參數資料
型號: LAN83C175
廠商: STANDARD MICROSYSTEMS CORP
元件分類: 微控制器/微處理器
英文描述: Ethernet CARDBUS Integrated Controller With Modem Support
中文描述: 1 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PQFP208
封裝: 28 X 28 MM, 1.40 MM HEIGHT, TQFP-208
文件頁數: 32/92頁
文件大?。?/td> 299K
代理商: LAN83C175
32
Timers and Counters/Slot Timer
During transmit, the slot timer starts counting
once the receiver recognizes that a carrier is
present at the start of a returning preamble.
When backing off, the slot timer starts with the
end of transmit enable (TX_EN) for the collided
frame and is not reset by any other incoming
frames. The slot timer is programmable by the
transmit control register. The default slot time is
512 bit times.
Backoff Timer
After a transmission is terminated because of a
collision, a retransmission is attempted. The
backoff time is determined by the truncated
binary exponential backoff alogrithm. This
algorithm is:
draw random integer r: 0<=r<2**k
Where k equals the number of retries already on
this transmission. The value k is initialized to 0.
The required backoff time is 'r' number of slot
times. After the backoff time has been
completed, normal transmission deferral begins.
The backoff timer is a 12 bit counter that is
initialized to a random number when an
attempted transmission results in a collision.
The counter decrements once per slot time until
it reaches zero. The transmit protocol FSM
utilizes this timer to insert a variable amount of
delay ahead of its attempt to retransmit the
frame.
Collision Counter
Prior to the first attempt at each frame
transmission, the collision counter is initialized
to 0. Each attempted transmission of the frame
resulting in a collision causes the collision
counter
to increment. If the maximum number of
collisions (16) is reached before a successful
attempt to transmit the frame, the frame
transmission is aborted. An interrupt is
generated for an aborted frame indicating
transmission complete, and the collision count
value in the transmit status register is 16.
Heartbeat Detection
When the transmitter is configured in serial
mode, after each transmission, the transmit
logic opens a window 3.6
μ
sec long during
which it looks for a pulse on the COL pin. This
pulse is normally generated by the MAU and is
received through the MII interface. If the pulse
is received, the CDH status bit of the transmit
status register is cleared. If no pulse is received,
the CDH bit is set.
MII MANAGEMENT INTERFACE
The
specification for the MII Serial Management
Interface.
LAN83C175
supports
the
802.3
EEPROM INTERFACE
The LAN83C175 has a 8-bit parallel interface to
an external EEPROM. The parallel EEPROM
contains the LAN Address for the adapter and a
several bytes of configuration information. The
LAN address and configuration information is
automatically recalled from the first eight words
(each word is 16 bits) of the serial EEPROM
after reset. Access to the LAN83C175 is
disabled during the initial EEPROM recall. Any
attempted access results in a CardBus target
retry. The initial recall may be bypassed
through a test "jumper".
相關PDF資料
PDF描述
LAN83C180 10/100 FAST ETHERNET PHY TRANSCEIVER
LAN83C185 HIGH PERFORMANCE SINGLE CHIP LOW POWER 10/100 ETHERNET PHYSICAL LAYER TRANSCEIVER
LAN83C183-JD FAST ETHERNET PHYSICAL LAYER DEVICE
LAN83C180TQFP 10/100 FAST ETHERNET PHY TRANSCEIVER
LAN83C183 FAST ETHERNET PHYSICAL LAYER DEVICE
相關代理商/技術參數
參數描述
LAN83C175TQFP 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:SMC Corporation of America 功能描述:83C175TQFP 制造商:SMSC 功能描述:
LAN83C175TQFP WAF 制造商:SMSC 功能描述:
LAN83C180 制造商:SMSC 制造商全稱:SMSC 功能描述:10/100 FAST ETHERNET PHY TRANSCEIVER
LAN83C180_01 制造商:SMSC 制造商全稱:SMSC 功能描述:10/100 Fast Ethernet PHY Transceiver
LAN83C180TQFP 制造商:SMSC 制造商全稱:SMSC 功能描述:10/100 Fast Ethernet PHY Transceiver