- 您現在的位置：買賣IC網 > PDF目錄358741 > LAN83C175 (STANDARD MICROSYSTEMS CORP) Ethernet CARDBUS Integrated Controller With Modem Support PDF資料下載
參數資料
| 型號： | LAN83C175 |
| 廠商： | STANDARD MICROSYSTEMS CORP |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | Ethernet CARDBUS Integrated Controller With Modem Support |
| 中文描述： | 1 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PQFP208 |
| 封裝： | 28 X 28 MM, 1.40 MM HEIGHT, TQFP-208 |
| 文件頁數： | 35/92頁 |
| 文件大?。?/td> | 299K |
| 代理商： | LAN83C175 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁當前第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁
35
CONFIGURATION
The LAN83C175 is automatically configured by
the host system power-up software before the
machine is booted to an operating system.
Configuration is performed through the CardBus
configuration space. The LAN83C175 indicates
its requirements and the power-up software
allocates the appropriate resources. Note that
there is a separate configuration space for the
ethernet function and the modem function.
The LAN83C175 has the following requirements
for both the ethernet and modem functions:
A)
256 byte I/O space (may be mapped
anywhere in 32-bit I/O address space)
B)
4 Kbyte memory space (may be mapped
anywhere in 32-bit host memory space -
may be disabled on any host with I/O
space).
C)
64 Kbyte expansion ROM space (may be
mapped anywhere in 32-bit host memory
space - will be disabled after boot
sequence).
D)
Interrupt hardwired to CardBus nINTA line.
Because resources are relocatable, device
drivers must read the configuration registers
after boot time to determine where the device is
mapped.
Mapping of ROM and Control Functions
The LAN83C175 control registers are mapped
into both host I/O and memory space (to
accommodate host systems with no I/O space).
In machines with I/O space, mapping into
memory address space may optionally be
disabled by a bit in EEPROM. Any change in
the memory map enable bit will not take effect
until the system is reset (hard reset). The I/O
base address for the control registers will be
stored in the I/O Base Address Register (10h in
the configuration space). The memory base
address for the control registers will be stored in
the Memory Base Address Register (14h in the
configuration space). The I/O space is 256 bytes
long and is always naturally aligned. When
mapped into memory, the control registers
consume 4 Kbytes, even though only the first
256 bytes are used. They are always aligned to
a 4 Kbyte boundary. Access to the control
registers is enabled by the memory space and
I/O space enable bits in the CardBus Command
Register (04h in the configuration space). Both
memory space and I/O space will be disabled
after reset. All control registers are dword
accessible only.
The expansion ROM is accessible when the
"address decode enable" bit in the ROM base
address register (30h in the configuration space)
is set and the memory space enable bit is set.
The ROM code is not executable in place. It
must be copied into system RAM and executed
from RAM (as per CardBus specification).
LAN83C175 control functions will not be
accessible through memory address space
while the ROM address decode enable bit is
set. Note that this ROM also contains the CIS
information for both the ethernet and modem
function.
When the expansion ROM is read, the
LAN83C175 will always return all four bytes in
the dword being accessed, regardless of which
byte enables are active.
The LAN83C175 will write to the flash ROM on a
byte basis, as decoded by the byte enables.
相關PDF資料 |
PDF描述 |
|---|---|
| LAN83C180 | 10/100 FAST ETHERNET PHY TRANSCEIVER |
| LAN83C185 | HIGH PERFORMANCE SINGLE CHIP LOW POWER 10/100 ETHERNET PHYSICAL LAYER TRANSCEIVER |
| LAN83C183-JD | FAST ETHERNET PHYSICAL LAYER DEVICE |
| LAN83C180TQFP | 10/100 FAST ETHERNET PHY TRANSCEIVER |
| LAN83C183 | FAST ETHERNET PHYSICAL LAYER DEVICE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LAN83C175TQFP | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:SMC Corporation of America 功能描述:83C175TQFP 制造商:SMSC 功能描述: |
| LAN83C175TQFP WAF | 制造商:SMSC 功能描述: |
| LAN83C180 | 制造商:SMSC 制造商全稱:SMSC 功能描述:10/100 FAST ETHERNET PHY TRANSCEIVER |
| LAN83C180_01 | 制造商:SMSC 制造商全稱:SMSC 功能描述:10/100 Fast Ethernet PHY Transceiver |
| LAN83C180TQFP | 制造商:SMSC 制造商全稱:SMSC 功能描述:10/100 Fast Ethernet PHY Transceiver |
發布緊急采購，3分鐘左右您將得到回復。