 9.2, “Device Commands” on page 47
). See
Section 15.0, “Special Read States”
on page 75
for details regarding Read Status, Read ID, and CFI Query modes.
The following sections describe read-mode operations in detail.
10.1
Asynchronous Page-Mode Read
Following a device power-up or reset, asynchronous page mode is the default read mode and all
partitions are set to Read Array. However, to perform array reads after any other device operation
(e.g. write operation), the Read Array command must be issued in order to read from the flash
memory array.
Note:
Asynchronous page-mode reads can only be performed when Read Configuration Register bit
RCR[15] is set (see
Section 10.3, “Read Configuration Register (RCR)” on page 51
).
To perform an asynchronous page-mode read, an address is driven onto A[MAX:0], and CE# and
ADV# are asserted. WE# and RST# must already have been deasserted. WAIT is deasserted during
asynchronous page mode. ADV# can be driven high to latch the address, or it must be held low
throughout the read cycle. CLK is not used for asynchronous page-mode reads, and is ignored. If
only asynchronous reads are to be performed, CLK should be tied to a valid V
IH
level, WAIT
signal can be floated and ADV# must be tied to ground. Array data is driven onto DQ[15:0] after
an initial access time t
AVQV
delay. (see
Section 7.0, “AC Characteristics” on page 28
).
In asynchronous page mode, four data words are “sensed” simultaneously from the flash memory
array and loaded into an internal page buffer. The buffer word corresponding to the initial address
on A[MAX:0] is driven onto DQ[15:0] after the initial access delay. Address bits A[MAX:2] select
the 4-word page. Address bits A[1:0] determine which word of the 4-word page is output from the
data buffer at any given time.
10.2
Synchronous Burst-Mode Read
Section 10.3, “Read Configuration Register (RCR)” on page 51
continuous-wordsTo perform a
synchronous burst- read, an initial address is driven onto A[MAX:0], and CE# and ADV# are
asserted. WE# and RST# must already have been deasserted. ADV# is asserted, and then
deasserted to latch the address. Alternately, ADV# can remain asserted throughout the burst access,
in which case the address is latched on the next valid CLK edge while ADV# is asserted.
相關PDF資料
PDF描述
NZ48F4L0QTZ StrataFlash Wireless Memory
NZD560A NPN Low Saturation Transistor
NZF220DFT1G EMI Filter with ESD Protection
NZF220TT1 EMI Filter with ESD Protection(帶ESD保護功能的EMI濾波器)
NZL5V1AXV3T1 Zener Voltage Regulators (SC-89 Dual Common Anode Zeners for ESD Protection)
相關代理商/技術參數
參數描述
NZ48F4L0QTZ 制造商:INTEL 制造商全稱:Intel Corporation 功能描述:StrataFlash Wireless Memory
NZ600N18K 制造商:n/a 功能描述:Power Module
NZ9F10VST5G 功能描述:穩壓二極管 ZENER DIODE RoHS:否 制造商:Vishay Semiconductors 齊納電壓:12 V 電壓容差:5 % 電壓溫度系數:0.075 % / K 齊納電流: 功率耗散:3 W 最大反向漏泄電流:3 uA 最大齊納阻抗:7 Ohms 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AC 封裝:Reel
NZ9F10VT5G 功能描述:穩壓二極管 ZENER DIODE RoHS:否 制造商:Vishay Semiconductors 齊納電壓:12 V 電壓容差:5 % 電壓溫度系數:0.075 % / K 齊納電流: 功率耗散:3 W 最大反向漏泄電流:3 uA 最大齊納阻抗:7 Ohms 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AC 封裝:Reel
NZ9F11VST5G 功能描述:穩壓二極管 ZENER DIODE RoHS:否 制造商:Vishay Semiconductors 齊納電壓:12 V 電壓容差:5 % 電壓溫度系數:0.075 % / K 齊納電流: 功率耗散:3 W 最大反向漏泄電流:3 uA 最大齊納阻抗:7 Ohms 最大工作溫度:+ 150 C 安裝風格:SMD/SMT 封裝 / 箱體:DO-214AC 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*